Perovskite-Based X-ray Detectors

Direct detection of minimum ionizing charged particles in a perovskite single crystal detector with single particle sensitivity

We report the detection of high energy electrons of some hundreds of MeV, crossing a methylammonium lead bromide single crystal device with sensitivity down to a single electron. In the device, the released energy is close to the energy released by minimum-ionizing particles. This is the first demonstration of a perovskite-based device that can be used for tracking and counting minimum-ionizing charged particles. The device reaches single particle sensitivity with a low bias voltage of 5 V. It also shows a good linearity of the response as a function of the number of electrons in a dynamic range of approximately 104.

Perovskite materials in X-ray detection and imaging: recent progress, challenges, and future prospects

Perovskite materials have attracted significant attention as innovative and efficient X-ray detectors owing to their unique properties compared to traditional X-ray detectors. Herein, chronologically, we present an in-depth analysis of X-ray detection technologies employing organic-inorganic hybrids (OIHs), all-inorganic and lead-free perovskite material-based single crystals (SCs), thin/thick films and wafers. Particularly, this review systematically scrutinizes the advancement of the diverse synthesis methods, structural modifications, and device architectures exploited to enhance the radiation sensing performance. In addition, a critical analysis of the crucial factors affecting the performance of the devices is also provided. Our findings revealed that the improvement from single crystallization techniques dominated the film and wafer growth techniques. The probable reason for this is that SC-based devices display a lower trap density, higher resistivity, large carrier mobility and lifetime compared to film- and wafer-based devices. Ultimately, devices with SCs showed outstanding sensitivity and the lowest detectable dose rate (LDDR). These results are superior to some traditional X-ray detectors such as amorphous selenium and CZT. In addition, the limited performance of film-based devices is attributed to the defect formation in the bulk film, surfaces, and grain boundaries. However, wafer-based devices showed the worst performance because of the formation of voids, which impede the movement of charge carriers. We also observed that by performing structural modification, various research groups achieved high-performance devices together with stability. Finally, by fusing the findings from diverse research works, we provide a valuable resource for researchers in the field of X-ray detection, imaging and materials science. Ultimately, this review will serve as a roadmap for directing the difficulties associated with perovskite materials in X-ray detection and imaging, proposing insights into the recent status, challenges, and promising directions for future research.

Self-Assembled Monolayer-Based Hole-Transporting Materials for Perovskite Solar Cells

Ever since self-assembled monolayers (SAMs) were adopted as hole-transporting layers (HTL) for perovskite solar cells (PSCs), numerous SAMs for HTL have been synthesized and reported. SAMs offer several unique advantages including relatively simple synthesis, straightforward molecular engineering, effective surface modification using small amounts of molecules, and suitability for large-area device fabrication. In this review, we discuss recent developments of SAM-based hole-transporting materials (HTMs) for PSCs. Notably, in this article, SAM-based HTMs have been categorized by similarity of synthesis to provide general information for building a SAM structure. SAMs are composed of head, linker, and anchoring groups, and the selection of anchoring groups is key to design the synthetic procedure of SAM-based HTMs. In addition, the working mechanism of SAM-based HTMs has been visualized and explained to provide inspiration for finding new head and anchoring groups that have not yet been explored. Furthermore, both photovoltaic properties and device stabilities have been discussed and summarized, expanding reader's understanding of the relationship between the structure and performance of SAMs-based PSCs.