Impact of Reaction Parameters and Water Matrices on the Removal of Organic Pollutants by TiO2/LED and ZnO/LED Heterogeneous Photocatalysis Using 365 and 398 nm Radiation

Influence of wastewater matrix on the visible light degradation of phenol using AgCl/Bi24O31Cl10 photocatalyst

A significant amount of research has been conducted on the development and application of photocatalytic materials for the visible light degradation of organic pollutants in wastewater. However, most pollutant degradation studies are conducted using simulated wastewater often prepared using DI water. This is far removed from the realities of environmentally relevant water systems. It is therefore important to investigate the activity of these semiconductor materials with real water samples. In this study, the photocatalytic activity of the photocatalyst was investigated in the secondary effluent of a wastewater treatment plant (WWTP) in Pretoria, South Africa, for the degradation of phenol under visible light irradiation. The experimental design was done using the Taguchi method L16 orthogonal tray with three factors (pH, initial phenol concentration, and photocatalyst dosage) and four levels. The results show that pH is the highest-ranked significant factor influencing the degradation rate, closely followed by the initial concentration of the pollutant. The photocatalyst dosage had the least significant impact on degradation. The effects of individual anion components such as Cl-, NO3-, NO2-, SO42- and cations such as Ca2+, Mg2+, Zn2+, and K+ were investigated. While Cl- did not negatively influence the degradation rate, the results show that NO3- and SO42- inhibit the degradation of phenol. More specifically, the presence of nitrites resulted in total impeding of the degradation process illustrating that nitrite concentrations ≥ 20 ppm should be removed from wastewater prior to photocatalytic degradation. The cations investigated promoted the degradation of phenol. Generally, there was enhanced degradation in the water matrix when compared to DI water, and the results revealed improved degradation efficiency due to the cumulative impact of various components of the wastewater.

Comparison of TiO2 and ZnO for Heterogeneous Photocatalytic Activation of the Peroxydisulfate Ion in Trimethoprim Degradation

The persulfate-based advanced oxidation process is a promising method for degrading organic pollutants. Herein, TiO2 and ZnO photocatalysts were combined with the peroxydisulfate ion (PDS) to enhance the efficiency. ZnO was significantly more efficient in PDS conversion and SO4•- generation than TiO2. For ZnO, the PDS increased the transformation rate of the trimethoprim antibiotic from 1.58 × 10-7 M s-1 to 6.83 × 10-7 M s-1. However, in the case of TiO2, the moderated positive effect was manifested mainly in O2-free suspensions. The impact of dissolved O2 and trimethoprim on PDS transformation was also studied. The results reflected that the interaction of O2, PDS, and TRIM with the surface of the photocatalyst and their competition for photogenerated charges must be considered. The effect of radical scavengers confirmed that in addition to SO4•-, •OH plays an essential role even in O2-free suspensions, and the contribution of SO4•- to the transformation is much more significant for ZnO than for TiO2. The negative impact of biologically treated domestic wastewater as a matrix was manifested, most probably because of the radical scavenging capacity of Cl- and HCO3-. Nevertheless, in the case of ZnO, the positive effect of PDS successfully overcompensates that, due to the efficient SO4•- generation. Reusability tests were performed in Milli-Q water and biologically treated domestic wastewater, and only a slight decrease in the reactivity of ZnO photocatalysts was observed.

Application of BiOX Photocatalyst to Activate Peroxydisulfate Ion-Investigation of a Combined Process for the Removal of Organic Pollutants from Water

The persulfate-based advanced oxidation processes employing heterogeneous photocatalysts to generate sulfate radicals (SO4•−) from peroxydisulfate ion (PDS, S2O82−) have been extensively investigated to remove organic pollutants. In this work, BiOX (X = Cl, Br, and I) photocatalysts were investigated to activate PDS and enhance the transformation rate of various organic substances under UV (398 nm) and Vis (400–700 nm) radiation. For BiOCl and BiOBr, in addition to excitability, the light-induced oxygen vacancies are decisive in the activity. Although without organic substances, the BiOI efficiency highly exceeds that of BiOBr and BiOCl for PDS activation (for BiOI, 15–20%, while for BiOBr and BiOCl, only 3–4% of the PDS transformed); each BiOX catalyst showed enhanced activity for 1,4-hydroquinone (HQ) transformation due to the semiquinone radical-initiated PDS activation. For sulfamethoxypyridazine (SMP), the transformation is driven by direct charge transfer, and the effect of PDS was less manifested. BiOI proved efficient for transforming various organic substances even under Vis radiation. The efficiency was enhanced by PDS addition (HQ is wholly transformed within 20 min, and SMP conversion increased from 40% to 90%) without damaging the catalyst; its activity did change over three consecutive cycles. Results related to the well-adsorbed trimethoprim (TRIM) and application of biologically treated domestic wastewater as a matrix highlighted the limiting factors of the method and visible light active photocatalyst, BiOI.

Acetaminophen degradation in aqueous solution by the UV-LED-EC/Cl2 process

In this study, electrochemically generated free chlorine (EC/Cl2) was activated by UV irradiation with a light emitting diode (LED) lamp at 275 nm to degrade acetaminophen (AAP, 2 μM) in aqueous solution. The potential at a RuO2-IrO2/Ti plate anode was set at 1.5 V vs. the Ag/AgCl electrode. Chlorine was in situ generated in the presence of Cl at the anode and then it was transformed into various active species such as OH and reactive chlorine species (RCS) under UV-LED irradiation. The degradation of AAP was investigated using batch tests, evaluating the influence of different experimental conditions such as NaCl concentration, phosphate buffer saline concentration, irradiation time and solution pH, keeping constant the UV-LED power and temperature. Results show that AAP could be completely degraded by the hybrid process with a high mineralization ratio (73%), and the degradation process followed a pseudo-first-order kinetics. The value of the Electric Energy per Order (EEO) = 1.272 kWh m3 order?, which is lower than the energy consumption of some other UV-based processes for AAP degradation. Adding 1 mM HCO3 ions slightly decreased the rate of AAP degradation. Luminescent bacteria experiment revealed that the acute toxicity of the reacted solution could be greatly reduced and the ecological risk was effectively abated. The scavenging assay shows that RCS plays a key role in the AAP degradation. The intermediate products were identified, and possible degradation routes were proposed. The system can advantageously replace conventional UV mercury lamp based ones in the degradation of microorganic pollutants.

Efficient Removal of Cr(VI) by TiO2 Based Micro-Nano Reactor via the Synergy of Adsorption and Photocatalysis

The low-toxicity treatment of chromium-containing wastewater represents an important way of addressing key environmental problems. In this study, a core-shell structural ZIF-8@TiO2 photocatalyst was synthesized by a simple one-step hydrothermal method. The obtained composite photocatalyst possessed improved photocatalytic activity compared with TiO2. The results indicated that the optimized ZIF-8@TiO2 composite exhibited the highest removal efficiency with 93.1% of Cr(VI) after 120 min under UV-vis irradiation. The removal curves and XPS results indicated that the adsorbed Cr(VI) on the ZIF-8 during the dark process was preferentially reduced. The superior removal efficiency of ZIF-8@TiO2 is attributed to the combination of both high adsorption of ZIF-8, which attracted Cr(VI) on the composite surface, and the high separation efficiency of photo-induced electron-hole pairs. For the mixture of wastewater that contained methyl orange and Cr(VI), 97.1% of MO and 99.7% of Cr(VI) were removed after 5 min and 60 min light irradiation, respectively. The high removal efficiency of multiple pollutants provides promising applications in the field of Cr(VI) contaminated industrial wastewater treatment.