Probing Interactions in Combined Hydroxide Base Solvents for Improving Dissolution of Cellulose

Bacterial Cellulose Aerogels Derived from Pineapple Peel Waste for the Adsorption of Dyes

Valorization of pineapple peel waste is an attractive research topic because of the huge quantities of this byproduct generated from pineapple processing industries. In this study, the extract from pineapple waste was collected to produce a hydrogel-like form containing bacterial cellulose fibers with a three-dimensional structure and nanoscale diameter by the Acetobacter xylinum fermentation process. The bacterial cellulose suspension was subsequently activated by freeze-drying, affording lightweight aerogels as potential adsorbents in wastewater treatment, in particular the adsorptive removal of organic dyes. Intensive tests were carried out with the adsorption of methylene blue, a typical cationic dye, to investigate the influence of adsorption conditions (temperature, pH, initial dye concentration, time, and experiment scale) and aerogel-preparation parameters (grinding time and bacterial cellulose concentration). The bacterial cellulose-based aerogels exhibited high adsorption capacity not only for methylene blue but also for other cationic dyes, including malachite green, rhodamine B, and crystal violet (28-49 mg/g). However, its activity was limited for most of the anionic dyes, such as methyl orange, sunset yellow, and quinoline yellow, due to the repulsion of these anionic dyes with the aerogel surface, except for the case of congo red. It is also an anionic dye but has two amine groups providing a strong interaction with the hydroxyl group of the aerogel via hydrogen bonding. Indeed, the aerogel has a substantially large congo red-trapping capacity of 101 mg/g. Notably, the adsorption process exhibited similar performances, upscaling the solution volume to 50 times. The utilization of abundant agricultural waste in the simple aerogel preparation to produce a highly efficient and biodegradable adsorbent is the highlight of this work.

Investigation of cellulose dissolution in morpholinium-based solvents: impact of solvent structural features on cellulose dissolution

A series of N-methylmorpholinium salts with varying N-alkyl chains and Cl-, OAc- and OH- as counter ions have been synthesized and investigated for their ability to dissolve cellulose, aiming at elucidating solvent structural features affecting cellulose dissolution. Synthesis procedures have been developed to, to a high extent, rely on conversions in water and microwave-assisted reactions employing a reduced number of work-up steps and ion-exchange resins that can be regenerated. Water solutions of morpholinium hydroxides proved capable of dissolving cellulose, with those of them possessing alkyl chains longer than ethyl showing surprising dissolution ability at room-temperature. Morpholinium acetates behaved as ionic liquids, and were also capable of dissolving cellulose when combined with DMSO. The obtained cellulose solutions were characterized according to their chemical and colloidal stability using 13C NMR spectroscopy, size exclusion chromatography and flow sweep measurements, while the ethanol coagulates were investigated in terms of crystallinity using solid state NMR. In contrast, the morpholinium chlorides obtained were hygroscopic with high melting points and low solubility in common organic solvents e.g., acetone, DMSO and DMAc, thus lacking the ability to swell or dissolve cellulose.

Perspectives on the Lindman Hypothesis and Cellulose Interactions

In the history of cellulose chemistry, hydrogen bonding has been the predominant explanation when discussing intermolecular interactions between cellulose polymers. This is the general consensus in scholarly textbooks and in many research articles, and it applies to several other biomacromolecules' interactions as well. This rather unbalanced description of cellulose has likely impacted the development of materials based on the processing of cellulose-for example, via dissolution in various solvent systems and regeneration into solid materials, such as films and fibers, and even traditional wood fiber handling and papermaking. In this review, we take as a starting point the questioning of the general description of the nature of cellulose and cellulose interactions initiated by Professor Björn Lindman, based on generic physicochemical reasoning about surfactants and polymers. This dispute, which became known as "the Lindman hypothesis", highlights the importance of hydrophobic interactions in cellulose systems and that cellulose is an amphiphilic polymer. This paper elaborates on Björn Lindman's contribution to the subject, which has caused the scientific community to revisit cellulose and reconsider certain phenomena from other perspectives.

Progress on chemical modification of cellulose in “green” solvents

Chemical modification of cellulose in "green" solvents.

In situ monitoring of cellulose etherification in solution: probing the impact of solvent composition on the synthesis of 3-allyloxy-2-hydroxypropyl-cellulose in aqueous hydroxide systems

Cellulose etherification can be affected by tuning the solvent composition as indicated by monitoring the reaction using in situ IR spectroscopy and rheology measurements together with NMR characterisation.

Fundamental aspects of the non-covalent modification of cellulose via polymer adsorption

The increasing need for new material applications based on cellulose demands increased functional diversity and thus new functionalisation/modification approaches. The non-covalent modification of cellulose fibres via the adsorption of functional polymers has emerged as a promising route for tailoring the properties of material. This review focuses on fundamental aspects of polymer adsorption on cellulose surfaces, where the adsorption of polyelectrolytes and non-polyelectrolytes are treated separately. Adsorption studies on model surfaces as well as cellulose macro-fibres are reviewed. A correlation of the adsorption findings with the Scheutjens-Fleer polymer adsorption theory is provided, allowing the fundamentals behind the polymer adsorption phenomenon and its context in utilization of cellulose fibres to be understood.

Scattering studies of the size and structure of cellulose dissolved in aqueous hydroxide base solvents

Combining NaOH with other hydroxide bases with superior dissolution properties can be a means of improving dissolution of cellulose. However, this raises questions about how the size and structure of cellulose vary when dissolved in different hydroxide bases. Here, cellulose in aqueous solutions of NaOH, Tetramethylammonium hydroxide (TMAH), Benzyltrimethylammonium hydroxide (Triton B) and previously studied equimolar solutions of NaOH/TMAH and NaOH/Triton B were investigated using small angle X-ray scattering, static and dynamic light scattering. The results show that cellulose in NaOH(aq) is largely aggregated and that the more hydrophobic TMAH and Triton are capable of molecularly dissolving cellulose into worm-like conformations, stiffer than in NaOH. The dissolution properties of mixtures are highly dependent on the compatibility of the individual bases; in line with previous observations of the properties of the solutions which now could be correlated to the structure of the cellulose on a nano- and microscale.

Hydrophobic interactions control the self-assembly of DNA and cellulose

Desoxyribosenucleic acid, DNA, and cellulose molecules self-assemble in aqueous systems. This aggregation is the basis of the important functions of these biological macromolecules. Both DNA and cellulose have significant polar and nonpolar parts and there is a delicate balance between hydrophilic and hydrophobic interactions. The hydrophilic interactions related to net charges have been thoroughly studied and are well understood. On the other hand, the detailed roles of hydrogen bonding and hydrophobic interactions have remained controversial. It is found that the contributions of hydrophobic interactions in driving important processes, like the double-helix formation of DNA and the aqueous dissolution of cellulose, are dominating whereas the net contribution from hydrogen bonding is small. In reviewing the roles of different interactions for DNA and cellulose it is useful to compare with the self-assembly features of surfactants, the simplest case of amphiphilic molecules. Pertinent information on the amphiphilic character of cellulose and DNA can be obtained from the association with surfactants, as well as on modifying the hydrophobic interactions by additives.