Characteristics and Performances of a Nanostructured Material for Passive Samplers of Gaseous Hg

Optimization and application of passive air sampling method for gaseous elemental mercury in Ulsan, South Korea

We compared uptake rates and concentrations of gaseous elemental mercury (GEM) by passive sampling conditions and investigated the spatial distribution of GEM in Ulsan, the largest industrial city in South Korea. For the optimization of sampling conditions, two outer sampling containers (cylindrical polyethylene terephthalate and two stainless steel bowls), two different sulfur contents of the sorbent (16.3% and 26.3%), and three sampling periods (1, 2, and 3 months) were considered. The uptake rates of GEM were not statistically different by the sampling container, but they were increased with the sulfur contents of activated carbon. A sampling condition using two stainless bowls and lower sulfur contents of activated carbon for 2-3 months was preferred with the highest precision of GEM concentrations. With the same method, passive air samples were collected for 3 months in duplicate from 10 sites in Ulsan. The concentrations of GEM ranged from 3.13 to 11.2 ng/m³ (mean 4.65 ng/m³), and the highest concentration was measured at a non-ferrous industrial complex. A zinc smelter in the non-ferrous industrial complex was identified as a major mercury source in Ulsan. This study is the first passive air sampling study investigating the spatial distributions of GEM in different types of industrial areas as well as residential areas of Ulsan.

Pocket Mercury-Vapour Detection System Employing a Preconcentrator Based on Au-TiO2 Nanomaterials

In environments polluted by mercury vapors that are potentially harmful to human health, there is a need to perform rapid surveys in order to promptly identify the sources of emission. With this aim, in this work, a low cost, pocket-sized portable mercury measurement system, with a fast response signal is presented. It consists of a preconcentrator, able to adsorb and subsequently release the mercury vapour detected by a quartz crystal microbalance (QCM) sensor. The preconcentrator is based on an adsorbing layer of titania/gold nanoparticles (TiO₂NP/AuNPs), deposited on a micro-heater that acts as mercury thermal desorption. For the detection of the released mercury vapour, gold electrodes QCM (20 MHz) have been used. The experimental results, performed in simulated polluted mercury-vapour environments, showed a detection capability with a prompt response. In particular, frequency shifts (-118 Hz ± 2 Hz and -30 Hz ± 2 Hz) were detected at concentrations of 65 µg/m³ Hg⁰ and 30 µg/m³ Hg⁰, with sampling times of 60 min and 30 min, respectively. A system limit of detection (LOD) of 5 µg/m³ was evaluated for the 30 min sampling time.