1
|
Moura PC, Pivetta TP, Vassilenko V, Ribeiro PA, Raposo M. Graphene Oxide Thin Films for Detection and Quantification of Industrially Relevant Alcohols and Acetic Acid. SENSORS (BASEL, SWITZERLAND) 2023; 23:462. [PMID: 36617058 PMCID: PMC9823657 DOI: 10.3390/s23010462] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Figures] [Subscribe] [Scholar Register] [Received: 11/30/2022] [Revised: 12/28/2022] [Accepted: 12/29/2022] [Indexed: 06/17/2023]
Abstract
Industrial environments are frequently composed of potentially toxic and hazardous compounds. Volatile organic compounds (VOCs) are one of the most concerning categories of analytes commonly existent in the indoor air of factories' facilities. The sources of VOCs in the industrial context are abundant and a vast range of human health conditions and pathologies are known to be caused by both short- and long-term exposures. Hence, accurate and rapid detection, identification, and quantification of VOCs in industrial environments are mandatory issues. This work demonstrates that graphene oxide (GO) thin films can be used to distinguish acetic acid, ethanol, isopropanol, and methanol, major analytes for the field of industrial air quality, using the electronic nose concept based on impedance spectra measurements. The data were treated by principal component analysis. The sensor consists of polyethyleneimine (PEI) and GO layer-by-layer films deposited on ceramic supports coated with gold interdigitated electrodes. The electrical characterization of this sensor in the presence of the VOCs allows the identification of acetic acid in the concentration range from 24 to 120 ppm, and of ethanol, isopropanol, and methanol in a concentration range from 18 to 90 ppm, respectively. Moreover, the results allows the quantification of acetic acid, ethanol, and isopropanol concentrations with sensitivity values of (3.03±0.12)∗104, (-1.15±0.19)∗104, and (-1.1±0.50)∗104 mL-1, respectively. The resolution of this sensor to detect the different analytes is lower than 0.04 ppm, which means it is an interesting sensor for use as an electronic nose for the detection of VOCs.
Collapse
|
2
|
Haug H, Klein L, Sauerwald T, Poelke B, Beauchamp J, Roloff A. Sampling Volatile Organic Compound Emissions from Consumer Products: A Review. Crit Rev Anal Chem 2022:1-22. [PMID: 36306209 DOI: 10.1080/10408347.2022.2136484] [Citation(s) in RCA: 4] [Impact Index Per Article: 2.0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 10/31/2022]
Abstract
Volatile organic compounds (VOCs) are common constituents of many consumer products. Although many VOCs are generally considered harmless at low concentrations, some compound classes represent substances of concern in relation to human (inhalation) exposure and can elicit adverse health effects, especially when concentrations build up, such as in indoor settings. Determining VOC emissions from consumer products, such as toys, utensils or decorative articles, is of utmost importance to enable the assessment of inhalation exposure under real-world scenarios with respect to consumer safety. Due to the diverse sizes and shapes of such products, as well as their differing uses, a one-size-fits-all approach for measuring VOC emissions is not possible, thus, sampling procedures must be chosen carefully to best suit the sample under investigation. This review outlines the different sampling approaches for characterizing VOC emissions from consumer products, including headspace and emission test chamber methods. The advantages and disadvantages of each sampling technique are discussed in relation to their time and cost efficiency, as well as their suitability to realistically assess VOC inhalation exposures.
