Exorbitant Drug Loading of Metformin and Sitagliptin in Mucoadhesive Buccal Tablet: In Vitro and In Vivo Characterization in Healthy Volunteers

Development of a hydroxypropyl methyl cellulose/polyacrylic acid interpolymer complex formulated buccal mucosa adhesive film to facilitate the delivery of insulin for diabetes treatment

Buccal mucosa administration is a promising method for insulin (INS) delivery with good compliance. However, buccal mucosa delivery systems still face challenges of long-term mucosal adhesion, sustained drug release, and mucosal drug penetration. To address these issues, a double-layer film consisting of a hydroxypropyl methylcellulose/polyacrylic acid interpolymer complex (IPC)-formulated mucoadhesive layer and an ethylcellulose (EC)-formulated waterproof backing layer (IPC/EC film) was designed. Protamine (PTM) and INS were co-loaded in the mucoadhesive layer of the IPC/EC film (PTM-INS-IPC/EC film). In ex vivo studies with porcine buccal mucosa, this film exhibited robust adhesion, with an adhesion force of 120.2 ± 20.3 N/m2 and an adhesion duration of 491 ± 45 min. PTM has been shown to facilitate INS mucosal transfer. Pharmacokinetic studies indicated that the PTM-INS-IPC/EC film significantly improved the absorption of INS, exhibiting a 1.45 and 2.24-fold increase in the area under the concentration-time curve (AUC0-∞) compared to the INS-IPC/EC film and free INS, respectively. Moreover, the PTM-INS-IPC/EC film effectively stabilized the blood glucose levels of type 1 diabetes mellitus (T1DM) rats with post oral glucose administration, maintaining lower glucose levels for approximately 8 h. Hence, the PTM-INS-IPC/EC film provides a promising noninvasive INS delivery system for diabetes treatment.

Correction: Shakir et al. Exorbitant Drug Loading of Metformin and Sitagliptin in Mucoadhesive Buccal Tablet: In Vitro and In Vivo Characterization in Healthy Volunteers. Pharmaceuticals 2022, 15, 686

In the original publication, a mistake was observed in Figure 5 as published [...].

The Preparation and Evaluation of Cyanocobalamin Mucoadhesive Sublingual Tablets

Cobalamin (vitamin B12), an essential vitamin with low oral bioavailability, plays a vital role in cellular functions. This research aimed to enhance the absorption of vitamin B12 using sublingual mucoadhesive tablets by increasing the residence time of the drug at the administration site. This research involved the preparation of different 50 mg placebo formulas using different methods. Formulas with disintegration times less than one minute and appropriate physical characteristics were incorporated into 1 mg of cyanocobalamin (S1-S20) using the direct compression method. The tablets obtained were evaluated ex vivo for residence time, and only those remaining for >15 min were included. The final formulas (S5, S8, S11, and S20) were evaluated in several ways, including pre- and post-compression, drug content, mucoadhesive strength, dissolution, and Permeapad® permeation test employed in the Franz diffusion cell. After conducting the evaluation, formula S11 (Eudragit L100-55) emerged as the most favorable formulation. It exhibited a mucoadhesive residence time of 118.2 ± 2.89 min, required a detachment force of 26 ± 1 g, maintained a drug content of 99.124 ± 0.001699%, and achieved a 76.85% drug release over 22 h, fitting well with the Peppas-Sahlin kinetic model (R2: 0.9949). This suggests that the drug release process encompasses the Fickian and non-Fickian kinetic mechanisms. Furthermore, Eudragit L100-55 demonstrated the highest permeability, boasting a flux value of 6.387 ± 1.860 µg/h/cm2; over 6 h. These findings indicate that including this polymer in the formulation leads to an improved residence time, which positively impacts bioavailability.

Special Issue "Recent Advances in Oral Drug Delivery Development"

This Special Issue, entitled "Recent Advances in Oral Drug Delivery Development", aims to demonstrate new advances and future trends in the field of oral drug delivery [...].

Assessment of Binary Agarose-Carbopol Buccal Gels for Mucoadhesive Drug Delivery: Ex Vivo and In Vivo Characterization

Agarose (AG) is a naturally occurring biocompatible marine seaweed extract that is converted to hydrocolloid gel in hot water with notable gel strength. Currently, its mucoadhesion properties have not been fully explored. Therefore, the main aim of this study was to evaluate the mucoadhesive potential of AG binary dispersions in combination with Carbopol 934P (CP) as mucoadhesive gel preparations. The gels fabricated via homogenization were evaluated for ex vivo mucoadhesion, swelling index (SI), dissolution and stability studies. The mucoadhesive properties of AG were concentration dependent and it was improved by the addition of CP. Maximum mucoadhesive strength (MS) (27.03 g), mucoadhesive flow time (FT) (192.2 min), mucoadhesive time in volunteers (MT) (203.2 min) and SI (23.6% at 4 h) were observed with formulation F9. The mucoadhesive time investigated in volunteers (MT) was influenced by AG concentration and was greater than corresponding FT values. Formulations containing 0.3%, w/v AG (F3 and F9) were able to sustain the release (~99%) for both drugs till 3 h. The optimized formulation (F9) did not evoke any inflammation, irritation or pain in the buccal cavity of healthy volunteers and was also stable up to 6 months. Therefore, AG could be considered a natural and potential polymer with profound mucoadhesive properties to deliver drugs through the mucosal route.