Highly Luminescent Copper Nanoclusters Stabilized by Ascorbic Acid for the Quantitative Detection of 4-Aminoazobenzene

A Ratio Fluorescence Method Based on Dual Emissive Copper Nanoclusters for the Detection of Vanillin

In this study, a novel double-emission fluorescence probe at 340 and 400 nm was synthesized by one-pot method using phenylalanine (Phe) and ascorbic acid (AA) as stabilizing and reducing agents. It was found that the fluorescence intensity of the probe at 400 nm could be controlled by controlling the temperature within a certain range, and the ratio of double-emission fluorescence probe could be further regulated. Under the optimal conditions, the fluorescence intensity at 340 nm decreased significantly, while it only showed a slight decrease at 400 nm, which constituted the ratio fluorescence probe. The synthesized fluorescence probe showed good linearity in the range of 0.2-32 μM, and its detection limit was 63.4 nM. Moreover, the method was successfully employed to determine VA in vanilla drink and perfumes, and corresponding results were consistent with those of HPLC.

Raman and Photoluminescence Spectroscopy with a Variable Spectral Resolution

Raman and photoluminescence (PL) spectroscopy are important analytic tools in materials science that yield information on molecules’ and crystals’ vibrational and electronic properties. Here, we show results of a novel approach for Raman and PL spectroscopy to exploit variable spectral resolution by using zoom optics in a monochromator in the front of the detector. Our results show that the spectral intervals of interest can be recorded with different zoom factors, significantly reducing the acquisition time and changing the spectral resolution for different zoom factors. The smallest spectral intervals recorded at the maximum zoom factor yield higher spectral resolution suitable for Raman spectra. In contrast, larger spectral intervals recorded at the minimum zoom factor yield the lowest spectral resolution suitable for luminescence spectra. We have demonstrated the change in spectral resolution by zoom objective with a zoom factor of 6, but the perspective of such an approach is up to a zoom factor of 20. We have compared such an approach on the prototype Raman spectrometer with the high quality commercial one. The comparison was made on ZrO₂ and TiO₂ nanocrystals for Raman scattering and Al₂O₃ for PL emission recording. Beside demonstrating that Raman spectrometer can be used for PL and Raman spectroscopy without changing of grating, our results show that such a spectrometer could be an efficient and fast tool in searching for Raman and PL bands of unknown materials and, thereafter, spectral recording of the spectral interval of interest at an appropriate spectral resolution.

Intrinsic-to-extrinsic emission tuning in luminescent Cu nanoclusters by in situ ligand engineering

Enhancement of the emission quantum yield and expansion of the emission tunability spectrum are the key aspects of an emitter, which direct the evolution of future generation light harvesting materials. In this regard, small molecular ligand-protected Cu nanoclusters (SLCuNCs) have emerged as prospective candidates. Herein, we report the broadband emission tunability in a SLCuNC system, mediated by in situ ligand replacement. 1,6-Hexanedithiol-protected blue emissive discrete Cu nanoclusters (CuNCs) and red emissive CuNC assemblies have been synthesized in one pot. The red emissive CuNC assemblies were characterized and found to be covalently-linked nanocluster superstructures. The blue emissive CuNC was further converted to a green-yellow emissive CuNC over time by a ligand replacement process, which was mediated by the oxidized form of the reducing agent used for synthesizing the blue emissive nanocluster. Steady-state emission results and fluorescence dynamics studies were used to elucidate that the ligand replacement process not only modulates the emission color but also alters the nature of emission from metal-centered intrinsic to ligand-centered extrinsic emission. Moreover, time-dependent blue to green-yellow emission tunability was demonstrated under optimized reaction conditions.

Green preparation of carbon dots from Momordica charantia L. for rapid and effective sensing of p-aminoazobenzene in environmental samples

p-Aminoazobenzene (pAAB) is a hazardous azo dye that causes considerable harm to human health and the environment. The development of novel and sensitive sensors for the rapid detection of pAAB is in high demand. In this study, a simple fluorescent sensor for pAAB detection is designed based on carbon dots (CDs) which are prepared using green carbon source of Momordica charantia L. via a facile hydrothermal approach. The fluorescence spectra of CDs exhibit considerable overlap with the absorption band of pAAB, and the fluorescence is specifically suppressed in the presence of pAAB ascribed to the inner filter effect. Good and wide linearity is observed in the pAAB concentration range of 0.01-12.5 μg mL^-1 with a lower detection limit of 3.9 ng mL^-1. The established method achieves good results with a rapid analysis of pAAB in different practical water and soil samples. The as-constructed fluorescent sensor provides a simple, rapid, economical and eco-friendly platform and possesses prospective applications for the effective, selective and sensitive detection of pAAB in the environmental field.

Copper nanoclusters: designed synthesis, structural diversity, and multiplatform applications

Atomically precise metal nanoclusters (MNCs) have gained tremendous research interest in recent years due to their extraordinary properties. The molecular-like properties that originate from the quantized electronic states provide novel opportunities for the construction of unique nanomaterials possessing rich molecular-like absorption, luminescence, and magnetic properties. The field of monolayer-protected metal nanoclusters, especially copper, with well-defined molecular structures and compositions, is relatively new, about two to three decades old. Nevertheless, the massive progress in the field illustrates the importance of such nanoobjects as promising materials for various applications. In this respect, nanocluster-based catalysts have become very popular, showing high efficiencies and activities for the catalytic conversion of chemical compounds. Biomedical applications of clusters are an active research field aimed at finding better fluorescent contrast agents, therapeutic pharmaceuticals for the treatment and prevention of diseases, the early diagnosis of cancers and other potent diseases, especially at early stages. A huge library of structures and the compositions of copper nanoclusters (CuNCs) with atomic precisions have already been discovered during last few decades; however, there are many concerns to be addressed and questions to be answered. Hopefully, in future, with the combined efforts of material scientists, inorganic chemists, and computational scientists, a thorough understanding of the unique molecular-like properties of metal nanoclusters will be achieved. This, on the other hand, will allow the interdisciplinary researchers to design novel catalysts, biosensors, or therapeutic agents using highly structured, atomically precise, and stable CuNCs. Thus, we hope this review will guide the reader through the field of CuNCs, while discussing the main achievements and improvements, along with challenges and drawbacks that one needs to face and overcome.