Holographic Gratings for Slow-Neutron Optics

Enhanced microwave metrology using an optical grating in Rydberg atoms

An enhanced measurement of the microwave (MW) electric (E) field is proposed using an optical grating in Rydberg atoms. Electromagnetically induced transparency (EIT) of Rydberg atoms appears driven by a probe field and a control field. The EIT transmission spectrum is modulated by an optical grating. When a MW field drives the Rydberg transition, the central principal maximum of the grating spectrum splits. It is interesting to find that the magnitude of the sharp grating spectrum changes linearly with the MW E-field strength, which can be used to measure the MW E-field. The simulation result shows that the minimum detectable E-field strength is nearly 1/8 of that without gratings, and its measurement accuracy could be enhanced by about 60 times. Other discussion of MW metrology based on a grating spectrum is also presented.

Focusing and imaging of cold neutrons with a permanent magnetic lens

This paper reports imaging of objects with slow neutrons, specifically very cold neutrons and cold neutrons, at Institut Laue Langevin, using novel, permanent magnet (Nd₂Fe₁₄B) compound refractive lenses (MCRL) with a large 2.5 cm bore diameter. The MCRL focuses and images spin-up neutrons and defocuses spin-down neutrons via a large, radial magnetic field gradient. A single lens neutron microscope, composed of an MCRL objective lens with 2-fold magnification, was tested using very cold (slow) neutrons at 45 Å wavelength. One-to-one imaging was obtained using 16.7 Å polarized neutrons. The magnetic field gradient of the MCRL was measured by raster-scanned pencil beams on D33. Finally, a compound neutron microscope was realized using an MCRL condenser lens, which provided increased illumination of objects, and an MCRL as objective lens to produce 3.5-fold magnification.

Light- and Neutron-Optical Properties of Holographic Transmission Gratings from Polymer-Ionic Liquid Composites with Submicron Grating Spacing

We investigate the applicability of polymer-ionic liquid composites as optical elements for light, as well as for slow neutrons. The gratings are recorded using two-beam mixing and are characterized experimentally based on their diffraction properties. We produced a set of samples differing in their thickness, ranging from 10 μm–100 μm. We demonstrate that it is possible to prepare transmission gratings with a lattice constant of Λ=480 nm, resulting in thick gratings for light, as well as neutrons. The presented samples show low optical losses in the Vis-UV spectrum and exhibit refractive index modulations of about 10−3 at λ=543 nm. However, further improvements have to be made to obtain efficient neutron optical components.

A Comprehensive Study of Photorefractive Properties in Poly(ethylene glycol) Dimethacrylate- Ionic Liquid Composites

A detailed investigation of the recording, as well as the readout of transmission gratings in composites of poly(ethylene glycol) dimethacrylate (PEGDMA) and ionic liquids is presented. Gratings with a period of about 5.8 micrometers were recorded using a two-wave mixing technique with a coherent laser beam of a 355-nm wavelength. A series of samples with grating thicknesses d0=10…150 micrometers, each for two different exposure times, was prepared. The recording kinetics, as well as the post-exposure properties of the gratings were monitored by diffracting a low intensity probe beam at a wavelength of 633 nm for Bragg incidence. To obtain a complete characterization, two-beam coupling experiments were conducted to clarify the type and the strength of the recorded gratings. Finally, the diffraction efficiency was measured as a function of the readout angle at different post-exposure times. We found that, depending on the parameters, different grating types (pure phase and/or mixed) are generated, and at elevated thicknesses, strong light-induced scattering develops. The measured angular dependence of the diffraction efficiency can be fitted using a five-wave coupling theory assuming an attenuation of the gratings along the thickness. For grating thicknesses larger than 85 microns, light-induced scattering becomes increasingly important. The latter is an obstacle for recording thicker holograms, as it destroys the recording interference pattern with increasing sample depth. The obtained results are valuable in particular when considering PEGDMA-ionic liquid composites in the synthesis of advanced polymer composites for applications, such as biomaterials, conductive polymers and holographic storage materials.

Photopolymerizable nanocomposite photonic materials and their holographic applications in light and neutron optics

We present an overview of recent investigations of photopolymerizable nanocomposite photonic materials in which, thanks to their high degree of material selectivity, recorded volume gratings possess high refractive index modulation amplitude and high mechanical/thermal stability at the same time, providing versatile applications in light and neutron optics. We discuss the mechanism of grating formation in holographically exposed nanocomposite materials, based on a model of the photopolymerization-driven mutual diffusion of monomer and nanoparticles. Experimental inspection of the recorded grating's morphology by various physicochemical and optical methods is described. We then outline the holographic recording properties of volume gratings recorded in photopolymerizable nanocomposite materials consisting of inorganic/organic nanoparticles and monomers having various photopolymerization mechanisms. Finally, we show two examples of our holographic applications, holographic digital data storage and slow-neutron beam control.