Technological and Strength Aspects of Layers Made of Different Powders Laminated on a Polymer Matrix Composite Substrate

The Influence of Flame Exposure and Solid Particle Erosion on Tensile Strength of CFRP Substrate with Manufactured Protective Coating

This paper presents the results of laboratory tests for new materials made of a carbon fibre-reinforced polymer (CFRP) composite with a single-sided protective coating. The protective coatings were made of five different powders-Al2O3, aluminium, quartz sand, crystalline silica and copper-laminated in a single process during curing of the prepreg substrate with an epoxy matrix. The specimens were subjected to flame exposure and solid particle erosion tests, followed by uniaxial tensile tests. A digital image correlation (DIC) system was used to observe the damage location and deformation of the specimens. All coatings subjected to solid particle erosion allowed an increase in tensile failure force ranging from 5% to 31% compared to reference specimens made of purely CFRP. When exposed to flame, only three of the five materials tested, Al2O3, aluminium, quartz sand, could be used to protect the surface, which allowed an increase in tensile failure force of 5.6%.

Effect of Marble Dust on the Mechanical, Morphological, and Wear Performance of Basalt Fibre-Reinforced Epoxy Composites for Structural Applications

The reinforcement of natural fibre and fillers in polymer resin is the latest trend followed by research groups and industries for the development of sustainable composites. Basalt fibre and waste marble powder are naturally occurring substances used to enhanced polymer properties. The present research examined the effect of both basalt fibre and waste marble powder in epoxy resin. The hand lay-up method was employed to fabricate the composite and test for mechanical and wear behaviour. The tensile, flexural, and impact energy were enhanced up to 7.5 wt. % of WMP, and the Vickers hardness of epoxy enhanced every state of reinforcement of WMP. The specific wear rate was observed to be increased with the addition of WMP until 7.5 wt. %. Scanning electron microscopy was performed to examine the nature of fractured surface wear phenomena.