High Acoustic Impedance and Attenuation Backing for High-Frequency Focused P(VDF-TrFE)-Based Transducers

Broad bandwidth and excellent thermal stability in BiScO3-PbTiO3 high-temperature ultrasonic transducer for non-destructive testing

High-temperature ultrasonic transducer (HTUT) is essential for non-destructive testing (NDT) in harsh environments. In this paper, a HTUT based on BiScO3-PbTiO3 (BS-PT) piezoelectric ceramics was developed, and the effect of different backing layers on its bandwidth were analyzed. The HTUT demonstrates a broad bandwidth and excellent thermal stability with operation temperature up to 400 °C. By using a 10 mm thick porous alumina backing layer, the HTUT achieves a broad -6 dB bandwidth of 100 %, which is about 4 times superior to the transducer with an air backing layer. The center frequency (fc) of the HTUT remains stable with fluctuations of less than 10 % across the temperature range from room temperature to 400 °C. The HTUT successfully detected simulated defects in pulse-echo mode for NDT over 200 °C. This research not only advances high-temperature ultrasonic transducer technology but also expands the NDT applications in harsh environmental conditions.

Development of an Artificial Soft Solid Gel Using Gelatin Material for High-Quality Ultrasound Diagnosis

For ultrasound diagnosis, a gel is applied to the skin. Ultrasound gel serves to block air exposure and match impedance between the skin and the probe, enhancing imaging efficiency. However, if use of the ultrasound gel exceeds a certain period of time, it may dry out and be exposed to air, causing impedance mismatch and reducing imaging resolution. In such cases, the use of a soft, solid gel proves advantageous, as it can be employed for an extended period without succumbing to the drying phenomenon and can be reused after disinfection. Its soft consistency ensures excellent skin adhesion. Our soft solid gel demonstrated approximately 1.2 times better performance than water, silicone, and traditional ultrasound gels. When comparing the dimensions of grayscale, dead zone, vertical, and horizontal regions, the measurements for the traditional ultrasound gel were 93.79 mm, 45.32 mm, 103.13 mm, 83.86 mm, and 83.86 mm, respectively. In contrast, the proposed soft solid gel exhibited dimensions of 105.64 mm, 34.48 mm, 141.1 mm, and 102.8 mm.