Swine Small Intestine Sealing Performed by Different Vessel Sealing Devices: Ex-Vivo Test

Ex vivo evaluation of a technique for equine jejunocecal anastomosis using radiofrequency thermofusion and a Cushing oversew

OBJECTIVE

To describe a technique for a side-to-side jejunocecal anastomosis in horses using radiofrequency thermofusion (TF) of the intestines supported by a Cushing oversew and to compare this anastomosis to handsewn and stapled techniques.

STUDY DESIGN

Ex vivo study.

SAMPLE POPULATION

Intestinal tracts from 24 slaughtered horses.

METHODS

A radiofrequency device was used to perform a jejunocecal anastomosis (Group RFA). The construction time and bursting pressure of this construct were compared with those of a hand-sewn double layer (Group HS) and stapled anastomoses (Group ST) without oversew of the staple line. Histology was also performed for the TF anastomoses to evaluate the extent of the thermal damage.

RESULTS

The median (range) construction time (min) for the TF (15.8 [14.4-16.8]) was not significantly different from that for the HS (25.5 [24.2-26.3]) and ST (10.8 [9.7-12.5]) groups (p = .07). The construction time for ST was shorter than that for HS group (p < .001). The average (standard deviation) bursting pressure (mmHg) for HS (153.1 +/- 17.5) was higher than that for RFA (76 +/- 15) and ST groups (48 +/- 13; p < .001). The bursting pressure of the RFA was higher than that of the ST anastomoses (p = .001). The thermal damage caused by the device was within the suture oversew in the deeper layers, whereas it extended a few mm beyond the suture line in the serosa.

CONCLUSION

Radiofrequency assisted anastomoses provide similar construction times to current techniques and have a higher bursting pressure than ST anastomoses.

CLINICAL SIGNIFICANCE

Radiofrequency-assisted anastomoses with a suture oversew demonstrated comparable bursting pressures to ST anastomoses. The use of the radiofrequency device on the intestine is extra label and causes serosal tissue damage, which may increase the risk of adhesions.

Ex-Vivo Evaluation of "First Tip Closing" Radiofrequency Vessel Sealing Devices for Swine Small Intestinal Transection

This study compared burst pressure (BP), number of activations, and histological assessment of ex vivo swine small intestine loops transected by stapler, a single fulcrum radiofrequency vessel sealing (RFVS) device, and the newly-developed jaws RFVS. Fifty (n = 50) 20 cm long jejunal loops were randomly assigned to be transected with RFVS devices and linear stapler (Caiman5, Caiman Maryland, Caiman12, Ligasure Atlas, and Stapler group as control respectively). Caiman5, Caiman12 and stapler required only one activation to complete the sealing. The mean BP in Caiman5 and Caiman Maryland groups were significantly lower (p < 0.05) than the S group as control and the other RFVS devices studied. RFVS Caiman12 and Ligasure Atlas produced mean BP values that were close to the Control and did not differ between them. The lumen was totally closed in the Caiman12 and Ligasure Atlas groups. The findings of this investigation were promising; we discovered that Caiman12 and Ligasure Atlas produce comparable mechanical capabilities as well as stapled intestinal closure, however Caiman12 need a single activation to complete the transection.

Dynamic Impedance Analysis of Intestinal Anastomosis during High-Frequency Electric Field Welding Process

The success rate of the electrosurgical high-frequency electric field welding technique lies in reasonable control of the welding time. However, the final impedance value used to control the welding time varies due to differences in tissue size and the welding method during the welding process. This study aims to introduce a new reference indicator not limited by impedance size from dynamic impedance to achieve an adequate weld strength with minimal thermal damage, providing feedback on the tissue welding effect in medical power supplies. End-to-end anastomosis experiments were conducted with porcine small intestine tissue under seven levels of compression pressure. The dynamic impedance changes were analyzed, combined with compression pressure, temperature, moisture, and collagen during welding. The welding process was divided into three stages according to the dynamic impedance, with impedance decreasing in Period Ⅰ and impedance increasing in Period Ⅲ. Period Ⅲ was the key to high-strength connections due to water evaporation and collagen reorganization. The dynamic impedance ratio is defined as the final impedance divided by the minimum impedance, and successful welding would be predicted when detecting the dynamic impedance ratio over 4 (n = 70, p < 0.001). Dynamic impedance monitoring can be used as a macroscopic real-time prediction of the anastomosis effect.