Supercritical Fluid Extraction of Phenolic Compounds from Mango (Mangifera indica L.) Seed Kernels and Their Application as an Antioxidant in an Edible Oil

Composing functional food from agro-forest wastes: Selectively extracting bioactive compounds using supercritical fluid extraction

Supercritical fluid extraction (SFE) employing carbon dioxide (SC-CO2) is an efficient method to extract bioactive compounds from agro-forest wastes. These compounds maintain and/or improve food nutrition, safety, freshness, taste, and health and are employed as natural functional food components. To highlight the potential of this technology, we focus on the following current advances: (I) parameters affecting solubility in SFE (pressure, temperature, SC-CO2 flow rate, extraction time, and co-solvents); (II) extraction spectra and yield obtained according to proportion and composition of co-solvents; (III) extract bioactivity for functional food production. Fatty acids, monoterpenes, sesquiterpenes, diterpenoids, and low-polarity phenolic acids and triterpenoids were extracted using SFE without a co-solvent. High-polarity phenolic acids and flavonoids, tannins, carotenoids, and alkaloids were only extracted with the help of co-solvents. Using a co-solvent significantly improved the triterpenoid, flavonoid, and phenolic acid yield with a medium polarity.

Deep Eutectic Solvent-Based Aqueous Two-Phase Systems and Their Application in Partitioning of Phenol Compounds

This work studies the partition of phenolic compounds, namely caffeic acid, syringic acid, vanillic acid, ferulic acid, and vanillin, in aqueous two-phase systems (ATPSs) formed by acetonitrile and deep eutectic solvents (DESs) based on choline chloride ([Ch]Cl) and carbohydrates (sucrose, d-glucose, d-mannose, arabinose, and d-xylose). The binodal curves built at 25 °C and 0.1 MPa using DES were compared with ATPS composed of [Ch]Cl and the same carbohydrates. The ability to form ATPS depends on the number and kind of hydroxyl groups in DES's hydrogen-bond donor compound (carbohydrates). ATPS based on DES showed biphasic regions larger than the systems based on [Ch]Cl and carbohydrates alone due to the larger hydrophilicity of DES. The ATPS were used to study the partition of the phenolic compounds. For all the systems, the biomolecules preferentially partitioned to the acetonitrile-rich phase (K > 1), and the best recovery in the top phase ranged between 53.36% (caffeic acid) and 90.09% (vanillin). According to the remarkable results, DES-based ATPS can selectively separate ferulic acid and vanillin for the top phase and syringic, caffeic, and vanillic acids for the bottom phase, achieving a selectivity higher than two.

Valorisation of raw mango pickle industry waste into antimicrobial agent against postharvest fungal pathogens

In mango pickle industry, a significant quantity of mango seed kernels is discarded as solid wastes. These seed kernels can be an ideal source for obtaining extracts rich in bioactive polyphenolic compounds with good antioxidant properties. The potential of mango kernel phenolic extract (MKPE) was investigated as a natural and effective antimicrobial agent for controlling major postharvest fungal pathogen infections, a significant threat to global food supply chains. Fungal pathogens contribute to the deterioration of fruits, vegetables, and grains during storage and transportation, leading to economic losses and compromised food safety. MKPE was obtained from pickling variety 'Ramkela' raw mango kernels, and its phenolic composition was characterized using LC-MS. The in vitro antifungal activity of MKPE against Botrytis cinerea, Colletotrichum gloeosporoides, and Rhizopus stolonifer was evaluated in vitro. A concentration-dependent inhibition of fungal radial growth against all three pathogens was observed, exhibiting the potential of MKPE as a valuable natural resource for addressing postharvest losses caused by fungal pathogens. The extraction process yielded a total phenolic content of 2128 mg GAE/100 g. Major polyphenolic bioactive compounds present were mangiferin, quercetin, and rhamnetin. The in-vitro antimicrobial assay showed reduction in the radial growth and inhibition percent of the pathogens. EC50 values of MKPE for B. cineria, C. gloeosporoides, and R. stolonifer was found to 364.17, 963.8 and 926 ppm, respectively. Our results demonstrate an economical, sustainable, and eco-friendly approach to manage post-harvest diseases rendered by fungi using mango MKPE from pickling industry waste.

