Solid Phase Extraction Purification of Saliva Samples for Antipsychotic Drug Quantitation

Current development of bioanalytical sample preparation techniques in pharmaceuticals

Sample preparation is considered as the bottleneck step in bioanalysis because each biological matrix has its own unique challenges and complexity. Competent sample preparation to extract the desired analytes and remove redundant components is a crucial step in each bioanalytical approach. The matrix effect is a key hurdle in bioanalytical sample preparation, which has gained extensive consideration. Novel sample preparation techniques have advantages over classical techniques in terms of accuracy, automation, ease of sample preparation, storage, and shipment and have become increasingly popular over the past decade. Our objective is to provide a broad outline of current developments in various bioanalytical sample preparation techniques in chromatographic and spectroscopic examinations. In addition, how these techniques have gained considerable attention over the past decade in bioanalytical research is mentioned with preferred examples. Modern trends in bioanalytical sample preparation techniques, including sorbent-based microextraction techniques, are primarily emphasized.

•

Bioanalytical sampling techniques are described with suitable applications in pharmaceuticals.

•

The pros and cons of each bioanalytical sampling techniques are described.

•

Relevant biological matrices are outlined.

Direct infusion nano-electrospray ionization mass spectrometry for therapeutic drug monitoring of ciprofloxacin and its metabolites in human saliva

A rapid and sensitive method based on direct infusion-nano-electrospray ionization mass spectrometry (DI-nESI-MS) has been developed for the detection and quantification of ciprofloxacin and its metabolites in human saliva. Saliva samples were collected after the oral administration of 500 mg ciprofloxacin tablets. Internal standard (IS), tamoxifen, was added to the collected samples, and then diluted with the ionization solvent, centrifuged and filtered. An aliquot of 4 μL of the filtrate was loaded into a nanospray (NS) capillary. The NS capillary was then fitted into an off-line ion source and the instrument was operated to acquire a two-minute run by applying a voltage of 1000 V (positive-ion detection mode). Quantification of ciprofloxacin relied on the ratio of its peak intensity to the IS peak intensity. The DI-nESI-MS method was validated and provided satisfactory precision with relative standard deviation ranging from 0.39 to 7.48 % and accuracy with relative error ranging from -2.12 to 9.72 %. The calibration curve showed good linearity (r²) > 0.999 over the concentration range of 10-4000 ng/mL. These results verify the effectiveness of the DI-nESI-MS method for monitoring of ciprofloxacin and its metabolites in human saliva samples.

Effects of Age, Drug Dose, and Sampling Time on Salivary Levels of Olanzapine, Quetiapine, and Their Metabolites

Although blood is the basic test material to monitor levels of antipsychotic drugs in a person’s system, saliva could serve as a more convenient test material. Therefore, the aim of this novel study was to determine the correlations between the salivary levels of olanzapine and quetiapine (and their metabolites: N-demethyl olanzapine and norquetiapine) and the patient’s sex and age, dose level, and the time of sampling. The study involved two groups of patients: 21 female patients starting treatment immediately after being admitted to the hospital and 36 male and female nursing home residents, long-time users of the studied drugs. Women had lower levels of the tested analytes than men. Quetiapine levels in the saliva of people starting the treatment showed a positive correlation with the age of the patients and a strong positive correlation with the dose level. The saliva levels of olanzapine showed a strong correlation with its metabolite in patients who had recently started treatment. Among long-time users of this drug, salivary levels differed significantly before and after administration. In conclusion, the results indicate that there is a possibility of using saliva as a material for monitoring quetiapine or olanzapine concentrations, especially in people starting treatment.

Deproteinization as a Rapid Method of Saliva Purification for the Determination of Carbamazepine and Carbamazepine-10,11 Epoxide

Saliva is a valuable diagnostic material that, in some cases, may replace blood. However, because of its different composition, its use requires the development of new, or the modification of existing, extraction procedures. Therefore, the aim of the study was to develop a method of saliva purification that would enable the determination of carbamazepine and its metabolite, carbamazepine-10,11 epoxide. When comparing two methods of sample purification (Solid Phase Extration (SPE) and deproteinization), it was found that the second method yielded more favorable results. A 1% formic acid solution in acetonitrile was used for extraction. The samples were shaken and centrifuged, and the supernatant obtained was evaporated and dissolved in a mobile phase, then chromatographically analyzed. The developed method was validated by determining its linearity in the range of 10-5000 ng/mL for both analytes. Intra- and inter-day precision did not exceed 14%. In order to check the usefulness of the method, both analytes were determined in the saliva samples from 20 patients treated with carbamazepine. The content of both analytes was detected and determined in all of the tested samples of saliva. It was found that the method developed is rapid, sensitive, reliable, and can be used to monitor the concentration of carbamazepine and metabolite in patients' saliva.

