Inherently Area-Selective Atomic Layer Deposition of Manganese Oxide through Electronegativity-Induced Adsorption

Area-Selective Atomic Layer Deposition of Ru Using Carbonyl-Based Precursor and Oxygen Co-Reactant: Understanding Defect Formation Mechanisms

Area selective deposition (ASD) is a promising IC fabrication technique to address misalignment issues arising in a top-down litho-etch patterning approach. ASD can enable resist tone inversion and bottom-up metallization, such as via prefill. It is achieved by promoting selective growth in the growth area (GA) while passivating the non-growth area (NGA). Nevertheless, preventing undesired particles and defect growth on the NGA is still a hurdle. This work shows the selectivity of Ru films by passivating the Si oxide NGA with self-assembled monolayers (SAMs) and small molecule inhibitors (SMIs). Ru films are deposited on the TiN GA using a metal-organic precursor tricarbonyl (trimethylenemethane) ruthenium (Ru TMM(CO)3) and O2 as a co-reactant by atomic layer deposition (ALD). This produces smooth Ru films (<0.1 nm RMS roughness) with a growth per cycle (GPC) of 1.6 Å/cycle. Minimizing the oxygen co-reactant dose is necessary to improve the ASD process selectivity due to the limited stability of the organic molecule and high reactivity of the ALD precursor, still allowing a Ru GPC of 0.95 Å/cycle. This work sheds light on Ru defect generation mechanisms on passivated areas from the detailed analysis of particle growth, coverage, and density as a function of ALD cycles. Finally, an optimized ASD of Ru is demonstrated on TiN/SiO2 3D patterned structures using dimethyl amino trimethyl silane (DMA-TMS) as SMI.

Vapor-Phase Halogenation of Hydrogen-Terminated Silicon(100) Using N-Halogen-succinimides

The focus of this study was to demonstrate the vapor-phase halogenation of Si(100) and subsequently evaluate the inhibiting ability of the halogenated surfaces toward atomic layer deposition (ALD) of aluminum oxide (Al2O3). Hydrogen-terminated silicon ⟨100⟩ (H-Si(100)) was halogenated using N-chlorosuccinimide (NCS), N-bromosuccinimide (NBS), and N-iodosuccinimide (NIS) in a vacuum-based chemical process. The composition and physical properties of the prepared monolayers were analyzed by using X-ray photoelectron spectroscopy (XPS) and contact angle (CA) goniometry. These measurements confirmed that all three reagents were more effective in halogenating H-Si(100) over OH-Si(100) in the vapor phase. The stability of the modified surfaces in air was also tested, with the chlorinated surface showing the greatest resistance to monolayer degradation and silicon oxide (SiO2) generation within the first 24 h of exposure to air. XPS and atomic force microscopy (AFM) measurements showed that the succinimide-derived Hal-Si(100) surfaces exhibited blocking ability superior to that of H-Si(100), a commonly used ALD resist. This halogenation method provides a dry chemistry alternative for creating halogen-based ALD resists on Si(100) in near-ambient environments.