Removal of Cd(II) from Water by HPEI Modified Humin

Hyperbranched-Polyethylenimine-Functionalized Coal Fly Ash as an Adsorbent for the Removal of Hexavalent Chromium and Reuse as a Dye Photocatalyst

Coal fly ash (CFA) has been extensively researched as an adsorbent for heavy metals, but its application is limited by its low adsorption capacity. The modification of CFA with hyperbranched polymers results in improved adsorption capacities. Hyperbranched polyethylenimine (HPEI) is a hyperbranched polymer containing NH2 groups that can bind with heavy metal ions through complexation or electrostatic interactions. In this study, CFA-HPEI adsorbents with various HPEI loadings (1-5%) were prepared and evaluated for the removal of Cr(VI). The successful incorporation of HPEI onto CFA was confirmed using Fourier transform infrared, elemental analysis, and X-ray photoelectron spectroscopy (XPS). The 3% CFA-HPEI loaded adsorbent resulted in optimum results when the effect of pH and adsorbent dosage was studied. The pseudo-second-order kinetics model best described the adsorption kinetics at an initial concentration of 20 mg/L. The Freundlich adsorption isotherm model best fitted the equilibrium adsorption data with a maximum adsorption capacity of 85.93 mg/g. The Cr-loaded adsorbent was reused as a photocatalyst to degrade methylene blue (MB) in the presence of visible light. The loaded adsorbent degraded 98.9% of MB (5 mg/L) within 180 min and was accompanied by compounds with m/z of 173 and 234, corresponding to the intermediate degradation of Azure A. The XPS analysis confirmed the coexistence of Cr(III) and Cr(VI) on the surface of the adsorbent. In addition, the loaded adsorbent exhibited good stability following MB degradation with no structural changes observed. Thus, CFA-HPEI adsorbents can be utilized as low-cost adsorbents for the remediation of toxic Cr(VI) from water and wastewater. The Cr-loaded CFA-HPEI adsorbent can be effectively reused as a photocatalyst, thus reducing environmental pollution.

Preparation and adsorption properties of hyperbranched polyethyleneimine-cellulose nanofiber aerogel

A novel cellulose-based aerogel was prepared by a chemical cross-linking reaction and hydrogen bonding between cellulose nanofibers (CNF), polyethylene glycol diglycidyl ether (PEGDE), and hyperbranched polyethyleneimine (HPEI).

Remediation Techniques for Cadmium-Contaminated Dredged River Sediments after Land Disposal

This paper examines the remediation techniques of cadmium (Cd)-contaminated dredged river sediments after land disposal in a city in East China. Three remediation techniques, including stabilization, soil leaching, and phytoremediation, are compared by analyzing the performance of the techniques for Cd-contaminated soil remediation. The experimental results showed that the stabilization technique reduced the leaching rate of soil Cd from 33.3% to 14.3%, thus effectively reducing the biological toxicity of environmental Cd, but the total amount of Cd in soil did not decrease. Leaching soil with citric acid and oxalic acid achieved Cd removal rates of 90.1% and 92.4%, respectively. Compared with these two remediation techniques, phytoremediation was more efficient and easier to implement and had less secondary pollution, but it took more time, usually several years. In this study, these three remediation techniques were analyzed and discussed from technical, economic, and environmental safety perspectives by comprehensively considering the current status and future plans of the study site. Soil leaching was found to be the best technique for timely treatment of Cd contamination in dredged river sediments after land disposal.