Tracing Microalloy Precipitation in Nb-Ti HSLA Steel during Austenite Conditioning

Determination of Grain Growth Kinetics of S960MC Steel

Fine-grained high-strength low-alloyed (HSLA) steels are used for their advantageous combination of mechanical properties such as high yield strength, tensile strength, ductility, and good formability. These properties are mainly based on applied grain boundary strengthening, which as the only strengthening mechanism allows for the yield strength to increase without a decrease in ductility. Therefore, any changes in grain size lead to irreversible changes in material properties. Such changes also occur during welding in the heat-affected zone (HAZ), where there is a significant change in austenitic grain. In coarse-grain HAZ, this leads to a decrease in yield strength, ductility, toughness, and fatigue strength. The paper experimentally determines the growth kinetics of austenitic grain for fine-grained HSLA steel S960MC. As a result, the values of the activation energy required for grain growth Q and the proportional constant K₀ are determined. Knowing these values is important for numerical predictions of austenitic grain size in the HAZ. Based on these predictions, the changes in yield strength, ductility, toughness, and fatigue strength can be estimated.

Particle encapsulation techniques for atom probe tomography of precipitates in microalloyed steels

Atom probe tomography (APT) provides sub-nm resolution in the analysis of complex industrial steels. It can resolve the carbonitride precipitates in Nb-Ti microalloyed high-strength low-alloy (HSLA) steels that strongly affect material performance and illuminate the complex precipitation sequence before and during the thermo-mechanical controlled process (TMCP). However, the precipitate concentration is low in HSLA steels during austenite conditioning, especially at temperatures > 850 °C, so that the probability of detecting precipitates via APT is below 5%. Here, we demonstrate two encapsulation-based approaches that increase the precipitate concentration in the APT sample volume sufficiently to enable the analysis of sparse precipitates. The first method is based on metallographic etching and direct targeting of precipitates in the steel. A focused ion beam was used to mark precipitation sites. Encapsulation with nickel-phosphorus (Ni-P) enabled localized APT and increased the yield by a factor of 10. The second method relies on the chemical extraction of precipitates and subsequent encapsulation in a silicon oxide (SiO_x) network at a very high particle density. Analysis of tips cut from the encapsulated particles increased the yield by a factor of >15. We discuss and compare the spatial and chemical accuracy obtained in the analysis of pure Nb-, Ti- and mixed Nb-Ti carbonitrides.

Influence of Welding Parameters and Filler Material on the Mechanical Properties of HSLA Steel S960MC Welded Joints

This article provides an overview of the influence of welding parameters and filler material on changes in the heat-affected zone (HAZ) of thermo-mechanically controlled processed (TMCP) steel welded joints. The research focused on evaluating the effect of heat input and cooling rate on the width of the soft zone, which significantly affects the mechanical properties of welded joints. The negative effect of the soft zone is more pronounced as the thickness of the material decreases. Therefore, the object of this research was a 3-mm-thick sheet of S960MC steel welded by gas metal arc welding (GMAW) and metal-cored arc welding (MCAW) technology. Variable welding parameters were reflected in different heat input and cooling rate values, which led to a change in the properties of the HAZ and thus the mechanical properties of the welded joints. The changes in the HAZ were analyzed by microscopic analysis and mechanical testing. The measured results showed a significant effect of heat input on the cooling rate, which considerably affected the width of the soft zone in the HAZ and thus the overall mechanical properties of the welded joints.

Thermomechanical Processing of Steels

The combination of hot working technologies with a thermal path, under controlled conditions (i [...]