Ortho-Functionalized Dibenzhydryl Substituents in α-Diimine Pd Catalyzed Ethylene Polymerization and Copolymerization

Slurry Homopolymerization of Ethylene Using Thermostable α-Diimine Nickel Catalysts Covalently Linked to Silica Supports via Substituents on Acenaphthequinone-Backbone

Four supported α-diimine nickel(II) catalysts covalently linked to silica via hydroxyl functionality on α-diimine acenaphthequinone-backbone were prepared and used in slurry polymerizations of ethylene to produce branched polyethylenes. The catalytic activities of these still reached 10⁶ g/molNi·h at 70 °C. The life of the supported catalyst is prolonged, as can be seen from the kinetic profile. The molecular weight of the polyethylene obtained by the 955 silica gel supported catalyst was higher than that obtained by the 2408D silica gel supported catalyst. The melting points of polyethylene obtained by the supported catalysts S-C1-a/b are all above 110 °C. Compared with the homogeneous catalyst, the branching numbers of the polyethylenes obtained by the supported catalysts S-C1-a/b is significantly lower. The polyethylenes obtained by supported catalyst S-C1-a/b at 30-50 °C are free-flowing particles, which is obviously better than the rubber-like cluster polymer obtained from homogeneous catalyst.

Distorted Sandwich a-Diimine Pd(II) Catalyst: Linear Polyethylene and Synthesis of Ethylene/Acrylate Elastomers

The introduction of m-xylyl substituents to α-diimine Pd(II) catalyst promotes living ethylene polymerization at room temperature and low pressure to yield high molecular weight polyethylene (PE) with low branching (<17/1000C). m-Xylyl groups provide a highly effective blockage to the axial sites of the catalytic center and form a distorted sandwich geometry. The shielding prevents chain-transfer and easy accessibility of polar monomers, leading to a living polymerization. Conducting a light irradiation as part of the one-step metal-organic insertion light initiated radical (MILRad) process leads to diblock copolymers of ethylene and acrylates. Incorporation of different acrylate block sequences can significantly modify the mechanical and chemical properties of block copolymers which can be modulated to be a hard plastic, elastomer, or semi-amorphous polymer.

Influence of intramolecular π–π and H-bonding interactions on pyrazolylimine nickel-catalyzed ethylene polymerization and co-polymerization

Pyrazolylimine-based nickel catalysts bearing intramolecular π–π and H-bonding interactions show high activity, thermal stability, and Mn of polyethylene.