Influence of Different Light-Emitting Diode Colors on Growth and Phycobiliprotein Generation of Arthrospira platensis

Exploring Porphyridium purpureum and Porphyridium aerugineum as alternative resources for phycobiliprotein production

Microalgae not only fix carbon dioxide, but also represent a promising alternative resource for the production of proteins, lipids, and polysaccharides. This study employed two Porphyridium strains to compare their responses under different light qualities. P. purpureum up-regulated the content (up to 69.37 ± 0.92 mg/g DW) and proportion of phycoerythrin to enhance light absorption, which led to the accumulation of total soluble proteins, neutral lipids and exopolysaccharides under blue light. In contrast, P. aerugineum primarily improved the light energy utilization by increasing phycocyanin levels (up to 81.10 ± 0.60 mg/g DW), resulting in the degradation of neutral lipids and the accumulation of exopolysaccharides. Given the biomass, the highest yields of phycoerythrin (169.61 ± 2.90 mg/L) and phycocyanin (216.92 ± 1.90 mg/L) were achieved by P. purpureum and P. aerugineum cultured under white light, respectively. These findings indicate that Porphyridium can serve as a valuable resource for phycobiliprotein production, with biomolecules synthesis being tightly regulated by light quality.

Potential of a novel brine-struvite-based growth medium for sustainable biomass and phycocyanin production by Arthrospira platensis

Nutrient recovery is crucial for sustainability as it helps to recycle valuable resources, reduce environmental pollution, and promote the efficient use of natural materials in various agricultural and industrial processes. The present study investigated the impact of using brine and struvite as sustainable nutrient sources on the growth and c-phycocyanin (C-PC) production by the cyanobacterium Arthrospira platensis. Three modified growth media were compared to the standard SAG-spirul medium under yellow-white light [YLT], and blue-white light [BLT]. In the modified medium BSI, a struvite solution was utilized to replace dipotassium phosphate, while diluted brine was used to replace NaCl and de-ionized H2O. For BSII, struvite and brine were used as in BSI, with elimination of the micronutrient from the solution. In BSIII, no other nutrient sources than bicarbonate-buffer were used in addition to struvite and brine. For each medium, A. platensis was cultivated and incubated under YLT or BLT till the stationary phase. The results showed that the combinations of brine and struvite did not have any significant negative impact on the growth rates in BSIII. However, adding struvite as a phosphorus source boosted C-PC production just as effectively as YLT, with boosting biomass yield, unlike when only BLT was used. In conclusion, the brine/struvite-based media resulted in high biomass productivity with higher C-PC yields, making it an ideal growth medium for commercial sustainable C-PC production.

Therapeutic potential of Phycocyanin in gastrointestinal cancers and related disorders

Gastrointestinal cancer is the most fatal cancer worldwide. The etiology of gastrointestinal cancer has yet to be fully characterized. Alcohol consumption, obesity, tobacco, Helicobacter pylori and gastrointestinal disorders, including gastroesophageal reflux disease, gastric ulcer, colon polyps and non-alcoholic fatty liver disease are among the several risks factors for gastrointestinal cancers. Phycocyanin which is abundant in Spirulina. Phycocyanin, a member of phycobiliprotein family with intense blue color, is an anti-diabetic, neuroprotective, anti-oxidative, anti-inflammatory, and anticancer compound. Evidence exists supporting that phycocyanin has antitumor effects, exerting its pharmacological effects by targeting a variety of cellular and molecular processes, i.e., apoptosis, cell-cycle arrest, migration and Wnt/β-catenin signaling. Phycocyanin has also been applied in treatment of several gastrointestinal disorders such as, gastric ulcer, ulcerative colitis and fatty liver that is known as a risk factor for progression to cancer. Herein, we summarize various cellular and molecular pathways that are affected by phycocyanin, its efficacy upon combined drug treatment, and the potential for nanotechnology in its gastrointestinal cancer therapy.

