Q-Factor Enhancement of Coupling Bragg and Local Resonance Band Gaps in Single-Phase Phononic Crystals for TPOS MEMS Resonator

Multi-Material Radial Phononic Crystals to Improve the Quality Factor of Piezoelectric MEMS Resonators

In this paper, a multi-material radial phononic crystal (M-RPC) structure is proposed to reduce the anchor-point loss of piezoelectric micro-electro-mechanical system (MEMS) resonators and improve their quality factor. Compared with single-material phononic crystal structures, an M-RPC structure can reduce the strength damage at the anchor point of a resonator due to the etching of the substrate. The dispersion curve and frequency transmission response of the M-RPC structure were calculated by applying the finite element method, and it was shown that the M-RPC structure was more likely to produce a band-gap range with strong attenuation compared with a single-material radial phononic crystal (S-RPC) structure. Then, the effects of different metal-silicon combinations on the band gap of the M-RPC structures were studied, and we found that the largest band-gap range was produced by a Pt and Si combination, and the range was 84.1-118.3 MHz. Finally, the M-RPC structure was applied to a piezoelectric MEMS resonator. The results showed that the anchor quality factor of the M-RPC resonator was increased by 33.5 times compared with a conventional resonator, and the insertion loss was reduced by 53.6%. In addition, the loaded and unloaded quality factors of the M-RPC resonator were improved by 75.7% and 235.0%, respectively, and at the same time, there was no effect on the electromechanical coupling coefficient.

Nonconventional Tether Structure for Quality Factor Enhancement of Thin-Film-Piezoelectric-on-Si MEMS Resonator

This article presents a new design of supporting tethers through the concept of force distribution. The transmitted force applied on tethers will be distributed on the new tether design area, resulting in low acoustic energy transferred to anchor boundaries and stored energy enhancement. This technique achieves an anchor quality factor of 175,000 compared to 58,000 obtained from the conventional tether design, representing a three-fold enhancement. Furthermore, the unloaded quality factor of the proposed design improved from 23,750 to 27,442, representing a 1.2-fold improvement.

H-Shaped Radial Phononic Crystal for High-Quality Factor on Lamb Wave Resonators

In this paper, a novel H-shaped radial phononic crystal (H-RPC) structure is proposed to suppress the anchor loss of a Lamb wave resonator (LWR), which has an ultra-high frequency (UHF) and ultra-wideband gap characteristics. Compared to previous studies on phononic crystal (PC) structures aimed at suppressing anchor loss, the radial phononic crystal (RPC) structure is more suitable for suppressing the anchor loss of the LWR. By using the finite element method, through the research and analysis of the complex energy band and frequency response, it is found that the elastic wave can generate an ultra-wideband gap with a relative bandwidth of up to 80.2% in the UHF range when propagating in the H-RPC structure. Furthermore, the influence of geometric parameters on the ultra-wideband gap is analyzed. Then, the H-RPC structure is introduced into the LWR. Through the analysis of the resonant frequency, it is found that the LWR formed by the H-RPC structure can effectively reduce the vibration energy radiated by the anchor point. The anchor quality factor was increased by 505,560.4% compared with the conventional LWR. In addition, the analysis of the LWR under load shows that the LWR with the H-RPC structure can increase the load quality factor by 249.9% and reduce the insertion loss by 93.1%, while the electromechanical coupling coefficient is less affected.