New Carboxylate Anionic Sm-MOF: Synthesis, Structure and Effect of the Isomorphic Substitution of Sm3+ with Gd3+ and Tb3+ Ions on the Luminescent Properties

Smartphone-Assisted Fluorescence Determination of Inorganic Phosphorus Using a Samarium Metal-Organic Framework

Inorganic phosphori are widely used in food, whose quantitative detection method is of significance. This work presents a Sm-DDB (H4DDB = 1,3-di(3',5'-dicarboxylphenyl)benzene), which acts as a ratiometric fluorescence sensor to monitor PO43-, H2PO4-, and (PO3)66- with high sensitivity. The determination factors of pH, MOF dosage, and fluorescence response time are optimized as 7.35, 1 mg, and 2 min, respectively. The sensitivity tests show the linear fitting equations of I465/I598 = 0.00363·CP + 1.49183 (I465 and I598: the emission intensities at 465 and 598 nm; Cp = inorganic phosphorus concentration) for PO43-, I465/I598 = 0.00272·CP + 1.55944 for H2PO4-, and I465/I598 = 0.00957·CP + 1.55122 for (PO3)66- with LODs being 1.00 μM for PO43-, 1.33 μM for H2PO4-, and 0.38 μM for (PO3)66-. The detection method was applied in frozen shrimp, marine fish, and bacon, whose fluorescence recoveries of around 100% demonstrate its reliability. The analytical results are close to those determined by the phosphomolybdenum blue method. The Sm-DDB test paper shows an obvious emission color change, whose blue/red (B/R) values can be recognized by a smartphone APP. This work provides a smartphone-assisted visualization detection method for PO43-, H2PO4-, and (PO3)66-.

Solvatomorphic phase transitions and tunable luminescence emission in lanthanide metal-organic frameworks

Four new metal-organic frameworks with the formulae [Sm2(phen)2(NO3)2(chdc)2]·2solv, where solv = N,N-dimethylformamide (DMF; 1), N,N-dimethylacetamide (DMA; 2), N,N-diethylformamide (DEF; 3), N-formylpiperidine (NFP; 4), phen = 1,10-phenanthroline and chdc2- = trans-1,4-cyclohexanedicarboxylate were synthesized and structurally characterized. These compounds are based on similar binuclear samarium(III)-carboxylate blocks, bound by flexible chdc linkers into layered sql-type coordination networks. The amide solvents drive different intralayer block orientations between 1 and 2-4 and different layer-to-layer packings in all the described compounds. A pronounced dependence of the emission color upon the excitation wavelength variation was determined for 1-4, while the relative impacts of Sm3+ and phen emission on overall luminescence were found to depend strongly on these packings, and their reasonable correlation to the distances between the closest π-π-stacked phen moieties in the structures was revealed. Phase transitions between compounds 1-4 were studied by means of powder X-ray diffraction. Additionally, bimetallic near-white luminophores were obtained for phases 3 and 4 by doping their synthetic systems with a minor (∼5%) Tb3+ additive. In general, this study shows a possibility of tuning the luminescence properties of porous metal-organic frameworks by minor structural differences induced by solvent-driven dynamics with no apparent quenching or other direct impact on the optical properties of the included solvent.

Host-guest charge transfer for scalable single crystal epitaxy of a metal-organic framework

Methods to grow large crystals provide the foundation for material science and technology. Here we demonstrate single crystal homoepitaxy of a metal-organic framework (MOF) built of zinc, acetate and terephthalate ions, that encapsulate arrays of octahedral zinc dimethyl sulfoxide (DMSO) complex cations within its one-dimensional (1D) channels. The three-dimensional framework is built of two-dimensional Zn-terephthalate square lattices interconnected by anionic acetate pillars through diatomic zinc nodes. The charge of the anionic framework is neutralized by the 1D arrays of Zn ( DMSO ) 6 2 + cations that fill every second 1D channel of the framework. It is demonstrated that the repeatable and scalable epitaxy allows square cuboids of this charge-transfer MOF to grow stepwise to sizes in the centimeter range. The continuous growth with no size limits can be attributed to the ionic nature of the anionic framework with cationic 1D molecular fillers. These findings pave the way for epitaxial growth of bulk crystals of MOFs.

