Experimental Study on Water Recovery from Flue Gas Using Macroporous Ceramic Membrane

Experimental Investigation into Flue Gas Water and Waste Heat Recovery Using a Purge Gas Ceramic Membrane Condenser

The direct discharge of wet saturated flue gas from a coal-fired power plant boiler causes a lot of water and waste heat loss. An inorganic ceramic membrane condenser recovers water and waste heat from the flue gas, which has great significance to improve energy utilization efficiency and reduce water consumption. However, the flue gas temperature is relatively low; thus, it is difficult to effectively utilize waste heat. In this paper, it is attempted to use the boiler secondary air as the cooling medium of the ceramic membrane condenser to realize the flue gas waste heat reuse. Based on the above ideas, a purge gas ceramic membrane condenser experimental platform was built for the water and waste heat recovery from the flue gas, and the water and waste heat recovery characteristics and the purge gas outlet parameters were discussed. Simultaneously, the heat transfer resistance and water recovery power consumption are also analyzed. The experimental results show that the water and waste heat recovery characteristics are enhanced with the purge gas flow increases. Increasing the flue gas temperature will increase the water recovery rate and heat recovery power. The ceramic membrane transmission efficiency is a key factor in restricting the actual water recovery efficiency. The purge gas absorbs the water and waste heat from the flue gas, the purge gas temperature and moisture content are significantly increased, and the purge gas relative humidity is also close to saturation. The Biot number of the ceramic membrane condenser is about 3.2 × 10^-3 to 1.9 × 10^-2; thus, the ceramic membrane tube wall thermal resistance can be neglected. There is a temperature difference between the flue gas and the purge gas, and the entropy production value of the ceramic membrane condenser increases with the flue gas temperature increases by the irreversible process.

Experimental Study on a Ceramic Membrane Condenser with Air Medium for Water and Waste Heat Recovery from Flue Gas

Ceramic membrane condensers that are used for water and waste heat recovery from flue gas have the dual effects of saving water resources and improving energy efficiency. However, most ceramic membrane condensers use water as the cooling medium, which can obtain a higher water recovery flux, but the waste heat temperature is lower, which is difficult to use. This paper proposes to use the secondary boiler air as the cooling medium, build a ceramic membrane condenser with negative pressure air to recover water and waste heat from the flue gas, and analyze the transfer characteristics of flue gas water and waste heat in the membrane condenser. Based on the experimental results, it is technically feasible for the ceramic membrane condenser to use negative pressure air as the cooling medium. The flue gas temperature has the most obvious influence on the water and heat transfer characteristics. The waste heat recovery is dominated by latent heat of water vapor, accounting for 80% or above. The negative pressure air outlet temperature of the ceramic membrane condenser can reach 50.5 °C, and it is in a supersaturated state. The research content of this article provides a new idea for the water and waste heat recovery from flue gas.

Transport Membrane Condenser Heat Exchangers to Break the Water-Energy Nexus-A Critical Review

Under the notion of water-energy nexus, the unsustainable use of water in power plants has been largely accepted in silence. Moreover, the evaporated water from power plants acts as a primary nucleation source of particulate matter (PM), rendering significant air pollution and adverse health issues. With the emergence of membrane-based dehydration processes such as vapor permeation membrane, membrane condenser, and transport membrane condenser, it is now possible to capture and recycle the evaporated water. Particularly, the concept of transport membrane condensers (TMCs), also known as membrane heat exchangers, has attracted a lot of attention among the membrane community. A TMC combines the advantages of heat exchangers and membranes, and it offers a unique tool to control the transfer of both mass and energy. In this review, recent progress on TMC technology was critically assessed. The effects of TMC process parameters and membrane properties on the dehydration efficiencies were analyzed. The peculiar concept of capillary condensation and its impact on TMC performance were also discussed. The main conclusion of this review was that TMC technology, although promising, will only be competitive when the recovered water quality is high and/or the recovered energy has some energetic value (water temperature above 50 ∘C).