Collapse
Affiliation(s)
- Helen Haug
- Department of Sensory Analytics and Technologies, Fraunhofer Institute for Process Engineering and Packaging IVV, Freising, Germany
- Department of Chemistry and Pharmacy, Friedrich-Alexander-Universität Erlangen-Nürnberg, Chair of Aroma and Smell Research, Erlangen, Germany
| | - Luise Klein
- Department of Chemical and Product Safety, German Federal Institute for Risk Assessment (BfR), Berlin, Germany
| | - Tilman Sauerwald
- Department of Sensory Analytics and Technologies, Fraunhofer Institute for Process Engineering and Packaging IVV, Freising, Germany
| | - Birte Poelke
- Department of Chemical and Product Safety, German Federal Institute for Risk Assessment (BfR), Berlin, Germany
| | - Jonathan Beauchamp
- Department of Sensory Analytics and Technologies, Fraunhofer Institute for Process Engineering and Packaging IVV, Freising, Germany
| | - Alexander Roloff
- Department of Chemical and Product Safety, German Federal Institute for Risk Assessment (BfR), Berlin, Germany
| |
Collapse
|
3
|
Halios CH, Landeg-Cox C, Lowther SD, Middleton A, Marczylo T, Dimitroulopoulou S. Chemicals in European residences - Part I: A review of emissions, concentrations and health effects of volatile organic compounds (VOCs). THE SCIENCE OF THE TOTAL ENVIRONMENT 2022; 839:156201. [PMID: 35623519 DOI: 10.1016/j.scitotenv.2022.156201] [Citation(s) in RCA: 29] [Impact Index Per Article: 14.5] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Subscribe] [Scholar Register] [Received: 03/29/2022] [Revised: 05/16/2022] [Accepted: 05/20/2022] [Indexed: 06/15/2023]
Abstract
One of the more important classes of potentially toxic indoor air chemicals are the Volatile Organic Compounds (VOCs). However, due to a limited understanding of the relationships between indoor concentrations of individual VOCs and health outcomes, there are currently no universal health-based guideline values for VOCs within Europe including the UK. In this study, a systematic search was conducted designed to capture evidence on concentrations, emissions from indoor sources, and health effects for VOCs measured in European residences. We identified 65 individual VOCs, and the most commonly measured were aromatic hydrocarbons (14 chemicals), alkane hydrocarbons (9), aldehydes (8), aliphatic hydrocarbons (5), terpenes (6), chlorinated hydrocarbons (4), glycol and glycol ethers (3) and esters (2). The pathway of interest was inhalation and 8 individual aromatic hydrocarbons, 7 alkanes and 6 aldehydes were associated with respiratory health effects. Members of the chlorinated hydrocarbon family were associated with cardiovascular neurological and carcinogenic health effects and some were irritants as were esters and terpenes. Eight individual aromatic hydrocarbons, 7 alkanes and 6 aldehydes identified in European residences were associated with respiratory health effects. Of the 65 individual VOCs, 52 were from sources associated with building and construction materials (e.g. brick, wood products, adhesives and materials for flooring installation etc.), 41 were linked with consumer products (passive, electric and combustible air fresheners, hair sprays, deodorants) and 9 VOCs were associated with space heating, which may reflect the relatively small number of studies discussing emissions from this category of sources. A clear decrease in concentrations of formaldehyde was observed over the last few years, whilst acetone was found to be one of the most abundant but underreported species. A new approach based on the operational indoor air quality surveillance will both reveal trends in known VOCs and identify new compounds.
Collapse
Affiliation(s)
- Christos H Halios
- Air Quality & Public Health Group, Environmental Hazards and Emergencies Department, Radiation, Chemicals and Environmental Hazards, Science Group, UK Health Security Agency, Harwell Science and Innovation Campus, Chilton, UK
| | - Charlotte Landeg-Cox
- Air Quality & Public Health Group, Environmental Hazards and Emergencies Department, Radiation, Chemicals and Environmental Hazards, Science Group, UK Health Security Agency, Harwell Science and Innovation Campus, Chilton, UK
| | - Scott D Lowther
- Air Quality & Public Health Group, Environmental Hazards and Emergencies Department, Radiation, Chemicals and Environmental Hazards, Science Group, UK Health Security Agency, Harwell Science and Innovation Campus, Chilton, UK
| | - Alice Middleton
- Air Quality & Public Health Group, Environmental Hazards and Emergencies Department, Radiation, Chemicals and Environmental Hazards, Science Group, UK Health Security Agency, Harwell Science and Innovation Campus, Chilton, UK
| | - Tim Marczylo
- Toxicology Department, Radiation, Chemicals and Environmental Hazards, Science Group, UK Health Security Agency, Harwell Science and Innovation Campus, Chilton, UK
| | - Sani Dimitroulopoulou
- Air Quality & Public Health Group, Environmental Hazards and Emergencies Department, Radiation, Chemicals and Environmental Hazards, Science Group, UK Health Security Agency, Harwell Science and Innovation Campus, Chilton, UK.
