Preparation and Thermal Analysis of Blended Nanoaluminum/Fluorinated Polyether-Segmented Urethane Composites

Nanoenergetic Composites with Fluoropolymers: Transition from Powders to Structures

Over the years, nanoenergetic materials have attracted enormous research interest due to their overall better combustion characteristics compared to their micron-sized counterparts. Aluminum, boron, and their respective alloys are the most extensively studied nanoenergetic materials. The majority of the research work related to this topic is confined to the respective powders. However, for practical applications, the powders need to be consolidated into reactive structures. Processing the nanoenergetic materials with polymeric binders to prepare structured composites is a possible route for the conversion of powders to structures. Most of the binders, including the energetic ones, when mixed with nanoenergetic materials even in small quantities, adversely affects the ignitability and combustion performance of the corresponding composites. The passivating effect induced by the polymeric binder is considered unfavorable for ignitability. Fluoropolymers, with their ability to induce pre-ignition reactions with the nascent oxide shell around aluminum and boron, are recognized to sustain the ignitability of the composites. Initial research efforts have been focused on surface functionalizing approaches using fluoropolymers to activate them further for energy release, and to improve the safety and storage properties. With the combined advent of more advanced chemistry and manufacturing techniques, fluoropolymers are recently being investigated as binders to process nanoenergetic materials to reactive structures. This review focuses on the major research developments in this area that have significantly assisted in the transitioning of nanoenergetic powders to structures using fluoropolymers as binders.

On‐Chip Chemical Synthesis Using One‐Step 3D Printed Polyperfluoropolyether

Three‐dimensional (3D) printing has already shown its high relevance for the fabrication of microfluidic devices in terms of precision manufacturing cycles and a wider range of materials. 3D‐printable transparent fluoropolymers are highly sought after due to their high chemical and thermal resistance. Here, we present a simple one‐step fabrication process via stereolithography of perfluoropolyether dimethacrylate. We demonstrate successfully printed microfluidic mixers with 800 µm circular channels for chemistry‐on‐chip applications. The printed chips show chemical, mechanical, and thermal resistance up to 200 °C, as well as high optical transparency. Aqueous and organic reactions are presented to demonstrate the wide potential of perfluoropolyether dimethacrylate for chemical synthesis.