Multilayer WO3/BiVO4 Photoanodes for Solar-Driven Water Splitting Prepared by RF-Plasma Sputtering

Promoting the Photoelectrochemical Properties of BiVO4 Photoanode via Dual Modification with CdS Nanoparticles and NiFe-LDH Nanosheets

Bismuth vanadate (BiVO4) has long been considered a promising photoanode material for photoelectrochemical (PEC) water splitting. Despite its potential, significant challenges such as slow surface water evolution reaction (OER) kinetics, poor carrier mobility, and rapid charge recombination limit its application. To address these issues, a triadic photoanode has been fabricated by sequentially depositing CdS nanoparticles and NiFe-layered double hydroxide (NiFe-LDH) nanosheets onto BiVO4, creating a NiFe-LDH/CdS/BiVO4 composite. This newly engineered photoanode demonstrates a photocurrent density of 3.1 mA cm-2 at 1.23 V vs. RHE in 0.1 M KOH under AM 1.5 G illumination, outperforming the singular BiVO4 photoanode by a factor of 5.8 and the binary CdS/BiVO4 and NiFe-LDH/BiVO4 photoanodes by factors of 4.9 and 4.3, respectively. Furthermore, it exhibits significantly higher applied bias photon-to-current efficiency (ABPE) and incident photon-to-current efficiency (ICPE) compared to pristine BiVO4 and its binary counterparts. This enhancement in PEC performance is ascribed to the formation of a CdS/BiVO4 heterojunction and the presence of a NiFe-LDH OER co-catalyst, which synergistically facilitate charge separation and transfer efficiencies. The findings suggest that dual modification of BiVO4 with CdS and NiFe-LDH is a promising approach to enhance the efficiency of photoanodes for PEC water splitting.

Boosting the Photoactivity of BiVO4 Photoanodes by a ZnCoFe-LDH Thin Layer for Water Oxidation

Monoclinic bismuth vanadate (BiVO₄ ) has been used as an efficient photoanode material for photoelectrochemical water oxidation owing to its suitable band gap and nontoxicity. Nevertheless, the practical application of BiVO₄ photoanode has been severely limited by the surface charge recombination and sluggish kinetic, which leads to the obtained photoactivity of BiVO₄ is much lower than its theoretical value. In this case, ZnCoFe-LDH thin layer is conformally decorated on the porous BiVO₄ photoanode through a simple electrodeposition process. The results show that a boosted photoactivity and a remarkably enhanced photocurrent density (3.43 mA cm^-2 at 1.23 V_RHE ) are attained for BiVO₄ /ZnCoFe-LDH. In addition, the optimized BiVO₄ /ZnCoFe-LDH photoanode exhibits significant negative shift in the onset potential (0.51 V_RHE to 0.21 V_RHE ), promotes charge separation efficiency (49.3% to 60.4% in the bulk, 29.6% to 61.9% on the surface at 1.23 V_RHE ) and enhanced IPCE efficiency (25.5% to 54.7% at 425 nm) compared with that of bare BiVO₄ photoanode. It is demonstrated that the boosted photoactivity of BiVO₄ /ZnCoFe-LDH photoanode is mainly ascribed to the synergy effects of the formation of p-n heterojunction between ZnCoFe-LDH and BiVO₄ to accelerate the photogenerated charge transfer and separation, broaden light absorption, as well as promote the surface water oxidation kinetics.

Nanostructured Magnéli-Phase W18O49 Thin Films for Photoelectrochemical Water Splitting

Converting water into hydrogen through the photo-electrochemical (PEC) process is one of the most exciting approaches in this field, and there is a quest to design or search for new electro-photo-catalytic materials. In this work, simple steps for fabrication and transformation of metallic tungsten thin film into the photo-active Magnéli-phase (W18O49) of tungsten oxide thin film is demonstrated. The post-annealing temperature has a significant impact on the phase evolution of tungsten film into W18O49. The film thickness of W18O49 is controlled by controlling the sputtering time (or deposition time) of W film. The PEC performance of the as-prepared electrodes is evaluated by monitoring the water oxidation reaction under visible radiation. The PEC findings reveal a correlation between PEC performance and phase, morphology, and thickness of the film. The as-derived W18O49 can efficiently catalyze the water oxidation reaction at neutral solution pH, generating 0.6 and 1.4 mA cm−1 photo-current at 0.6 and 0.8 V vs. Saturated calomel electrode (SCE), respectively, in addition to excellent stability. The electrical conductivity and the charge transfer kinetics are investigated employing the electrochemical impedance spectroscopic (EIS) technique.