A Directly Compressible Pregelatinised Sago Starch: A New Excipient in the Pharmaceutical Tablet Formulations

Evaluation of digoxin-boronate ester formation through in-capillary derivatisation-large volume sample stacking-capillary zone electrophoresis

Determination of digoxin through in-capillary derivatisation based on the formation of o-tolyl- and 2-naphthyl-anionic boronate esters in combination with large volume sample stacking-capillary electrophoresis is proposed. The derivatisation reaction was performed at basic pH values to obtain compounds with a charge and chromophore group during the stacking process. After stacking, the species were separated and detected at 225 nm using p-nitrophenol as an internal standard. Stacking and derivatisation parameters such as pre-concentration time, preconcentration voltage and injection time (relation between the analyte and the derivatisation agent) were evaluated using a Box-Behnken design. Under optimal conditions, the proposed method exhibits a linear range of 1.08-50.00 μM with a limit of detection of 0.36 μM; additionally, adequate repeatability and reproducibility was obtained (%RSD ≤ 5.0%). The methodology was validated by comparing it to an HPLC-UV established methodology and was successfully applied for the determination of digoxin in pharmaceutical tablets and blood serum samples, showing a positive performance for these matrices.

Development of a novel direct compressible co-processed excipient and its application for formulation of Mirtazapine orally disintegrating tablets

INTRODUCTION

Orally disintegrating tablets (ODTs) are designed to dissolve in the oral cavity within 3 min, providing a convenient option for patients as they can be taken without water. Direct compression is the most common method used for ODTs formulations. However, the availability of single composite excipients with desirable characteristics such as good compressibility, fast disintegration, and a good mouthfeel suitable for direct compression is limited.

OBJECTIVE

This research was proposed to develop a co-processed excipient composed of xylitol, mannitol, and microcrystalline cellulose for the formulation of ODTs.

METHODS

A total of 11 formulations of co-processed excipients with different ratios of ingredients were prepared, which were then compressed into ODTs, and their characteristics were thoroughly examined. The primary focus was on evaluating the disintegration time and hardness of the tablets, as these factors are important in ensuring the ODTs meet the desired criteria. The model drug, Mirtazapine was then incorporated into the chosen optimized formulation.

RESULTS

The results showed that the formulation comprised of 10% xylitol, 10% mannitol and 80% microcrystalline cellulose demonstrated the fastest disintegration time (1.77 ± 0.119 min) and sufficient hardness (3.521 ± 0.143 kg) compared to the other formulations. Furthermore, the drug was uniformly distributed within the tablets and fully released within 15 min.

CONCLUSION

Therefore, the developed co-processed excipients show great potential in enhancing the functionalities of ODTs, offering a promising solution to improve the overall performance and usability of ODTs in various therapeutic applications.

Sodium Starch Glycolate (SSG) from Sago Starch (Metroxylon sago) as a Superdisintegrant: Synthesis and Characterization

The characteristics of sago starch exhibit remarkable resemblances to those of cassava, potato, and maize starches. This review intends to discuss and summarize the synthesis and characterization of sodium starch glycolate (SSG) from sago starch as a superdisintegrant from published journals using keywords in PubMed, Scopus, and ScienceDirect databases by Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA 2020). There are many methods for synthesizing sodium starch glycolate (SSG). Other methods may include the aqueous, extrusion, organic solvent slurry, and dry methods. Sago starch is a novel form of high-yield starch with significant development potential. After cross-linking, the phosphorus content of sago starch increases by approximately 0.3 mg/g, corresponding to approximately one phosphate ester group per 500 anhydroglucose units. The degree of substitution (DS) of sodium starch glycolate (SSG) from sago ranges from 0.25 to 0.30; in drug formulations, sodium starch glycolate (SSG) from sago ranges from 2% to 8% w/w. Higher levels of sodium starch glycolate (SSG) (2% and 4% w/w) resulted in shorter disintegration times (within 1 min). Sago starch is more swellable and less enzymatically digestible than pea and corn starch. These investigations demonstrate that sago starch is a novel form of high-yield starch with tremendous potential for novel development as superdisintegrant tablets and capsules.

A comprehensive review on pharmaceutical uses of plant-derived biopolysaccharides

Biopolysaccharides extracted from plants are mainly photosynthetic byproducts found in leaves, pods, stems, fruits, grains, seeds, corms, rhizomes, roots, bark exudates, and other plant parts. Recently, these plant-derived biopolysaccharides have received a great deal of attention as pharmaceutical excipients in a range of different dosage forms because of several key advantages, such as widespread accessibility from nature as plant-based sources are readily available, sustainable production, availability of easy and cost-effective extraction methodologies, aqueous solubility, swelling capability in the aqueous medium, non-toxicity, biodegradability, etc. The current review presents a comprehensive overview of the uses of plant-derived biopolysaccharides as effective pharmaceutical excipients in the formulations of different kinds of dosage forms, for example gels, pastes, films, emulsions, suspensions, capsules, tablets, nanoparticles, microparticles, beads, buccal formulations, transdermal formulations, ocular formulations, nasal formulations, etc.

Optimization of Pregelatinized Taro Boloso-I Starch as a Direct Compression Tablet Excipient

Background. Tablets are still the most preferred means of drug delivery. The search for new and improved direct compression tablet excipients is an area of research focus. This is because the direct compression method overcomes the drawbacks of granulation methods of tablet production. It exempts several treatment steps associated with the granulation methods. The requirements for the powders to be directly compressible include flowability, low friction tendency, compressibility, and fast disintegration capacity. Taro Boloso-I is a new variety of Colocasia esculenta (L. Schott) yielding 67% more than a previously reported variety (Godare) in Ethiopia. This study is aimed at enhancing the flowability while keeping the compressibility and compactibility of the pregelatinized Taro Boloso-I starch. Methods. Central composite design was used for the optimization of two factors which were the temperature and duration of pregelatinization against 4 responses. The responses were angle of repose, Hausner’s ratio, Heckel’s yield pressure, and tablet breaking force. Results and Discussions. An increase in the temperature resulted in decrease in both the angle of repose and the Hausner ratio and that of time decreased angle of repose as well. The Heckel yield pressure was observed to increase with increasing levels of both temperature and time. The pregelatinized starch prepared by heating 15% slurry of Taro Boloso-I starch at the pregelatinization temperature of 66.22°C for 20 min showed desired flow property and compressibility. Conclusions. Pregelatinized Taro Boloso-I starch could be regarded as a potential direct compression excipient in terms of flowability, compressibility, and compactibility. The PGTBIS could perform better as filler and binder in direct compression tablets than the Starch 1500® in terms of compactibility.