Enhanced Synaptic Properties in Biocompatible Casein Electrolyte via Microwave-Assisted Efficient Solution Synthesis

Multifunctional HfAlO thin film: Ferroelectric tunnel junction and resistive random access memory

This study presents findings indicating that the ferroelectric tunnel junction (FTJ) or resistive random-access memory (RRAM) in one cell can be intentionally selected depending on the application. The HfAlO film annealed at 700 °C shows stable FTJ characteristics and can be converted into RRAM by forming a conductive filament inside the same cell, that is, the process of intentionally forming a conductive filament is the result of defect generation and redistribution, and applying compliance current prior to a hard breakdown event of the dielectric film enables subsequent RRAM operation. The converted RRAM demonstrated good memory performance. Through current-voltage fitting, it was confirmed that the two resistance states of the FTJ and RRAM had different transport mechanisms. In the RRAM, the 1/f noise power of the high-resistance state (HRS) was about ten times higher than that of the low-resistance state (LRS). This is because the noise components increase due to the additional current paths in the HRS. The 1/f noise power according to resistance states in the FTJ was exactly the opposite result from the case of the RRAM. This is because the noise component due to the Poole-Frenkel emission is added to the noise component due to the tunneling current in the LRS. In addition, we confirmed the potentiation and depression characteristics of the two devices and further evaluated the accuracy of pattern recognition through a simulation by considering a dataset from the Modified National Institute of Standards and Technology.

Bio-based Pickering emulsifier from mangosteen residues-derived sodium caseinate grafted spherical cellulose nanocrystals: Stability, rheological properties and microstructure studies

This study focuses on the preparation of mangosteen rind-derived nanocellulose via green ascorbic acid hydrolysis. Subsequently, milk protein-grafted nanocellulose particles were developed as a renewable Pickering emulsifier for water-oil stabilization. The stabilizing efficiency of modified nanocellulose (NC-S) at different caseinate (milk protein) concentrations (1.5, 3.0, and 4.0 % w/v) was tested in a water-in-oil emulsion (W/O ratio of 40:60). At a concentration 3.0 % w/v of caseinate (3.0NC-S), the emulsion exhibited a stronger network of adsorption between water, Pickering emulsifier, and oil. This resulted in reduced oil droplet flocculation, increased stability over a longer period, and favorable emulsifying properties, as depicted in the creaming index profile, oil droplet distribution, and rheology analysis. Since 3.0NC-S demonstrated the best colloidal stability, further focus will be placed on its microstructural properties, comparing them with those of mangosteen rind (MG), cellulose, and nanocellulose (NC-L). The XRD profile indicated that both NC-L and NC-S possessed a cellulose nanocrystal structure characterized as type I beta with a high crystallinity index above 60 %. Morphology investigation shown that the NC-L present in the spherical shape of particles with nanosized ranging at diameters of 11.27 ± 0.50 nm and length 11.76 ± 0.46 nm, while modified NC-S showed increase sized at 14.26 ± 4.60 nm and length 14.96 ± 4.94 nm. The increment of particle sizes from NC-L to NC-S indicated 2.82 × 10-15 mg/m2 of surface protein coverage by caseinate functional groups.

Development of Salmon Sperm DNA/Regenerated Silk Bio-Based Films for Biomedical Studies on Human Keratinocyte HaCaT Cells under Solar Spectrum

In this study, we fabricated adhesive patches from silkworm-regenerated silk and DNA to safeguard human skin from the sun's rays. The patches are realized by exploiting the dissolution of silk fibers (e.g., silk fibroin (SF)) and salmon sperm DNA in formic acid and CaCl₂ solutions. Infrared spectroscopy is used to investigate the conformational transition of SF when combined with DNA; the results indicated that the addition of DNA provides an increase in the SF crystallinity. UV-Visible absorption and circular dichroism spectroscopy showed strong absorption in the UV region and the presence of B-form of DNA once dispersed in the SF matrix, respectively. Water absorption measurements as well as thermal dependence of water sorption and thermal analysis, suggested the stability of the fabricated patches. Biological results on cellular viability (MTT assay) of keratinocyte HaCaT cells after exposures to the solar spectrum showed that both SF and SF/DNA patches are photo-protective by increasing the cellular viability of keratinocytes after UV component exposure. Overall, these SF/DNA patches promise applications in wound dressing for practical biomedical purposes.