Advancement of an Infra-Red Technique for Whole-Field Concentration Measurements in Fluidized Beds

Experimental Quantification of Gas Dispersion in 3D-Printed Logpile Structures Using a Noninvasive Infrared Transmission Technique

3D-printed catalyst structures have the potential to broaden reactor operating windows. However, the hydrodynamic aspects associated with these novel catalyst structures have not yet been quantified in detail. This work applies a recently introduced noninvasive, instantaneous, whole-field concentration measurement technique based on infrared transmission to quantify the rate of transverse gas dispersion in 3D-printed logpile structures. Twenty-two structural variations have been investigated at various operating conditions, and the measured transverse gas dispersion has been correlated to the Péclet number and the structures’ porosity and feature size. It is shown that staggered configurations of these logpile structures offer significantly more tunability of the dispersion behavior compared to straight structures. The proposed correlations can be used to facilitate considerations of reactor design and operating windows.

A Simplified Numerical Approach to Examine the Sensitivity of Two-Electrode Capacitance Sensor Orientation to Capture Different Gas-Liquid Flow Patterns in a Small Circular Pipe

This work involved the simulation of both a multiphase gas–liquid flow and the electromagnetic field representing a two-electrode capacitance sensor in a circular pipe. The simulation investigates in particular the sensitivity of the sensor orientation around the pipe (i.e., top-to-bottom or side-to-side) that best capture the induced flow patterns. The presented numerical work is a simplified simulation by COMSOL multi-physics which was validated by a systematic and an extensive experimental work, using (a) a specially designed simple capacitance sensor (i.e., concave two electrodes), (b) different gas–liquid superficial velocity combinations, (c) different flow section inclinations, and (d) high-speed camera images. The numerical modelling capacitance values were validated against the experimentally measured values which shows a satisfactory level of agreement with a deviation of less than ±2%. The quantity of finite points was between 280,000 and 340,000, which was influenced by the simulated flow pattern. The simulated cases captured the generated flow patterns and their variation inside the pipe, which was in a good agreement when compared to the experimental work as time-dependent values. It was found that the best orientation for the utilized two-electrode capacitance sensor was the top-to-bottom configuration. This is because the sensor’s electrical field distribution was more sensitive, and capable of detecting a greater range of capacitance values. The sensitivity of the top-to-bottom configuration was 1.25–1.64 times greater than that of the side-to-side configuration. Therefore, for design purposes and performance optimization, it is recommended to use the top-to-bottom configuration.