Quality by design applied to olanzapine and quetiapine LC-MS/MS bioanalysis

One major challenge in quantifying drugs in biological matrices is to manage interfering compounds. A technique such liquid chromatography coupled to mass spectrometry in tandem (LC-MS/MS) is especially suitable for this application due to its high sensitivity and selectivity in detecting low concentrations of analytes in a complex system. Due to the complexity of LC-MS/MS systems, a number of experimental parameters must be optimized to provide an adequate separation and detection of the analyte. In the present work, a design of experiments approach was developed to optimize an LC-MS/MS-based bioanalytical method to extract olanzapine (OLZ) and quetiapine (QTP) from human plasma. Three steps for the optimization process were conducted: central composite face-centered design to optimize chromatographic parameters (Step 1), ionization in mass spectrometry (Step 2) and a full 32 factorial design to optimize analyte extraction conditions (Step 3). After the optimization process, resolutions and QTP and OLZ retention time (2.3 and 4, respectively) were optimum with pH of 4.7 and 85.5% of acetonitrile for the chromatographic step. Mass spectrometry optimization step provided an increase of (±50%) in the average peak area with high signal-to-noise relationship for the analytes studied. The proposed extraction method was 70% more efficient than the initial method for all drugs analyzed.

Development and validation of solid-phase extraction coupled with a liquid chromatography-tandem mass spectrometry method for quantitation of olanzapine in saliva

Olanzapine is one of the most commonly used drugs for the treatment of schizophrenia and depression of various origins. Its levels are usually measured in the blood, but the collection of this diagnostic material poses many problems. Therefore, we aimed to develop a fast and sensitive method to determine olanzapine levels in saliva, an easily available diagnostic material. To reduce the consumption of toxic solvents during analyte extraction from saliva, olanzapine was isolated by solid-phase extraction using Oasis® MCX cartridges. Chromatographic analysis was performed by LC-MS/MS, with C18 resin in Atlantis® T3 column as the stationary phase and 2 mM ammonium formate and acetonitrile as the mobile phase (flow rate of 0.25 mL/min, with elution gradient). The specificity, linearity, sensitivity, precision, accuracy, and stability of the optimized method were validated. The relative standard deviation for intra-day precision for three tested olanzapine concentrations did not exceed 12.7%; the highest accuracy value was 113.9%. The recoveries from spiked saliva samples were greater than 87.3% for the two olanzapine concentrations studied. The developed method was then used to determine olanzapine levels in human saliva obtained from 15 patients treated with different doses of olanzapine.

Simultaneous Quantification of Antipsychotic and Antiepileptic Drugs and Their Metabolites in Human Saliva Using UHPLC-DAD

Neuroleptics and antiepileptics are excreted in saliva, which can, therefore, be very useful in determining their concentration in the body. This study presents a method developed to simultaneously identify five neuroleptics-olanzapine, quetiapine, risperidone, aripiprazole, and clozapine-and the antiepileptic carbamazepine together with their metabolites: N-demethyl olanzapine, norquetiapine, 9-OH-risperidone, dehydroaripiprazole, N-desmethylclozapine, and carbamazepine-10,11 epoxide. Chlordiazepoxide was used as the internal standard. Strata-X-C columns were used for isolation of the compounds. Chromatographic analysis was carried out using UHPLC with a diode array detector (DAD). A mixture of acetonitrile and water with the addition of formic acid and 0.1% triethylamine was used as the mobile phase. The developed method was validated by determining the linearity for all analytes in the range 10-1000 ng/mL and the value of R² > 0.99. Intra- and inter-day precision were also determined, and the relative standard deviation (RSD) value in both cases did not exceed 15%. To determine the usefulness of the developed method, saliva samples were collected from 40 people of both sexes treated with the tested active substances both in monotherapy and in polypragmasy. In all cases, the active substances tested were identified.