Comparison on Reduction of VOCs Emissions from Radiata Pine (Pinus Radiata D. Don) between Sodium Bicarbonate and Ozone Treatments

Removal of volatile organic compounds (VOCs) from waste air stream using ozone assisted zinc oxide (ZnO) nanoparticles coated on zeolite

The release of volatile organic compounds (VOCs) from stationary and mobile sources increases the concentration of these pollutants in the environment. These compounds have the potential to cause adverse effects on human health and the environment. The adoption of management and engineering procedures to control the emission of these pollutants to the air has become essential. The aim of this study was to use an advanced oxidation process namely the catalytic ozonation to reduce the concentration of these pollutants in industrial output. In this experimental study, the catalytic ozonation process in the presence of ZnO nanoparticles coated on zeolite media was used in a laboratory scale to treat the air contaminated with BTEX compounds as indicators of VOCs. For this purpose, First the nanocomposites were synthesized based on chemical co-precipitation method. SEM, XRD, BET and FT-IR analyses were performed to investigate the characteristics of nanocomposites. The variables including initial concentrations of BTEX (50-200 ppm), polluted air flow rate (5-20 l/h), humidity (0-75%) and ozone dose (0.25-1 g/h) were investigated. The concentration of BTEX compounds was measured by the Gas Chromatography (GC) technique according to the NIOSH 1501 manual. The results of SEM, XRD, BET and FT-IR analyses showed the proper synthesis of nanocomposites. According to the laboratory results, the optimal conditions of the process were found to be as follows: the initial concentration of pollutants equal to 50 ppm, inlet air flow rate of 5 l/h, relative air humidity of 25-35%, and inlet ozone concentration equal to 1 g/h. Under these conditions, the removal efficiency of the compounds: benzene, toluene, ethylbenzene and xylene were obtained 98, 96, 92 and 91%, respectively. Simple ozonation and adsorption processes were less efficient than catalytic ozonation. This process had the ability to reduce the concentration of BTEX compounds to standard level.

Enhancement of Removal of VOCs and Odors from Wood by Microwave-Activated Persulfate

Since traditional methods for removing volatile organic compounds (VOCs) from wood consume large amounts of energy and generate environmental pollution, it is desired to develop a convenient and green treatment method. Oxidation by microwave-activated persulfate (MW-PS) is a promising alternative method that has been used to eliminate VOCs from wood. The penetration of microwave energy can destroy the wood pit membranes and increase VOC emissions. The VOCs are further degraded by ·OH and SO₄ ^•-, which are generated via the activation of microwaves. This phenomenon can be detected by the electron paramagnetic resonance spectrometry. The 35 types of main VOCs of natural wood were determined, including alkanes/terpenes, alcohols/ethers, esters, aldehydes/ketones, and others. In the MW-PS system, 23 compounds were removed with an efficiency of 100%. Specifically, as one of the major compounds, the content of alkanes/terpenes was sharply decreased, and no alcohols/ethers and esters were detected. It was found that the optimal conditions of the MW-PS system for the minimum release of VOCs from wood were the microwave power of 462 W, irradiation time of 30 min, and PS dosage of 0.5 mmol/L.