Studies on the Fabrication and Characterization of Optical Sensor Coatings for Aerodynamic Applications

Polystyrene Oxygen Optodes Doped with Ir(III) and Pd(II) meso-Tetrakis(pentafluorophenyl)porphyrin Using an LED-Based High-Sensitivity Phosphorimeter

This paper presents a gaseous oxygen detection system based on time-resolved phosphorimetry (time-domain), which is used to investigate O2 optical transducers. The primary sensing elements were formed by incorporating iridium(III) and palladium(II) meso-tetrakis(pentafluorophenyl)porphyrin complexes (IrTFPP-CO-Cl and PdTFPP) in polystyrene (PS) solid matrices. Probe excitation was obtained using a violet light-emitting diode (LED) (low power), and the resulting phosphorescence was detected by a high-sensitivity compact photomultiplier tube. The detection system performance and the preparation of the transducers are presented along with their optical properties, phosphorescence lifetimes, calibration curves and photostability. The developed lifetime measuring system showed a good signal-to-noise ratio, and reliable results were obtained from the optodes, even when exposed to moderate levels of O2. The new IrTFPP-CO-Cl membranes exhibited room temperature phosphorescence and moderate sensitivity: <τ0>/<τ21%> ratio of ≈6. A typically high degree of dynamic phosphorescence quenching was observed for the traditional indicator PdTFPP: <τ0>/<τ21%> ratio of ≈36. Pulsed-source time-resolved phosphorimetry combined with a high-sensitivity photodetector can offer potential advantages such as: (i) major dynamic range, (ii) extended temporal resolution (Δτ/Δ[O2]) and (iii) high operational stability. IrTFPP-CO-Cl immobilized in polystyrene is a promising alternative for O2 detection, offering adequate photostability and potentially mid-range sensitivity over Pt(II) and Pd(II) metalloporphyrins.

Significant sensitivity and stability enhancement of tetraphenylporphyrin-based optical oxygen sensing material in presence of perfluorochemicals

Emission-based oxygen sensing properties of highly luminescent tetraphenylporphyrin molecules were investigated in polystyrene, ethyl cellulose, poly(1-trimethylsilyl-1-propyne) and poly(isobutylmethacrylate) matrices. The effect of perfluorochemicals (PFCs) on oxygen sensitivity and stability of the sensor materials was also examined. Fluorescence intensity and lifetime measurements of meso-tetraphenylporphyrinato Zn ( II ) (ZnTPP) and meso-tetraphenylporphyrin (H2TPP) materials were performed in the concentration range of 0–100% pO 2. The fluorescence intensity variation of H2TPPvs. oxygen was 86%. H2TPP-based composite also yielded higher Stern–Volmer constant, faster response and regeneration time, excellent long term photostability and larger linear response range with respect to ZnTPP. The detection limit of oxygen for H2TPP was less than 0.5%. When stored in sealed bags protected from sunlight, no decrease in oxygen sensitivity was observed during approximately five months. As far as we know, the gathered utilization of PFCs and H2TPP embedded in polymer matrices was not previously described in literature, and has present amelioration compared to materials already existing.