Tuning the Pore Structures of Organosilica Membranes for Enhanced Desalination Performance via the Control of Calcination Temperatures

Hydrogen (H2)/Toluene (TOL) Separation via One and Two Stages of the Bis(triethoxysily)ethane (BTESE) Membranes

The separation ability of bis(triethoxysilyl)ethane (BTESE) membranes for hydrogen (H2) purification from hydrogen (H2)/toluene (TOL) gas mixtures after a methylcyclohexane (MCH) dehydrogenation process was investigated via one-stage and two-stage membrane processes. This study revealed that BTESE membranes of varied pore sizes (0.4, 0.5, and 0.7 nm) in a one-stage configuration can manage to achieve a H2 purity ~99.9%. However, the TOL concentrations fell within a wide range, ranging from 280 to 5441 ppm. A primary goal of this research was to lower the TOL concentration in the permeate stream below 200 ppm. Hence, by applying the two-stage membrane, it was demonstrated that the TOL concentration in the permeate stream could be lowered below 200 ppm.

Bis(triethoxysilyl)ethane (BTESE)-Organosilica Membranes for H2O/DMF Separation in Reverse Osmosis (RO): Evaluation and Correlation of Subnanopores via Nanopermporometry (NPP), Modified Gas Translation (mGT) and RO Performance

A 40 cm length Bis(triethoxysilyl)ethane (BTESE) membrane having different pore sizes was successfully prepared by changing the number of coating times for gas permeation (GP) and organic solvent reverse osmosis (OSRO) separation study. It was found that BTESE-6 membranes prepared through six-time coating consisted of small-sized pores in the range 0.56 to 0.64 nm estimated using modified Gas Translation (mGT) method and 0.59 to 0.67 nm estimated by nanopermporometry (NPP) method, respectively. These membranes demonstrated a high DMF rejection, RDMF > 95% with total flux, Jv total > 5 kg m-2 h-1 at operating condition feed pressure, Pf: 8 MPa; feed temperature, Tf : 50 °C; and feed flowrate, Qf : 30 mL/min; and they exhibited a high degree selectivity of He/SF6 in the range of ~ 260-3400 at a permeation temperature 200 °C. On the other hand, the larger pore sizes of the BTESE-4 membranes (pore size estimates > 0.76 nm to 1.02 nm) exhibited low DMF rejection and a low degree selectivity of He/SF6 around ~30% and 25, respectively, at the same operating condition as BTESE-6. Both GT and NPP methods can be considered as an indicator of the measurement membrane pore size. From this study, it was found that He and SF6 gases can be some of the potential predictors for water and DMF permeance. Furthermore, by comparing our OSRO membrane with other PV membranes for DMF/H2O separation, our BTESE-6 membranes still exhibited high flux in the range of 3-6 kg m-2 h-1 with a separation factor H2O/DMF in the range of 80-120.