Effect of the Partial Replacement of Cement with Waste Granite Powder on the Properties of Fresh and Hardened Mortars for Masonry Applications

Impact of Superplasticizers on the Performance of Low-Grade Limestone-Based Cement Mixes

Low-grade limestone (LGL) is not used to produce cement clinker, but this leftover material in cement quarries increases the water demand when used as a filler in concrete production. In this study, the effect of six commercial superplasticizers on the performance of cement mixes containing 35% LGL and 2% gypsum was investigated. The optimal doses of these superplasticizers were found in a range of different water/binder (w/b) ratios by conducting several Marsh cone and mini-slump tests. The addition of a superplasticizer with a higher active solid content produced a maximum cement flow, regardless of the w/b ratios. The LGL-based mortar samples admixed with this superplasticizer obtained a maximum compressive strength of about 36 MPa at the end of 28 days. SEM and XRD results showed the formation of a new calcium-rich mineral in their microstructure. These findings highlight the impact of the type and properties of superplasticizers on the performance of concrete mixes containing LGL as a supplementary cementitious material.

Physico-Mechanical Properties and Hydration Processes of Cement Pastes Modified with Pumice, Trass and Waste Chalcedonite Powder

In this article, the physico-mechanical properties and hydration processes of cement pastes containing three additives are introduced. Cement was replaced with pumice, trass, waste chalcedonite powder at 30% by mass and a combination of pumice or trass and waste chalcedonite powder in the amounts of 15% each. The main aim of this research was to assess the properties of two- or three-component binders to save cement in these binders. Rheological properties such as consistency, yield stress, viscosity and thixotropy were determined, in addition to porosity, 7-day and 28-day flexural and compressive strength and bulk density. Additionally, the heat evolution and degree of hydration of the tested pastes were compared. The use of all additives resulted in a reduction in the consistency of the tested pastes. The highest compressive strength measured after 28 days was observed for the cement paste with a 30% content of waste chalcedonite powder, which is related to it having the best pozzolanic activity of the materials used. The results of this research have confirmed that pumice, trass and waste chalcedonite powder can be used as components of blended Portland cements.