Temperature Dependence of the Resonant Magnetoelectric Effect in Layered Heterostructures

Magnetoelectric Effect in Amorphous Ferromagnetic FeCoSiB/Langatate Monolithic Heterostructure for Magnetic Field Sensing

This paper investigates the possibilities of creating magnetic field sensors using the direct magnetoelectric (ME) effect in a monolithic heterostructure of amorphous ferromagnetic material/langatate. Layers of 1.5 μm-thick FeCoSiB amorphous ferromagnetic material were deposited on the surface of the langatate single crystal using magnetron sputtering. At the resonance frequency of the structure, 107 kHz, the ME coefficient of linear conversion of 76.6 V/(Oe∙cm) was obtained. Furthermore, the nonlinear ME effect of voltage harmonic generation was observed with an increasing excitation magnetic field. The efficiency of generating the second and third harmonics was about 6.3 V/(Oe²∙cm) and 1.8 V/(Oe³∙cm), respectively. A hysteresis dependence of ME voltage on a permanent magnetic field was observed due to the presence of α-Fe iron crystalline phases in the magnetic layer. At the resonance frequency, the monolithic heterostructure had a sensitivity to the AC magnetic field of 4.6 V/Oe, a minimum detectable magnetic field of ~70 pT, and a low level of magnetic noise of 0.36 pT/Hz^1/2, which allows it to be used in ME magnetic field sensors.

Review of Magnetoelectric Sensors

Multiferroic magnetoelectric (ME) materials with the capability of coupling magnetization and electric polarization have been providing diverse routes towards functional devices and thus attracting ever-increasing attention. The typical device applications include sensors, energy harvesters, magnetoelectric random access memories, tunable microwave devices and ME antennas etc. Among those application scenarios, ME sensors are specifically focused in this review article. We begin with an introduction of materials development and then recent advances in ME sensors are overviewed. Engineering applications of ME sensors are followed and typical scenarios are presented. Finally, several remaining challenges and future directions from the perspective of sensor designs and real applications are included.

Magnetoelectric Vortex Magnetic Field Sensors Based on the Metglas/PZT Laminates

This paper describes the route, from simulations toward experiments, for optimizing the magnetoelectric (ME) geometries for vortex magnetic field sensors. The research is performed on the base of the Metglas/Piezoelectric (PZT) laminates in both open and closed magnetic circuit (OMC and CMC) geometries with different widths (W), lengths (L), and diameters (D). Among these geometries, the CMC laminates demonstrate advantages not only in their magnetic flux distribution, but also in their sensitivity and in their independence of the position of the vortex center. In addition, the ME voltage signal is found to be enhanced by increasing the magnetostrictive volume fraction. Optimal issues are incorporated to realize a CMC-based ME double sandwich current sensor in the ring shape with D × W = 6 mm × 1.5 mm and four layers of Metglas. At the resonant frequency of 174.4 kHz, this sensor exhibits the record sensitivity of 5.426 V/A as compared to variety of devices such as the CMC ME sensor family, fluxgate, magnetoresistive, and Hall-effect-based devices. It opens a potential to commercialize a new generation of ME-based current and (or) vortex magnetic sensors.

Experimental Investigation of the Magnetoelectric Effect in NdFeB-Driven A-Line Shape Terfenol-D/PZT-5A Structures

In this paper, the magnetoelectric (ME) effect is investigated in two kinds of A-line shape Terfenol-D/PZT-5A structures by changing the position of the NdFeB permanent magnet. The experimental results show that both ME composite structures had multiple resonance peaks. For the ME structure with acrylonitrile-butadiene-styrene (ABS) trestles, the resonance peak was different for different places of the NdFeB permanent magnet. Besides, the maximum of the ME coefficient was 4.142 V/A at 32.2 kHz when the NdFeB permanent magnet was on top of the Terfenol-D layer. Compared with the ME coefficient with a DC magnetic field, the ME coefficient with NdFeB magnets still maintained high values in the frequency domain of 65~87 kHz in the ME structure with mica trestles. Through Fourier transform analysis of the transient signal, it is found that the phenomenon of multiple frequencies appeared at low field frequency but not at high field frequency. Moreover, the output ME voltages under different AC magnetic fields are shown. Changing the amplitude of AC magnetic field, the magnitude of the output voltage changed, but the resonant frequency did not change. Finally, a finite element analysis was performed to evaluate the resonant frequency and the magnetic flux distribution characteristics of the ME structure. The simulation results show that the magnetic field distribution on the surface of Terfenol-D is non-uniform due to the uneven distribution of the magnetic field around NdFeB. The resonant frequencies of ME structures can be changed by changing the location of the external permanent magnet. This study may provide a useful basis for the improvement of the ME coefficient and for the optimal design of ME devices.

Size-Dependent and Multi-Field Coupling Behavior of Layered Multiferroic Nanocomposites

The prediction of magnetoelectric (ME) coupling in nano-scaled multiferroic composites is significant for nano-devices. In this paper, we propose a nonlinear multi-field coupling model for ME effect in layered multiferroic nanocomposites based on the surface stress model, strain gradient theory and nonlinear magneto-elastic-thermal coupling constitutive relation. With this novel model, the influence of external fields on strain gradient and flexoelectricity is discussed for the first time. Meanwhile, a comprehensive investigation on the influence of size-dependent parameters and multi-field conditions on ME performance is made. The numerical results show that ME coupling is remarkably size-dependent as the thickness of the composites reduces to nanoscale. Especially, the ME coefficient is enhanced by either surface effect or flexoelectricity. The strain gradient in composites at the nano-scale is significant and influenced by the external stimuli at different levels via the change in materials’ properties. More importantly, due to the nonlinear multi-field coupling behavior of ferromagnetic materials, appropriate compressive stress and temperature may improve the value of ME coefficient and reduce the required magnetic field. This paper provides a theoretical basis to analyze and evaluate multi-field coupling characteristics of nanostructure-based ME devices.