Application of Thin-Layer Chromatography in Combination with Densitometry for the Determination of Diclofenac in Enteric Coated Tablets

Visual Eosin Y-Based Photosensitization Sensing Systems for Ultrasensitive Detection of Diclofenac with Single-Atom Co─N2O2 Site-Immobilized g-C3N4 Nanosheets

It is highly desired to develop a visual sensing system for ultrasensitive detection of colorless diclofenac (DCF), yet with a significant challenge. Herein, a novel dye-based photosensitization sensing system has been successfully developed for detecting DCF for the first time, in which the used dye eosin Y (DeY) can strongly absorb visible light and then be decolorized obviously by transferring photogenerated electrons to g-C3N4 nanosheets (CN), while the built single-atomic Co─N2O2 sites on CN by boron-oxygen connection can competitively adsorb DCF to impede the photosensitization decoloration of DeY. This system exhibits a broad detection range from 8 ng L-1 to 2 mg L-1 with 535 nm light, an exceptionally low detection limit (3.5 ng L-1), and remarkable selectivity. Through the time-resolved, in situ technologies, and theoretical calculations, the decolorization of DeY is attributed to the disruption of DeY's conjugated structure caused by the triplet excited state electron transfer from DeY to CN, meanwhile, the adsorbed oxygen facilitates the charge transfer process. The preferential adsorption of DCF mainly depends on the strong interactions between the as-constructed single-atom Co and Cl in DCF. This study opens an innovative light-driven sensing system by combining dye and single-atom metal/nanomaterial for visually intuitive detection of environmental pollutants.

TLC–Densitometry for Determination of Omeprazole in Simple and Combined Pharmaceutical Preparations

TLC combined with densitometry was used and chromatographic conditions developed to separate omeprazole and diclofenac sodium from their potential impurities. The development of the TLC–densitometry method is based on the elaboration of new chromatographic conditions allowing for the simultaneous determination of omeprazole and diclofenac sodium in a pharmaceutical preparation. Identification and quantification of omeprazole in simple and combined (with diclofenac) pharmaceutical preparations was performed on silica gel 60F₂₅₄ using one mobile phase: chloroform–methanol–ammonia (36:4:0.60, v/v). Diclofenac sodium was determined in the presence of omeprazole after 2D separation on silica gel using two mobile phases of the first phase of chloroform–methanol–ammonia (36:4:0.60, v/v) and the second mobile phase cyclohexane–chloroform–methanol–glacial acetic acid (6:3:0.5:0.5 v/v). The developed method is simple, economical, specific, precise, accurate, sensitive, and robust, with a good range of linearity for the quantification of omeprazole and diclofenac sodium. TLC in combination with densitometry can be used as an effective analytical tool for quality control and quantitative determination of omeprazole in simple and combined pharmaceutical preparations containing diclofenac sodium. TLC in combination with densitometry can be recommended for the analysis of omeprazole and diclofenac sodium in the absence of HPLC or spectrophotometer in the laboratory or to confirm results obtained with other analytical techniques.

High-Performance Thin-Layer Chromatography (HPTLC) Method for Identification of Meloxicam and Piroxicam

Background: High-performance thin-layer chromatography (HPTLC) is an advantageous, modern analytical technique based on the principles of thin-layer chromatography (TLC), which provides essential benefits, such as improved sample application, better and faster separation, and less mobile phase usage. The aim of this work was to develop a simple and rapid HPTLC method that could be used for the identification of meloxicam and piroxicam. Methods: HPTLC. An analysis was carried out using silica gel 60 F254 glass TLC plates and as the mobile phase: hexane: ethyl acetate: glacial acetic acid, in a ratio of 65:30:5 v/v/v. For the standard solution preparation, ethanol was used. Front: 60 mm. Detection was performed at 366 nm. Results: The Rf value for meloxicam was 0.81 and the Rf value for piroxicam was 0.57. The proposed method can be used in the detection of the analyzed compounds in very low concentrations. It was established that the detection limit of meloxicam was 0.04 μg per band and that of piroxicam was 0.05 μg per band. It was also established that the quantitation limit of meloxicam was 0.12 μg per band and that of piroxicam was 0.15 μg per band. Conclusions: The proposed method is simple, sensitive, stable, cost effective, and eco-friendly. It could be used in research or for routine quality control purposes.

