Implementation of a Single Emulsion Mask for Three-Dimensional (3D) Microstructure Fabrication of Micromixers Using the Grayscale Photolithography Technique

Micromixing within microfluidic devices: Fundamentals, design, and fabrication

As one of the hot spots in the field of microfluidic chip research, micromixers have been widely used in chemistry, biology, and medicine due to their small size, fast response time, and low reagent consumption. However, at low Reynolds numbers, the fluid motion relies mainly on the diffusive motion of molecules under laminar flow conditions. The detrimental effect of laminar flow leads to difficulties in achieving rapid and efficient mixing of fluids in microchannels. Therefore, it is necessary to enhance fluid mixing by employing some external means. In this paper, the classification and mixing principles of passive (T-type, Y-type, obstructed, serpentine, three-dimensional) and active (acoustic, electric, pressure, thermal, magnetic field) micromixers are reviewed based on the presence or absence of external forces in the micromixers, and some experiments and applications of each type of micromixer are briefly discussed. Finally, the future development trends of micromixers are summarized.

Simple Microcontact Printing Technique to Obtain Cell Patterns by Lithography Using Grayscale, Photopolymer Flexographic Mold, and PDMS

Microcontact printing using PDMS embossing tools and its variations have aroused the interest of a wide spectrum of research fields, hence the feasibility of defining micro and nanoscale patterns. In this work, we have proposed and demonstrated a novel lithography method based on grayscale patterns printed in a flexographic photopolymer mold and transferred to epoxy resin and a single PDMS stamp to obtain different microprint pattern structures. The geometry of the patterns can be modified by adjusting the layout and grayscale of the stamp patterns. The functionality of this contact printing methodology was validated by generating human induced pluripotent stem cells (hiPSC) patterns. These specific micropatterns can be very useful for achieving complex differentiation in cell lines such as hiPSC. Microfabrication through the new technique provides a promising alternative to conventional lithography for constructing complex aligned surfaces; these structures could be used as components of biological patterns or microfluidic devices.

Three-Dimensional Soft Material Micropatterning via Grayscale Photolithography for Improved Hydrophobicity of Polydimethylsiloxane (PDMS)

In this present work, we aim to improve the hydrophobicity of a polydimethylsiloxane (PDMS) surface. Various heights of 3D PDMS micropillars were fabricated via grayscale photolithography, and improved wettability was investigated. Two approaches of PDMS replication were demonstrated, both using a single master mold to obtain the micropillar arrays. The different heights of fabricated PDMS micropillars were characterized by scanning electron microscopy (SEM) and a surface profiler. The surface hydrophobicity was characterized by measuring the water contact angles. The fabrication of PDMS micropillar arrays was shown to be effective in modifying the contact angles of pure water droplets with the highest 157.3-degree water contact angle achieved by implementing a single mask grayscale lithography technique.