Visible-Light-Driven Bio-Templated Magnetic Copper Oxide Composite for Heterogeneous Photo-Fenton Degradation of Tetracycline

Biogenic fabrication and enhanced photocatalytic degradation of tetracycline by bio structured ZnO nanoparticles

ABSTRACTZinc oxide nanoparticles (ZnO NPs) were synthesized using Zinc Nitrate as precursor salt, and plant leaves extracts from Azadirachta indica (Common name: Neem), Cymbopogan citratus (Common name: Lemongrass), and Mangifera indica (Common name: Mango), as both chelating and reducing agents for the synthesis of ZnO NPs by a simple cost-effective and eco-friendly green method. The biosynthesized ZnO NPs were well characterized by various methods. XRD pattern revealed a hexagonal wurtzite phase of ZnO, with no other impurity peaks present revealing XRD crystalline sizes of 13.94-16.37 nm calculated using Scherrer equation. The XPS confirmed the presence of Zn, O, and C, and the carbon peaks are almost in agreement with peaks observed by FT-IR. TEM showed the different ZnO with spherical shapes and some aggregations. BET surface area gave 24.98, 21.62, and 22.72 m²/g, respectively for ZnO-AI, ZnO-Cyc, and ZnO-MI, while BJH pore volume and average pore diameter were estimated to be 0.217 cc/g, 0.209 cc/g, 0.211 cc/g, and 2.132 nm, 2.025 nm, and 2.100 nm respectively for ZnO-AI, ZnO-Cyc, and ZnO-MI.Furthermore, the bio-synthesized ZnO NPs were evaluated for their catalytic and photocatalytic performance in the degradation of aqueous tetracycline (TC). The biosynthesized ZnO NPs exhibit good photodegradation efficiency for TC in varying degrees with ZnO-AI > ZnO-MI > ZnO-Cyc. Optimum operational parameters for TC degradation using the ZnO-AI were established, and maximum degradation efficiency of 84.8% was obtained. In addition, the catalyst can also be regenerated and reused up to three cycles, with the third cycle still achieving greater than 80% TC degradation.

Optimization and biosynthesis of calcined chicken eggshell doped titanium dioxide photocatalyst based nanoparticles for wastewater treatment

Abstract

This study presents, biosynthesis of calcinated eggshell (CES) doped with Titanium dioxide (TiO2,) photocatalyst for photodegradation of methylene blue from synthetic wastewater. The influence of three independent variables for improving photodegradation efficiency was investigated and optimized using response surface methodology of Box–Behnken Design on the removal of methylene blue using the calcined chicken eggshells (CES) doped with titanium dioxide. The experimental result showed that 95.8% degradation efficiency of methylene blue by prepared photocatalyst at a contact time of 180 min, initial concentration of methylene blue of 10 ppm, and calcined eggshells (CES) doped with titanium dioxide dose of 2.5 g/L. The synthesized photocatalyst was characterized by Fourier-transform infrared spectroscopy, UV-spectrometer, and X-ray diffractometer and UV–vis Spectroscopy for determined their functional group, structure, and bandgap energy respectively. Their results depict the calcined eggshell doped with titanium dioxide photocatalyst is a promising option for the degradation of methylene blue from industrial wastewater under the stated condition.

Highlights

Emerging Contaminants: An Overview of Recent Trends for Their Treatment and Management Using Light-Driven Processes

The management of contaminants of emerging concern (CECs) in water bodies is particularly challenging due to the difficulty in detection and their recalcitrant degradation by conventional means. In this review, CECs are characterized to give insights into the potential degradation performance of similar compounds. A two-pronged approach was then proposed for the overall management of CECs. Light-driven oxidation processes, namely photo/Fenton, photocatalysis, photolysis, UV/Ozone were discussed. Advances to overcome current limitations in these light-driven processes were proposed, focusing on recent trends and innovations. Light-based detection methodology was also discussed for the management of CECs. Lastly, a cost–benefit analysis on various light-based processes was conducted to access the suitability for CECs degradation. It was found that the UV/Ozone process might not be suitable due to the complication with pH adjustments and limited light wavelength. It was found that EEO values were in this sequence: UV only > UV/combination > photocatalyst > UV/O3 > UV/Fenton > solar/Fenton. The solar/Fenton process has the least computed EEO < 5 kWh m−3 and great potential for further development. Newer innovations such as solar/catalyst can also be explored with potentially lower EEO values.