Unveiling the Cultivation of Nostoc sp. under Controlled Laboratory Conditions

Cyanobacteria, photoautotrophic Gram-negative bacteria, play a crucial role in aquatic and terrestrial environments, contributing significantly to fundamental ecological processes and displaying potential for various biotechnological applications. It is, therefore, critical to identify viable strains for aquaculture and establish accurate culture parameters to ensure an extensive biomass supply for biotechnology purposes. This study aims to establish optimal laboratory batch culture conditions for Nostoc 136, sourced from Alga2O, Coimbra, Portugal. Preliminary investigations were conducted to identify the optimal culture parameters and to perform biomass analysis, including protein and pigment content. The highest growth was achieved with an initial inoculum concentration of 1 g.L-1, using modified BG11 supplemented with nitrogen, resulting in a Specific Growth Rate (SGR) of 0.232 ± 0.017 μ.day-1. When exposed to white, red, and blue LED light, the most favourable growth occurred under a combination of white and red LED light exhibiting an SGR of 0.142 ± 0.020 μ.day-1. The protein content was determined to be 10.80 ± 2.09%. Regarding the pigments, phycocyanin reached a concentration of 200.29 ± 30.07 µg.mL-1, phycoerythrin 148.29 ± 26.74 µg.mL-1, and allophycocyanin 10.69 ± 6.07 µg.mL-1. This study underscores the influence of light and nutrient supplementation on the growth of the Nostoc biomass.

Optimal Laboratory Cultivation Conditions of Limnospira maxima for Large-Scale Production

Cultivating Limnospira maxima, renowned for its abundant proteins and valuable pigments, faces substantial challenges rooted in the limited understanding of its optimal growth parameters, associated high costs, and constraints in the procurement of traditional nitrogen sources, particularly NaNO3. To overcome these challenges, we conducted a comprehensive 4 × 3 factorial design study. Factors considered included white, red, blue, and yellow light spectra, along with nitrogen sources NaNO3 and KNO3, as well as a nitrogen-free control, for large-scale implementation. Optimal growth, measured by Optical Density, occurred with white and yellow light combined with KNO3 as the nitrogen source. These conditions also increased dry weight and Chl-a content. Cultures with nitrogen deprivation exhibited high values for these variables, attributed to carbon accumulation in response to nitrogen scarcity. Phycocyanin, a crucial pigment for nutrition and industry, reached its highest levels in cultures exposed to white light and supplemented with KNO3, with an impressive content of 384.11 g kg-1 of dry weight. These results highlight the efficacy and cost-efficiency of using a combination of white light and KNO3 for large-scale L. maxima cultivation. This strategy offers promising opportunities to address global food security challenges and enhance the production of industrially relevant pigments.

Sunlight filtered via translucent-colored polyvinyl chloride sheets enhanced the light absorption capacity and growth of Arthrospira platensis cultivated in a pilot-scale raceway pond

In this research, the effects of filtered sunlight traveling through translucent-colored polyvinyl chloride (PVC) sheets on the photoconversion efficiency of Arthrospira platensis are investigated. Filtered sunlight improves the phycobilisome's capacity to completely absorb and transport it to intracellular photosystems. Findings indicated that filtered sunlight via orange-colored PVC sheet increased biomass dry weight by 21% (2.80 g/L), while under blue-colored PVC sheet decreased by 32% (1.49 g/L), when compared with translucent-colored (control) PVC sheet (2.19 g/L) after 120 h of culture. The meteorological conditions during the 1st week of cultivation reported higher light flux than the subsequent weeks. Furthermore, sunlight filtered through orange PVC sheet enhanced protein, allophycocyanin, phycocyanin, chlorophyll-a and carotenoids synthesis by 13%, 15%, 13%, 22%, and 27%, respectively. This practical and inexpensive solar radiation filtration system supports large-scale production of tailored bioactive compounds from microalgae with high growth rate.

Biotechnological response curve of the cyanobacterium Spirulina subsalsa to light energy gradient

BACKGROUND

Microalgae represent a suitable and eco-sustainable resource for human needs thanks to their fast growth ability, together with the great diversity in species and intracellular secondary bioactive metabolites. These high-added-value compounds are of great interest for human health or animal feed. The intracellular content of these valuable compound families is tightly associated with the microalgal biological state and responds to environmental cues, e.g., light. Our study develops a Biotechnological response curve strategy exploring the bioactive metabolites synthesis in the marine cyanobacterium Spirulina subsalsa over a light energy gradient. The Relative Light energy index generated in our study integrates the red, green and blue photon flux density with their relative photon energy. The Biotechnological response curve combined biochemical analysis of the macromolecular composition (total protein, lipid, and carbohydrate content), total sterols, polyphenols and flavonoids, carotenoids, phenolic compounds, vitamins (A, B1, B2, B6, B9, B12, C, D2, D3, E, H, and K1), phycobiliproteins, together with the antioxidant activity of the biomass as well as the growth ability and photosynthesis.

