Tetrafunctional Epoxy Resin-Based Buoyancy Materials: Curing Kinetics and Properties

A Study on Temperature Distribution within HVDC Bushing Influenced by Accelerator Content during the Curing Process

Power transmission technology plays an important role in energy sustainability. Bushing is an indispensable type of equipment in power transmission. In production, the accelerator changes the temperature distribution during the curing process, influencing the formation of defects and thus the safety output of renewable energy. In this study, uncured epoxy resin samples with different accelerator contents were prepared and measured by differential scanning calorimetry (DSC). The obtained heat flow curves were analyzed for curing kinetics. Then, the curing process of large length–diameter ratio bushings was simulated by using the finite element method combined with a curing kinetics model, transient Fourier heat transfer model, and stress–strain model. The study reveals that the curing system can be established by the Sestak–Berggren autocatalytic model with different accelerator contents. The overall curing degree and the maximum radial temperature difference of the capacitor core tend to increase and then decrease with the accelerator content. This is mainly attributable to the rapid exotherm excluding the participation of some molecular chains in the reaction, resulting in permanent under-curing. As the accelerator content increases, the strain peak decreases and then increases. This paper provides guidance for the comprehensive evaluation and manufacturing of the low-defect capacitor cores of large-size high voltage direct current (HVDC) bushings.

Non-Isothermal Crystallization Kinetics of Poly(Ethylene Glycol)-Poly(l-Lactide) Diblock Copolymer and Poly(Ethylene Glycol) Homopolymer via Fast-Scan Chip-Calorimeter

The non-isothermal crystallization kinetics of double-crystallizable poly(ethylene glycol)-poly(l-lactide) diblock copolymer (PEG-PLLA) and poly(ethylene glycol) homopolymer (PEG) were studied using the fast cooling rate provided by a Fast-Scan Chip-Calorimeter (FSC). The experimental data were analyzed by the Ozawa method and the Kissinger equation. Additionally, the total crystallization rate was represented by crystallization half time t1/2. The Ozawa method is a perfect success because secondary crystallization is inhibited by using fast cooling rate. The first crystallized PLLA block provides nucleation sites for the crystallization of PEG block and thus promotes the crystallization of the PEG block, which can be regarded as heterogeneous nucleation to a certain extent, while the method of the PEG block and PLLA block crystallized together corresponds to a one-dimensional growth, which reflects that there is a certain separation between the crystallization regions of the PLLA block and PEG block. Although crystallization of the PLLA block provides heterogeneous nucleation conditions for PEG block to a certain extent, it does not shorten the time of the whole crystallization process because of the complexity of the whole crystallization process including nucleation and growth.