Two-Wired Active Spring-Loaded Dry Electrodes for EEG Measurements

Recent progress on smart lower prosthetic limbs: a comprehensive review on using EEG and fNIRS devices in rehabilitation

The global rise in lower limb amputation cases necessitates advancements in prosthetic limb technology to enhance the quality of life for affected patients. This review paper explores recent advancements in the integration of EEG and fNIRS modalities for smart lower prosthetic limbs for rehabilitation applications. The paper synthesizes current research progress, focusing on the synergy between brain-computer interfaces and neuroimaging technologies to enhance the functionality and user experience of lower limb prosthetics. The review discusses the potential of EEG and fNIRS in decoding neural signals, enabling more intuitive and responsive control of prosthetic devices. Additionally, the paper highlights the challenges, innovations, and prospects associated with the incorporation of these neurotechnologies in the field of rehabilitation. The insights provided in this review contribute to a deeper understanding of the evolving landscape of smart lower prosthetic limbs and pave the way for more effective and user-friendly solutions in the realm of neurorehabilitation.

Active Claw-Shaped Dry Electrodes for EEG Measurement in Hair Areas

EEG, which can provide brain alteration information via recording the electrical activity of neurons in the cerebral cortex, has been widely used in neurophysiology. However, conventional wet electrodes in EEG monitoring typically suffer from inherent limitations, including the requirement of skin pretreatment, the risk of superficial skin infections, and signal performance deterioration that may occur over time due to the air drying of the conductive gel. Although the emergence of dry electrodes has overcome these shortcomings, their electrode-skin contact impedance is significantly high and unstable, especially in hair-covered areas. To address the above problems, an active claw-shaped dry electrode is designed, moving from electrode morphological design, slurry preparation, and coating to active electrode circuit design. The active claw-shaped dry electrode, which consists of a claw-shaped electrode and active electrode circuit, is dedicated to offering a flexible solution for elevating electrode fittings on the scalp in hair-covered areas, reducing electrode-skin contact impedance and thus improving the quality of the acquired EEG signal. The performance of the proposed electrodes was verified by impedance, active electrode circuit, eyes open-closed, steady-state visually evoked potential (SSVEP), and anti-interference tests, based on EEG signal acquisition. Experimental results show that the proposed claw-shaped electrodes (without active circuit) can offer a better fit between the scalp and electrodes, with a low electrode-skin contact impedance (18.62 KΩ@1 Hz in the hairless region and 122.15 KΩ@1 Hz in the hair-covered region). In addition, with the active circuit, the signal-to-noise ratio (SNR) of the acquiring EEG signal was improved and power frequency interference was restrained, therefore, the proposed electrodes can yield an EEG signal quality comparable to wet electrodes.

Flexible Electrodes for Brain-Computer Interface System

Brain-computer interface (BCI) has been the subject of extensive research recently. Governments and companies have substantially invested in relevant research and applications. The restoration of communication and motor function, the treatment of psychological disorders, gaming, and other daily and therapeutic applications all benefit from BCI. The electrodes hold the key to the essential, fundamental BCI precondition of electrical brain activity detection and delivery. However, the traditional rigid electrodes are limited due to their mismatch in Young's modulus, potential damages to the human body, and a decline in signal quality with time. These factors make the development of flexible electrodes vital and urgent. Flexible electrodes made of soft materials have grown in popularity in recent years as an alternative to conventional rigid electrodes because they offer greater conformance, the potential for higher signal-to-noise ratio (SNR) signals, and a wider range of applications. Therefore, the latest classifications and future developmental directions of fabricating these flexible electrodes are explored in this paper to further encourage the speedy advent of flexible electrodes for BCI. In summary, the perspectives and future outlook for this developing discipline are provided.