Tuning the Cerium-Based Metal-Organic Framework Formation by Template Effect and Precursor Selection

The novel metal-organic framework [(CH3)2NH2]2[Ce2(bdc)4(DMF)2]·2H2O (Ce-MOF, H2bdc-terephthalic acid, DMF-N,N-dimethylformamide) was synthesized by a simple solvothermal method. Ce-MOF has 3D connectivity of bcu type with a dinuclear fragment connected with eight neighbors, while three types of guest species are residing in its pores: water, DMF, and dimethylammonium cations. Dimethylamine was demonstrated to have a decisive templating effect on the formation of Ce-MOF, as its deliberate addition to the solvothermal reaction allows the reproducible synthesis of the new framework. Otherwise, the previously reported MOF Ce5(bdc)7.5(DMF)4 (Ce5) or its composite with nano-CeO2 (CeO2@Ce5) was obtained. Various Ce carboxylate precursors and synthetic conditions were explored to evidence the major stability of Ce-MOF and Ce5 within the Ce carboxylate-H2bdc-DMF system. The choice of precursor impacts the surface area of Ce-MOF and thus its reactivity in an oxidative atmosphere. The in situ PXRD and TG-DTA-MS study of Ce-MOF in a nonoxidative atmosphere demonstrates that it eliminates H2O and DMF along with (CH3)2NH guest species in two distinct stages at 70 and 250 °C, respectively, yielding [Ce2(bdc)3(H2bdc)]. The H2bdc molecule is removed at 350 °C with the formation of novel modification of Ce2(bdc)3, which is stable at least up to 450 °C. According to the total X-ray scattering study with pair distribution function analysis, the most pronounced local structure transformation occurs upon departure of DMF and (CH3)2NH guest species, which is in line with the in situ PXRD experiment. In an oxidative atmosphere, Ce-MOF undergoes combustion to CeO2 at a temperature as low as 390 °C. MOF-derived CeO2 from Ce-MOF, Ce5, and CeO2@Ce5 exhibits catalytic activity in the CO oxidation reaction.

Brightly Luminescent (TbxLu1-x)2bdc3·nH2O MOFs: Effect of Synthesis Conditions on Structure and Luminescent Properties

Luminescent, heterometallic terbium(III)-lutetium(III) terephthalate metal-organic frameworks (MOFs) were synthesized via direct reaction between aqueous solutions of disodium terephthalate and nitrates of corresponding lanthanides by using two methods: synthesis from diluted and concentrated solutions. For (Tb_xLu_1-x)₂bdc₃·nH₂O MOFs (bdc = 1,4-benzenedicarboxylate) containing more than 30 at. % of Tb³⁺, only one crystalline phase was formed: Ln₂bdc₃·4H₂O. At lower Tb³⁺ concentrations, MOFs crystallized as the mixture of Ln₂bdc₃·4H₂O and Ln₂bdc₃·10H₂O (diluted solutions) or Ln₂bdc₃ (concentrated solutions). All synthesized samples that contained Tb³⁺ ions demonstrated bright green luminescence upon excitation into the ¹ππ* excited state of terephthalate ions. The photoluminescence quantum yields (PLQY) of the compounds corresponding to the Ln₂bdc₃ crystalline phase were significantly larger than for Ln₂bdc₃·4H₂O and Ln₂bdc₃·10H₂O phases due to absence of quenching from water molecules possessing high-energy O-H vibrational modes. One of the synthesized materials, namely, (Tb_0.1Lu_0.9)₂bdc₃·1.4H₂O, had one of the highest PLQY among Tb-based MOFs, 95%.