Use of TLC-Densitometric Method for Determination of Valproic Acid in Capsules

Determination of valproic acid in the drug was carried out on the aluminum silica gel 60F₂₅₄ plates and using acetone-water-chloroform-ethanol-ammonia at a volume ratio of 30:1:8:5:11 as the mobile phase, respectively. Two methods of detection of valproic acid were used. The first was a 2% aqueous CuSO₄×5H₂O solution, and the second was a 2',7'-dichlorofluorescein-aluminum chloride-iron (III) chloride system. The applied TLC-densitometric method is selective, linear, accurate, precise, and robust, regardless of the visualizing reagent used for the determination of valproic acid in Convulex capsules. It has low limits of detection (LOD) and limits of quantification (LOQ), which are equal to 5.8 μg/spot and 17.4 μg/spot using a 2% aqueous CuSO₄×5H₂O solution as visualizing agent and also 0.32 μg/spot and 0.97 μg/spot using a 2',7'-dichlorofluorescein-aluminum chloride-iron (III) chloride system as visualizing reagent, respectively. The described analytical method can additionally be used to study the identity of valproic acid in a pharmaceutical preparation. The linearity range was found to be 20.00-80.00 μg/spot and 1.00-2.00 μg/spot for valproic acid detected on chromatographic plates using a 2% aqueous CuSO₄×5H₂O solution and the 2',7'-dichlorofluorescein-aluminum chloride-iron (III) chloride system, respectively. A coefficient of variation that was less than 3% confirms the satisfactory accuracy and precision of the proposed method. The results of the assay of valproic acid equal 96.2% and 97.0% in relation to the label claim that valproic acid fulfill pharmacopoeial requirements. The developed TLC-densitometric method can be suitable for the routine analysis of valproic acid in pharmaceutical formulations. The proposed TLC-densitometry may be an alternative method to the modern high-performance liquid chromatography and square wave voltammetry in the control of above-mentioned substances, and it can be applied when other analytical techniques is not affordable in the laboratory.

First derivative ATR-FTIR spectroscopic method as a green tool for the quantitative determination of diclofenac sodium tablets

Background: Attenuated total reflection-Fourier transform infrared (ATR-FTIR) spectroscopy is a rapid quantitative method which has been applied for pharmaceutical analysis. This work describes the utility of first derivative ATR-FTIR spectroscopy in the quantitative determination of diclofenac sodium tablets.

Methods: This analytical quantitative technique depends on a first derivative measurement of the area of infrared bands corresponding to the CO stretching range of 1550-1605 cm ^-1. The specificity, linearity, detection limits, precision and accuracy of the calibration curve, the infrared analysis and data manipulation were determined in order to validate the method. The statistical results were compared with other methods for the quantification of diclofenac sodium.

Results: The excipients in the commercial tablet preparation did not interfere with the assay. Excellent linearity was found for the drug concentrations in the range 0.2 – 1.5 w/w %.  (r ²= 0.9994). Precision of the method was assessed by the repeated analysis of diclofenac sodium tablets; the results obtained showed small standard deviation and relative standard deviation values, which indicates that the method is quite precise. The high percentage of recovery of diclofenac sodium tablets (99.81, 101.54 and 99.41%) demonstrate the compliance of the obtained recoveries with the pharmacopeial percent recovery. The small limit of detection and limit of quantification values (0.0528 and 0.1599 w/w %, respectively) obtained by this method indicate the high sensitivity of the method.

Conclusions: First derivative ATR-FTIR spectroscopy showed high accuracy and precision, is considered as nondestructive, green, low cost and rapid, and can be applied easily for the pharmaceutical quantitative determination of diclofenac sodium tablet formulations.

First derivative ATR-FTIR spectroscopic method as a green tool for the quantitative determination of diclofenac sodium tablets

Background: Attenuated total reflection-Fourier transform infrared (ATR-FTIR) spectroscopy is a rapid quantitative method which has been applied for pharmaceutical analysis. This work describes the utility of first derivative ATR-FTIR spectroscopy in the quantitative determination of diclofenac sodium tablets. Methods: This analytical quantitative technique depends on a first derivative measurement of the area of infrared bands corresponding to the CO stretching range of 1550-1605 cm -1. The specificity, linearity, detection limits, precision and accuracy of the calibration curve, the infrared analysis and data manipulation were determined in order to validate the method. The statistical results were compared with other methods for the quantification of diclofenac sodium. Results: The excipients in the commercial tablet preparation did not interfere with the assay. Excellent linearity was found for the drug concentrations in the range 0.2 - 1.5 w/w %.  (r 2= 0.9994). Precision of the method was assessed by the repeated analysis of diclofenac sodium tablets; the results obtained showed small standard deviation and relative standard deviation values, which indicates that the method is quite precise. The high percentage of recovery of diclofenac sodium tablets (99.81, 101.54 and 99.41%) demonstrate the compliance of the obtained recoveries with the pharmacopeial percent recovery. The small limit of detection and limit of quantification values (0.0528 and 0.1599 w/w %, respectively) obtained by this method indicate the high sensitivity of the method. Conclusions: First derivative ATR-FTIR spectroscopy showed high accuracy and precision, is considered as nondestructive, green, low cost and rapid, and can be applied easily for the pharmaceutical quantitative determination of diclofenac sodium tablet formulations.