Research Progress on Extraction and Detection Technologies of Flavonoid Compounds in Foods

Flavonoid compounds have a variety of biological activities and play an essential role in preventing the occurrence of metabolic diseases. However, many structurally similar flavonoids are present in foods and are usually in low concentrations, which increases the difficulty of their isolation and identification. Therefore, developing and optimizing effective extraction and detection methods for extracting flavonoids from food is essential. In this review, we review the structure, classification, and chemical properties of flavonoids. The research progress on the extraction and detection of flavonoids in foods in recent years is comprehensively summarized, as is the application of mathematical models in optimizing experimental conditions. The results provide a theoretical basis and technical support for detecting and analyzing high-purity flavonoids in foods.

Recent Progress on Green New Phase Extraction and Preparation of Polyphenols in Edible Oil

With the proposal of replacing toxic solvents with non-toxic solvents in the concept of green chemistry, the development and utilization of new green extraction techniques have become a research hotspot. Phenolic compounds in edible oils have good antioxidant activity, but due to their low content and complex matrix, it is difficult to achieve a high extraction rate in a green and efficient way. This paper reviews the current research status of novel extraction materials in solid-phase extraction, including carbon nanotubes, graphene and metal-organic frameworks, as well as the application of green chemical materials in liquid-phase extraction, including deep eutectic solvents, ionic liquids, supercritical fluids and supramolecular solvents. The aim is to provide a more specific reference for realizing the green and efficient extraction of polyphenolic compounds from edible oils, as well as another possibility for the future research trend of green extraction technology.

Flavonoids: Overview of Biosynthesis, Biological Activity, and Current Extraction Techniques

Recently, increased attention has been paid to natural sources as raw materials for the development of new added-value products. Flavonoids are a large family of polyphenols which include several classes based on their basic structure: flavanones, flavones, isoflavones, flavonols, flavanols, and anthocyanins. They have a multitude of biological properties, such as anti-inflammatory, antioxidant, antiviral, antimicrobial, anticancer, cardioprotective, and neuroprotective effects. Current trends of research and development on flavonoids relate to identification, extraction, isolation, physico-chemical characterization, and their applications to health benefits. This review presents an up-to-date survey of the most recent developments in the natural flavonoid classes, the biological activity of representative flavonoids, current extraction techniques, and perspectives.

A Novel Strategy for the Separation of Functional Oils from Chamomile Seeds

The main aim of this study was to evaluate the oils from chamomile seeds as a new source of bioactive compounds suitable for human consumption. A green extraction technique with supercritical carbon dioxide (sc-CO2) at pressures up to 450 bar and temperatures up to 60 °C was employed for the production of a high amount of biologically active oil. Additionally, exhausted waste material was re-extracted using sc-CO2 with the addition of ethanol. By optimization in operating pressure, temperature, production cost, fraction of milled seeds, and co-solvent addition, the amount of separated chamomile oil increased from 2.4 to 18.6% and the content of unsaturated fatty acids up to 88.7%. Oils contained α-bisabolol oxide A and B in amounts up to 1.4%. Linoleic acid was detected in an amount up to 711.1 mg/g and α-linolenic acid up to 27.5 mg/g. The total phenolic content in separated oil reached 80.4 mg GAE/g while the total flavonoid content reached 11.6 mg QE/g. The obtained chamomile oils showed antioxidant activity with an IC50 of up to 3.9 mg/mL. Among the 23 tested microorganisms, the antimicrobial activity of oils was the most pronounced against Gram-positive bacteria. The cytotoxic activity of oils was tested on normal and cancer-derived cell lines. Results indicated a significant potential for oil from chamomile seeds, produced in an eco-friendly manner, as a functional food.

Supplementary Information

The online version contains supplementary material available at 10.1007/s11947-023-03038-9.