Samarium-Based Turn-Off Fluorescence Sensor for Sensitive and Selective Detection of Quinolinic Acid in Human Urine and Serum

Quinolinic acid (QA) is an index for some diseases, whose detection is of importance. This work presents a samarium metal-organic framework (Sm-MOF) containing 5-sulfoisophthalate ligand (SIP^3-). The fluorescence of Sm-MOF integrates the emission at 339 nm from the SIP^3- ligand and four characteristic ⁴G_5/2 → ⁴H_j (j = 5/2, 7/2, 9/2, and 11/2) transitions at 559, 596, 642, and 701 nm from Sm(III). Sm-MOF as a turn-off fluorescence sensor to QA exhibits high sensitivity, selectivity, and durability. The fluorescence quenching response to QA shows a linear relationship of I₀/I = 0.00496·C_QA + 1.12474 in the QA concentration of 0-500 μM and a limit of detection calculated as 4.11 μM. Sm-MOF shows the structural and fluorescent stabilities in five quenching-recovery cycles. The recoveries of close to 100% in human urine and serum indicate high reliability. The paper-based Sm-MOF sensor displays a rough QA quantitative analysis by recognizing red values in the on-site QA detection.

Aliphatic-Bridged Early Lanthanide Metal–Organic Frameworks: Topological Polymorphism and Excitation-Dependent Luminescence

Six new three-dimensional metal–organic frameworks based on early lanthanide(III) cations and trans-1,4-cyclohexanedicarboxylic acid (H2chdc) were obtained. Their crystal structures were determined by single-crystal X-ray diffraction analysis. The structure of [La2(H2O)4(chdc)3]·2DMF·H2O (1; DMF = N,N-dimethylformamide) contains one-dimensional infinite La(III)-carboxylate chains interconnected by cyclohexane moieties to form a highly porous polymeric lattice with 30% solvent accessible volume. Compounds [Ln2(phen)2(chdc)3]·0.75DMF (2Ln; Ln3+ = Ce3+, Pr3+, Nd3+ and Sm3+; phen = 1,10-phenanthroline) are based on binuclear carboxylate building blocks, which are decorated by chelate phenanthroline ligands and interconnected by cyclohexane moieties to form more dense isostructural coordination frameworks with primitive cubic pcu topology. Compound [Nd2(phen)2(chdc)3]·2DMF·0.67H2O (3) is based on secondary building units similar to 2Ln and contains a coordination lattice isomeric to 2Ln with a rare hexagonal helical snz topology. Thermal stability and luminescent properties were investigated. For 2Sm, a strong and nonmonotonous dependence of the luminescence color on the variation of excitation wavelength was revealed, changing its emission from pinkish red at λex = 340 nm to white at λex = 400 nm, and then to yellow at lower excitation energies. Such nonlinear behavior was rationalized in terms of the contribution of several different luminescence mechanisms. Thus, 2Sm is a rather rare example of a highly tunable monometallic lanthanide-based luminophore with possible applications in light-emitting devices and optical data processing.

Heterometallic Europium(III)–Lutetium(III) Terephthalates as Bright Luminescent Antenna MOFs

A new series of luminescent heterometallic europium(III)–lutetium(III) terephthalate metal–organic frameworks, namely (Eu_xLu_1−x)₂bdc₃·nH₂O, was synthesized using a direct reaction in a water solution. At the Eu³⁺ concentration of 1–40 at %, the MOFs were formed as a binary mixture of the (Eu_xLu_1−x)₂bdc₃ and (Eu_xLu_1−x)₂bdc₃·4H₂O crystalline phases, where the Ln₂bdc₃·4H₂O crystalline phase was enriched by europium(III) ions. At an Eu³⁺ concentration of more than 40 at %, only one crystalline phase was formed: (Eu_xLu_1−x)₂bdc₃·4H₂O. All MOFs containing Eu³⁺ exhibited sensitization of bright Eu³⁺-centered luminescence upon the 280 nm excitation into a ¹ππ* excited state of the terephthalate ion. The fine structure of the emission spectra of Eu^{3+ 5}D₀-⁷F_J (J = 0–4) significantly depended on the Eu³⁺ concentration. The luminescence quantum yield of Eu³⁺ was significantly larger for Eu-Lu terephthalates containing a low concentration of Eu³⁺ due to the absence of Eu-Eu energy migration and the presence of the Ln₂bdc₃ crystalline phase with a significantly smaller nonradiative decay rate compared to the Ln₂bdc₃·4H₂O.