In vivo experimental validation of detection of gastric slow waves using a flexible multichannel electrogastrography sensor linear array

Background

Cutaneous electrogastrography (EGG) is a non-invasive technique that detects gastric bioelectrical slow waves, which in part govern the motility of the stomach. Changes in gastric slow waves have been associated with a number of functional gastric disorders, but to date accurate detection from the body-surface has been limited due to the low signal-to-noise ratio. The main aim of this study was to develop a flexible active-electrode EGG array. Methods: Two Texas Instruments CMOS operational amplifiers: OPA2325 and TLC272BID, were benchtop tested and embedded in a flexible linear array of EGG electrodes, which contained four recording electrodes at 20-mm intervals. The cutaneous EGG arrays were validated in ten weaner pigs using simultaneous body-surface and serosal recordings, using the Cyton biosensing board and ActiveTwo acquisition systems. The serosal recordings were taken using a passive electrode array via surgical access to the stomach. Signals were filtered and compared in terms of frequency, amplitude, and phase-shift based on the classification of propagation direction from the serosal recordings. Results: The data were compared over 709 cycles of slow waves, with both active cutaneous EGG arrays demonstrating comparable performance. There was an agreement between frequencies of the cutaneous EGG and serosal recordings (3.01 ± 0.03 vs 3.03 ± 0.05 cycles per minute; p = 0.75). The cutaneous EGG also demonstrated a reduction in amplitude during abnormal propagation of gastric slow waves (310 ± 50 µV vs 277 ± 9 µV; p < 0.01), while no change in phase-shift was observed (1.28 ± 0.09 s vs 1.40 ± 0.10 s; p = 0.36). Conclusion: A sparse linear cutaneous EGG array was capable of reliably detecting abnormalities of gastric slow waves. For more accurate characterization of gastric slow waves, a two-dimensional body-surface array will be required.

Review of semi-dry electrodes for EEG recording

Developing reliable and user-friendly electroencephalography (EEG) electrodes remains a challenge for emerging real-world EEG applications. Classic wet electrodes are the gold standard for recording EEG; however, they are difficult to implement and make users uncomfortable, thus severely restricting their widespread application in real-life scenarios. An alternative is dry electrodes, which do not require conductive gels or skin preparation. Despite their quick setup and improved user-friendliness, dry electrodes still have some inherent problems (invasive, relatively poor signal quality, or sensitivity to motion artifacts), which limit their practical utilization. In recent years, semi-dry electrodes, which require only a small amount of electrolyte fluid, have been successfully developed, combining the advantages of both wet and dry electrodes while addressing their respective drawbacks. Semi-dry electrodes can collect reliable EEG signals comparable to wet electrodes. Moreover, their setup is as fast and convenient similar to that of dry electrodes. Hence, semi-dry electrodes have shown tremendous application prospects for real-world EEG acquisition. Herein, we systematically summarize the development, evaluation methods, and practical design considerations of semi-dry electrodes. Some feasible suggestions and new ideas for the development of semi-dry electrodes have been presented. This review provides valuable technical support for the development of semi-dry electrodes toward emerging practical applications.

Validating a LEGO-Like EEG Headset for a Simultaneous Recording of Wet- and Dry-Electrode Systems During Treadmill Walking

Recent mobile and wearable electroencephalogram (EEG)-sensing technologies have been demonstrated to be effective for measuring rapid changes of spatio-spectral EEG correlates of brain and cognitive functions of interest with more ecologically natural settings. However, commercial EEG products are available commonly with a fixed headset in terms of the number of electrodes and their locations to the scalp practically constrains their generalizability for different demands of EEG and brain-computer interface (BCI) study. While most progress focused on innovation of sensing hardware and conductive electrodes, less effort has been done to renovate mechanical structures of an EEG headset. Recently, an electrode-holder assembly infrastructure was designed to be capable of unlimitedly (re)assembling a desired n-channel electrode headset through a set of primary elements (i.e., LEGO-like headset). The present work empirically demonstrated one of its advantage regarding coordinating the homogeneous or heterogeneous sensors covering the target regions of the brain. Towards this objective, an 8-channel LEGO headset was assembled to conduct a simultaneous event-related potential (ERP) recording of the wet- and dry-electrode EEG systems and testify their signal quality during standing still versus treadmill walking. The results showed that both systems returned a comparable P300 signal-to-noise ratio (SNR) for standing, yet the dry system was more susceptible to the movement artifacts during slow walking. The LEGO headset infrastructure facilitates a desired benchmark study, e.g., comparing the signal quality of different electrodes on non-stationary subjects conducted in this work, or a specific EEG and BCI application.