| |
Collapse
|
4
|
Glossiness Evaluation of Coated Wood Surfaces as Function of Varnish Type and Exposure to Different Conditions. COATINGS 2021. [DOI: 10.3390/coatings11050558] [Citation(s) in RCA: 12] [Impact Index Per Article: 4.0] [Reference Citation Analysis] [Abstract] [Track Full Text] [Subscribe] [Scholar Register] [Indexed: 11/16/2022]
Abstract
The objective of this study was to evaluate the glossiness of black alder wood (Alnus glutinosa L.) samples coated with two varnish types as a function of exposure to dry heat and artificial aging. The chemical resistance of the coated samples to cold liquids was also evaluated. Based on the findings in this work, it appears that the varnish types and their structural differences influenced the overall glossiness of the coated samples. The UV varnish exhibited higher gloss values than those coated with the water-borne product within the range of silky gloss and silky matte grades. The heat exposure influenced the surface glossiness of the UV-coated samples more than the samples coated with water-borne varnish. The overall gloss values of the samples decreased with the exposure time to artificial aging, resulting in no layer cracks. The cold household liquids left less visible traces on the surfaces and alcohol was found to be the strongest agent. This study could have practical applications in the furniture industry to produce value-added furniture units according to their specific conditions of indoor use.
Collapse
|
5
|
Breath Analysis: Comparison among Methodological Approaches for Breath Sampling. Molecules 2020; 25:molecules25245823. [PMID: 33321824 PMCID: PMC7763204 DOI: 10.3390/molecules25245823] [Citation(s) in RCA: 23] [Impact Index Per Article: 5.8] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Download PDF] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 05/28/2020] [Revised: 12/04/2020] [Accepted: 12/07/2020] [Indexed: 12/20/2022] Open
Abstract
Despite promising results obtained in the early diagnosis of several pathologies, breath analysis still remains an unused technique in clinical practice due to the lack of breath sampling standardized procedures able to guarantee a good repeatability and comparability of results. The most diffuse on an international scale breath sampling method uses polymeric bags, but, recently, devices named Mistral and ReCIVA, able to directly concentrate volatile organic compounds (VOCs) onto sorbent tubes, have been developed and launched on the market. In order to explore performances of these new automatic devices with respect to sampling in the polymeric bag and to study the differences in VOCs profile when whole or alveolar breath is collected and when pulmonary wash out with clean air is done, a tailored experimental design was developed. Three different breath sampling approaches were compared: (a) whole breath sampling by means of Tedlar bags, (b) the end-tidal breath collection using the Mistral sampler, and (c) the simultaneous collection of the whole and alveolar breath by using the ReCIVA. The obtained results showed that alveolar fraction of breath was relatively less affected by ambient air (AA) contaminants (p-values equal to 0.04 for Mistral and 0.002 for ReCIVA Low) with respect to whole breath (p-values equal to 0.97 for ReCIVA Whole). Compared to Tedlar bags, coherent results were obtained by using Mistral while lower VOCs levels were detected for samples (both breath and AA) collected by ReCIVA, likely due to uncorrected and fluctuating flow rates applied by this device. Finally, the analysis of all data also including data obtained by explorative analysis of the unique lung cancer (LC) breath sample showed that a clean air supply might determine a further confounding factor in breath analysis considering that lung wash-out is species-dependent.
Collapse
|