RESULTS

Results demonstrated that light energy significantly modulate the biochemical status of the microalga Spirulina subsalsa revealing the relevance of the light energy index to explain the light-induced biological variability. The sharp decrease of the photosynthetic rate at high light energy was accompanied with an increase of the antioxidant network response, such as carotenoids, total polyphenols, and the antioxidant capacity. Conversely, low light energy favorized the intracellular content of lipids and vitamins (B2, B6, B9, D3, K1, A, C, H, and B12) compared to high light energy.

CONCLUSIONS

Results of the Biotechnological response curves were discussed in their functional and physiological relevance as well as for the essence of their potential biotechnological applications. This study emphasized the light energy as a relevant tool to explain the biological responses of microalgae towards light climate variability, and, therefore, to design metabolic manipulation of microalgae.

Response surface optimization of light conditions for organic matter accumulation in two different shapes of Arthrospira platensis

Arthrospira platensis has attracted wide attention as a cyanobacteria with high nutritional value. In this research, the response surface method was used to study the effects of light cycle, light intensity and red-blue LED conditions on the growth and organic matter accumulation in spiral shaped strain A. platensis OUC623 and linear shaped strain A. platensis OUC793. The light conditions suitable for A. platensis OUC623 were as follows: growth (light time 12.01 h, light intensity 35.64 μmol/m2s, LED red: blue = 6.38:1); chlorophyll a (light time 12.75 h, light intensity 31.06 μmol/m2s, red: blue = 6.25:1); carotenoid (light time 13.12 h, light intensity 32.25 μmol/m2s, red: blue = 5.79:1); polysaccharide (light time 16.00 h, light intensity 31.32 μmol/m2s, blue: red = 6.24:1); protein (light time 12.18 h, light intensity 6.12 μmol/m2s, blue: red = 7.95:1); phycocyanin (light time12.00 h, light intensity 5.00 μmol/m2s, blue: red = 8.00:1). The light conditions suitable for A. platensis OUC793 were as follows: growth (light time 13.52 h, light intensity 40.22 μmol/m2s, red: blue = 5.98:1); chlorophyll a (light time 14.22 h, light intensity 44.96 μmol/m2s, red: blue = 5.94:1); carotenoid (light time 14.13 h, light intensity 44.50 μmol/m2s, red: blue = 6.02:1); polysaccharide (light time 16.00 h, light intensity 31.85 μmol/m2s, blue: red = 6.08:1); protein (light time12.00 h, light intensity 5.00 μmol/m2s, blue: red = 8.00:1); phycocyanin (light time12.01 h, light intensity 5.01 μmol/m2s, blue: red = 8.00:1). Under the theoretical optimal light conditions, compared with white LED, the growth rate, chlorophyll a, carotenoid, phycocyanin, protein and polysaccharide contents in strain 623 increased by 91.67%, 114.70%, 85.05%, 563.54%, 386.14%, 201.18%, and in strain 793 increased by 75.00%, 150.94%, 113.43%, 427.09%, 1284.71%, 312.38%, respectively. The two strains showed different advantages. Growth rate, chlorophyll a, polysaccharide, protein and phycocyanin content of strain 623 were higher than those of strain 793, while carotenoid was higher in strain 793. After optimization, both strains could reach a good growth state, and the growth rate and organic matter content were close. And then a 20 L photobioreactor was used to expand the culture of the two strains, validating the theoretical optimal light conditions of response surface method. This study laid the foundation for the establishment of optical conditions for organic matter accumulation in two different strains of A. platensis, which provided more options for meeting the industrialization needs of A. platensis.

Lipophilic and Hydrophilic Compounds from Arthrospira platensis and Its Effects on Tissue and Blood Cells-An Overview

The cyanobacterium Arthrospira platensis (Spirulina platensis) is a natural source of considerable amounts of ingredients that are relevant for nutra- and pharmaceutical uses. Different hydrophilic and hydrophobic substances can be obtained by extraction from the biomass. The respective extraction techniques determine the composition of substances in the extract and thus its biological activity. In this short review, we provide an overview of the hydrophilic compounds (phenols, phycobiliproteins, polysaccharides, and vitamins) and lipophilic ingredients (chlorophylls, vitamins, fatty acids, and glycolipids) of Arthrospira platensis. The principal influences of these substances on blood and tissue cells are briefly summarized.