Perilla frutescens seed meal as a fat substitute mitigates heterocyclic amine formation and protein oxidation and improves fatty acid profile of pan-fried chicken patties

Fatty acid profile, protein and fatty acid oxidation and flavor profile of pan-fried chicken patties formulated with various levels of Perilla frutescens seed meal (PSM) as a fat substitute was investigated in this study. The formation of heterocyclic amines (HCAs) in the chicken patties was also evaluated. The results showed that pan-fried patties formulated with 20% PSM (PSM4) had the highest ranges of oleic acid and ΣMUFA content and ΣPUFA/ΣSFA ratio. Low to medium levels of PSM (PSM1, 2, and 3 corresponding to 5, 10, and 15% of PSM, respectively) reduced the content of lipid peroxidation products, while high level (PSM4) increased it. All levels of PSM were also found to be effective against elevation in carbonyl content relative to the control. Moreover, the PSM effectively inhibited HCA formation in the chicken patties. The total contents of HCAs in PSM1, PSM2, PSM3, and PSM4 samples were significantly (P < 0.05) lower than that of the control sample, corresponding to 31.9, 46.1, 57.2, and 44.8% inhibition, respectively. PSM4, however, had no or very little effect on the formation of PhIP, 4,8-DiMeIQx and AαC, despite a strong inhibitory effect on MeIQx formation. These findings not only support the promising potential of PSM for application as a fat substitute to improve the fatty acid profile and reduce the content of harmful by-products in heat-processed chicken, but also highlight that appropriate addition level is a critical factor in optimizing the functional capacity of this natural agent.

Sustainable Food Systems: The Case of Functional Compounds towards the Development of Clean Label Food Products

The addition of natural components with functional properties in novel food formulations confers one of the main challenges that the modern food industry is called to face. New EU directives and the global turn to circular economy models are also pressing the agro-industrial sector to adopt cradle-to-cradle approaches for their by-products and waste streams. This review aims to present the concept of “sustainable functional compounds”, emphasizing on some main bioactive compounds that could be recovered or biotechnologically produced from renewable resources. Herein, and in view of their efficient and “greener” production and extraction, emerging technologies, together with their possible advantages or drawbacks, are presented and discussed. Μodern examples of novel, clean label food products that are composed of sustainable functional compounds are summarized. Finally, some action plans towards the establishment of sustainable food systems are suggested.

Application of Response Surface Methodologies to Optimize High-Added Value Products Developments: Cosmetic Formulations as an Example

In recent years, green and advanced extraction technologies have gained great interest to revalue several food by-products. This by-product revaluation is currently allowing the development of high value-added products, such as functional foods, nutraceuticals, or cosmeceuticals. Among the high valued-added products, cosmeceuticals are innovative cosmetic formulations which have incorporated bioactive natural ingredients providing multiple benefits on skin health. In this context, the extraction techniques are an important step during the elaboration of cosmetic ingredients since they represent the beginning of the formulation process and have a great influence on the quality of the final product. Indeed, these technologies are claimed as efficient methods to retrieve bioactive compounds from natural sources in terms of resource utilization, environmental impact, and costs. This review offers a summary of the most-used green and advanced methodologies to obtain cosmetic ingredients with the maximum performance of these extraction techniques. Response surface methodologies may be applied to enhance the optimization processes, providing a simple way to understand the extraction process as well as to reach the optimum conditions to increase the extraction efficiency. The combination of both assumes an economic improvement to attain high value products that may be applied to develop functional ingredients for cosmetics purposes.

Combined ultrasonic/subcritical water hydrolysis pretreatments for agricultural biomass

In response to the intensification of eco-friendly routes as a strategy to access compounds of interest, extraction based on hydrothermal technologies is an efficient method to obtain high yields of compounds present in lignocellulosic materials. Accordingly, this study investigated the effects of the combination of ultrasonic pretreatments (energy density, 1.23 × 10³-37.6 × 10³ J/cm³; reaction time, 15 and 60 min) and subcritical water hydrolysis (SWH) (temperature, 220°C; flow rate, 10-30 mL/min; and reaction time, 0.5-15 min) on sugar yield profile from residual biomass of rice, soybean, and pecan. A characterization of the sugars present in the hydrolyzed solutions by high-performance liquid chromatography (HPLC) and a physicochemical evaluation of biomasses by Fourier-transform infrared spectroscopy (FT-IR) was performed. The highest yield reported were 23.8/100 g biomass, 14.4/100 g biomass, and 6.0/100 g biomass for pecan shell, rice shell, and soybean straw, respectively. Cellobiose, glucose, xylose, and arabinose were quantified by the HPLC, as well as inhibitors and organic acids. FT-IR indicated the compositions of the fresh and pretreated samples. Appropriately, the combined application of ultrasonic and SWH methods supported the valorization and optimization of high potential materials generated in agricultural processing.