Is Steam Explosion a Promising Pretreatment for Acid Hydrolysis of Lignocellulosic Biomass?

Effects of steam explosion on raspberry leaf structure and the release of water-soluble nutrients and phenolics

Raspberry leaves were subjected to steam explosion at 0.5 and 1.0 MPa for 60-120 s, aiming to disrupt their physical and chemical structure and, consequently, promote the release of phenolic compounds into the leaf aqueous infusion. Under optimal condition of 1.0 MPa for 60 s, steam explosion led to a notable 23 % increase in total phenolic content, a 29 % elevation in ABTS radical scavenging capacity, and a 13 % rise in DPPH radical scavenging capacity of the aqueous infusion. Utilizing UHPLC-Q-TOF-MS/MS and UHPLC-QE-MS/MS techniques, respectively, a total of 39 phenolic compounds were identified from raspberry leaves, and the changes in the contents of the most important 11 species were analyzed following steam explosion. Through correlation analysis and considering the content of each phenolic compound, it was inferred that the heightened antioxidant capacity of the aqueous infusion primarily stemmed from a substantial increase in the release of ellagic acid after steam explosion.

Revolutionizing lignocellulosic biomass: A review of harnessing the power of ionic liquids for sustainable utilization and extraction

The potential for the transformation of lignocellulosic biomass into valuable commodities is rapidly growing through an environmentally sustainable approach to harness its abundance, cost-effectiveness, biodegradability, and environmentally friendly nature. Ionic liquids (ILs) have received considerable and widespread attention as a promising solution for efficiently dissolving lignocellulosic biomass. The fact that ILs can act as solvents and reagents contributes to their widespread recognition. In particular, ILs are desirable because they are inert, non-toxic, non-flammable, miscible in water, recyclable, thermally and chemically stable, and have low melting points and outstanding ionic conductivity. With these characteristics, ILs can serve as a reliable replacement for traditional biomass conversion methods in various applications. Thus, this comprehensive analysis explores the conversion of lignocellulosic biomass using ILs, focusing on main components such as cellulose, hemicellulose, and lignin. In addition, the effect of multiple parameters on the separation of lignocellulosic biomass using ILs is discussed to emphasize their potential to produce high-value products from this abundant and renewable resource. This work contributes to the advancement of green technologies, offering a promising avenue for the future of biomass conversion and sustainable resource management.

Steam explosion as sustainable biomass pretreatment technique for biofuel production: Characteristics and challenges

The biorefining process of lignocellulosic biomass has recently emerged as one of the most profitable biofuel production options. However, pretreatment is required to improve the recalcitrant lignocellulose's enzymatic conversion efficiency. Among biomass pretreatment methods, the steam explosion is an eco-friendly, inexpensive, and effective approach to pretreating biomass, significantly promoting biofuel production efficiency and yield. This review paper critically presents the steam explosion's reaction mechanism and technological characteristics for lignocellulosic biomass pretreatment. Indeed, the principles of steam explosion technology for lignocellulosic biomass pretreatment were scrutinized. Moreover, the impacts of process factors on pretreatment efficiency and sugar recovery for the following biofuel production were also discussed in detail. Finally, the limitations and prospects of steam explosion pretreatment were mentioned. Generally, steam explosion technology applications could bring great potential in pretreating biomass, although deeper studies are needed to deploy this method on industrial scales.

Modification of Bulk Density, Flow Property and Crystallinity of Microcrystalline Cellulose Prepared from Waste Cotton

The most affordable type of tablet is the immediately compressible tablet, which uses microcrystalline cellulose (MCC), a popular pharmaceutical excipient, as a filler or binder. To make it compatible with different active drugs and excipients, we tried to change some physical properties of the MCC. In the current study, we used a chelating agent to pretreat the waste cotton before pulping, bleaching, and finally, hydrochloric acid degradation with a concentration of 2N at 100 °C temperature for 20 min to prepare MCC. The prepared MCC was treated with different concentrations of sodium hydroxide at room temperature or at -20 °C followed by precipitation with hydrochloric acid or ethanol with complete washing with distilled water till neutralization. Evaluation of the degree of polymerization (DP) and FT-IR spectrum confirm the identity of the microcrystalline cellulose. The DP was found to be 216. The bulk density of the unmodified MCC was 0.21 while that of modified MCC varied from 0.253 to 0.594. The modified MCC powder showed good flow properties compared to the unmodified MCC as evaluated by the Hausner index, Carr's index and the angle of repose. The scanning electron microscopy (SEM) of the MCC revealed that the rod shape has been changed to an oval shape due to treatment with sodium hydroxide at -20 °C. The X-ray crystallographic (XRD) analysis indicated that the unmodified MCC and standard MCC showed the crystallinity index (CrI) value of 86.82% and 87.63%, respectively, while the value ranges from 80.18% to 60.7% among the modified MCC powder. The differences in properties of the MCC might be due to the variation of rearrangement of the cellulose chain among the MCC particles due to treatment with different concentrations of a base at different temperatures and precipitation environments. This has enabled us to prepare MCC with different properties which might be compatible with different drugs.

Apricot Seed Shells and Walnut Shells as Unconventional Sugars and Lignin Sources

The present study focuses on using apricot seeds shells and walnut shells as a potential renewable material for biorefinery in Ukraine. The goal of the research work was to determine the relationship between the chemical composition of solid residues from biomass after acid pretreatment with H₂SO₄, alkaline pretreatment with NaOH, and a steam explosion pretreatment and the recovery of sugars and lignin after further enzymatic hydrolysis with the application of an industrial cellulase Cellic CTec2. Apricot seeds shells and walnut shells consist of lots of cellulose (35.01 and 24.19%, respectively), lignin (44.55% and 44.63%, respectively), hemicelluloses (10.77% and 26.68%, respectively), and extractives (9.97% and 11.41%, respectively), which affect the efficiency of the bioconversion of polysaccharides to sugars. The alkaline pretreatment was found to be more efficient in terms of glucose yield in comparison with that of acid and steam explosion, and the maximum enzymatic conversions of cellulose reached were 99.7% and 94.6% for the solids from the apricot seeds shells and the walnut shells, respectively. The maximum amount of lignin (82%) in the residual solid was obtained during the processing of apricot seed shells submitted to the acid pretreatment. The amount of lignin in the solids interferes with the efficiency of enzymatic hydrolysis. The results pave the way for the efficient and perspective utilization of shells through the use of inexpensive, simple and affordable chemical technologies, obtaining value-added products, and thus, reducing the amount of environmental pollution (compared to the usual disposal practice of direct burning) and energy and material external dependency (by taking advantage of these renewable, low-cost materials).

Special Issue: Biochemical and Thermochemical Conversion Processes of Lignocellulosic Biomass Fractionated Streams

Global consumption of materials such as forest resources, fossil fuels, earth metals and minerals are expected to double in the next 30 years, while annual waste production is estimated to increase by approximately 70% by 2050 [...]