Gemological Characteristics and Origin of the Zhanguohong Agate from Beipiao, Liaoning Province, China: A Combined Microscopic, X-ray Diffraction, and Raman Spectroscopic Study

Mineralogical and Geochemical Characteristics of Banded Agates from Placer Deposits: Implications for Agate Genesis

The phase composition and geochemical characteristics in banded agates with different structural sequences have been investigated in detail. The results reveal that the agate bands have a combination of a pseudo-granular silica → fibrous chalcedony → crystalline quartz (type I) sequence and a newly discovered pseudo-granular silica → crystalline quartz (type II) sequence. The banded agates mainly consist of α-quartz, moganite, and a minor amount of amorphous silica, goethite, hematite, kaolinite, illite, and carbonates. With the evolution of two structural sequences, the content of α-quartz and moganite increases and decreases, respectively. There is no moganite in crystalline quartz. The increased concentration of trace elements like Li, Na, Al, K, Ca, Ti, Mn, and Fe in different bands may correspond to the decrease in the water content in the mineral-forming fluid. The increased trace elements promote the structural transformation process of silica. With the evolution of the type I sequence, the thermal gradients between adjacent bands are 17 and 51 °C, respectively. In contrast, a significantly higher thermal gradient of 53-66 °C is exhibited when pseudo-granular silica transforms directly to crystalline quartz. It is inferred that a slightly increased thermal gradient between adjacent bands promotes the structural transformation process of the type I sequence. The sharply increasing thermal gradient between adjacent bands leads to the formation of the type II sequence from pseudo-granular silica to crystalline quartz. The formation process of different structural sequences in agate may be controlled together by trace element concentrations and thermal gradients.

Quantitative Study on Colour and Spectral Characteristics of Beihong Agate

The Beihong agate from the southern section of the Xing’an Mountains in northeastern China is a kind of cryptocrystalline agate with a yellow to orange-red colour. However, it has been less studied in previous research, and there is a lack of quantitative study on the cause of its colour. In this study, the colour of Beihong agate was quantified by a colourimeter, and the quantitative relationships between colour and spectral characteristics of Beihong agate were studied by XRF, Raman spectra, UV-VIS spectra, and a heat treatment experiment. The results show a high correlation between the lightness and the hue angle of the Beihong agate. The change of total Fe content can significantly affect the lightness and the hue of the Beihong agate. The first derivative curve can effectively distinguish the relative contents of goethite and hematite in the Beihong agate, and the position of a primary trough is related significantly to the colour of the Beihong agate.

Occurrence and Distribution of Moganite and Opal-CT in Agates from Paleocene/Eocene Tuffs, El Picado (Cuba)

Agates in Paleocene/Eocene tuffs from El Picado/Los Indios, Cuba were investigated to characterize the mineral composition of the agates and to provide data for the reconstruction of agate forming processes. The volcanic host rocks are strongly altered and fractured and contain numerous fissures and veins mineralized by quartz and chalcedony. These features indicate secondary alteration and silicification processes during tectonic activities that may have also resulted in the formation of massive agates. Local accumulation of manganese oxides/hydroxides, as well as uranium (uranyl-silicate complexes), in the agates confirm their contemporaneous supply with SiO2 and the origin of the silica-bearing solutions from the alteration processes. The mineral composition of the agates is characterized by abnormal high bulk contents of opal-CT (>6 wt%) and moganite (>16 wt%) besides alpha-quartz. The presence of these elevated amounts of “immature” silica phases emphasize that agate formation runs through several structural states of SiO2 with amorphous silica as the first solid phase. A remarkable feature of the agates is a heterogeneous distribution of moganite within the silica matrix revealed by micro-Raman mapping. The intensity ratio of the main symmetric stretching-bending vibrations (A1 modes) of alpha-quartz at 465 cm−1 and moganite at 502 cm−1, respectively, was used to depict the abundance of moganite in the silica matrix. The zoned distribution of moganite and variations in the microtexture and porosity of the agates indicate a multi-phase deposition of SiO2 under varying physico-chemical conditions and a discontinuous silica supply.

Mineralogy, Geochemistry and Genesis of Agate—A Review

Agate—a spectacular form of SiO2 and a famous gemstone—is commonly characterized as banded chalcedony. In detail, chalcedony layers in agates can be intergrown or intercalated with macrocrystalline quartz, quartzine, opal-A, opal-CT, cristobalite and/or moganite. In addition, agates often contain considerable amounts of mineral inclusions and water as both interstitial molecular H2O and silanol groups. Most agate occurrences worldwide are related to SiO2-rich (rhyolites, rhyodacites) and SiO2-poor (andesites, basalts) volcanic rocks, but can also be formed as hydrothermal vein varieties or as silica accumulation during diagenesis in sedimentary rocks. It is assumed that the supply of silica for agate formation is often associated with late- or post-volcanic alteration of the volcanic host rocks. Evidence can be found in association with typical secondary minerals such as clay minerals, zeolites or iron oxides/hydroxides, frequent pseudomorphs (e.g., after carbonates or sulfates) as well as the chemical composition of the agates. For instance, elements of the volcanic rock matrix (Al, Ca, Fe, Na, K) are enriched, but extraordinary high contents of Ge (>90 ppm), B (>40 ppm) and U (>20 ppm) have also been detected. Calculations based on fluid inclusion and oxygen isotope studies point to a range between 20 and 230 °C for agate formation temperatures. The accumulation and condensation of silicic acid result in the formation of silica sols and proposed amorphous silica as precursors for the development of the typical agate micro-structure. The process of crystallisation often starts with spherulitic growth of chalcedony continuing into chalcedony fibers. High concentrations of lattice defects (oxygen and silicon vacancies, silanol groups) detected by cathodoluminescence (CL) and electron paramagnetic resonance (EPR) spectroscopy indicate a rapid crystallisation via an amorphous silica precursor under non-equilibrium conditions. It is assumed that the formation of the typical agate microstructure is governed by processes of self-organization. The resulting differences in crystallite size, porosity, kind of silica phase and incorporated color pigments finally cause the characteristic agate banding and colors.