In vivo graft performance of an improved bone substitute composed of poor crystalline hydroxyapatite based biphasic calcium phosphate

Influence of physicochemical characteristics of calcium phosphate-based biomaterials in cranio-maxillofacial bone regeneration. A systematic literature review and meta-analysis of preclinical models

Objectives

Calcium phosphate-based biomaterials (CaP) are the most widely used biomaterials to enhance bone regeneration in the treatment of alveolar bone deficiencies, cranio-maxillofacial and periodontal infrabony defects, with positive preclinical and clinical results reported. This systematic review aimed to assess the influence of the physicochemical properties of CaP biomaterials on the performance of bone regeneration in preclinical animal models.

Methods

The PubMed, EMBASE and Web of Science databases were searched to retrieve the preclinical studies investigating physicochemical characteristics of CaP biomaterials. The studies were screened for inclusion based on intervention (physicochemical characterization and in vivo evaluation) and reported measurable outcomes.

Results

A total of 1532 articles were retrieved and 58 studies were ultimately included in the systematic review. A wide range of physicochemical characteristics of CaP biomaterials was found to be assessed in the included studies. Despite a high degree of heterogeneity, the meta-analysis was performed on 39 studies and evidenced significant effects of biomaterial characteristics on their bone regeneration outcomes. The study specifically showed that macropore size, Ca/P ratio, and compressive strength exerted significant influence on the formation of newly regenerated bone. Moreover, factors such as particle size, Ca/P ratio, and surface area were found to impact bone-to-material contact during the regeneration process. In terms of biodegradability, the amount of residual graft was determined by macropore size, particle size, and compressive strength.

Conclusion

The systematic review showed that the physicochemical characteristics of CaP biomaterials are highly determining for scaffold's performance, emphasizing its usefulness in designing the next generation of bone scaffolds to target higher rates of regeneration.

Gene expression, micro-CT and histomorphometrical analysis of sinus floor augmentation with biphasic calcium phosphate and deproteinized bovine bone mineral: A randomized controlled clinical trial

AIMS

The aim of this randomized controlled clinical trial was to compare the gene expression, micro-CT, histomorphometrical analysis between biphasic calcium phosphate (BCP) of 70/30 ratio and deproteinized bovine bone mineral (DBBM) in sinus augmentation.

MATERIALS AND METHODS

Twenty-four patients in need for sinus floor augmentation through lateral approach were randomized into BCP 70/30 ratio or DBBM. After at least 6 months of healing, a total of 24 bone specimens were collected from the entire height of the augmented bone at the area of implant placement and underwent micro-CT, histomorphometric and gene expression analysis. The 12 bone specimens of BCP 70/30 ratio were equally allocated to micro-CT and histologic analysis (test group, n = 6) and gene expression analysis (test group, n = 6). Similarly, the 12 bone specimens of DBBM were also allocated to micro-CT and histologic analysis (control group, n = 6) and gene expression analysis (control group, n = 6). The newly formed bone, remaining graft materials and relative change in gene expression of four target genes were assessed.

RESULTS

The micro-CT results showed no statistically significant difference in the ratio of bone volume to total volume (BV/TV ratio) for the two groups (BCP 41.51% vs. DBBM 40.97%) and the same was true for residual graft material to total volume (GV/TV ratio, BCP 9.97% vs. DBBM 14.41%). Similarly, no significant difference was shown in the histological analysis in terms of bone formation, (BCP 31.43% vs. DBBM was 30.09%) and residual graft area (DBBM 40.76% vs. BCP 45.06%). With regards to gene expression, the level of ALP was lower in both groups of bone grafted specimens compared with the native bone. On the contrary, the level of OSX, IL-1B and TRAP was higher in augmented bone of both groups compared with the native bone. However, the relative difference in all gene expressions between BCP and DBBM group was not significant.

CONCLUSIONS

The BCP, HA/β-TCP ratio of 70/30 presented similar histological and micro-CT outcomes in terms of new bone formation and residual graft particles with DBBM. The gene expression analysis revealed different gene expression patterns between augmented and native bone, but showed no significant difference between the two biomaterials.

Wnt10b regulates osteogenesis of adipose-derived stem cells through Wnt/β-catenin signalling pathway in osteoporosis

Our previous finding revealed that the Wnt10b RNA expression of osteoporotic adipose-derived stem cells (OP-ASCs) with impaired osteogenic capacity was significantly reduced than that of ASCs. There are no ideas that the relationship between the OP-ASCs' impaired osteogenic potential and Wnt10b expression. This study aimed to indicate the potential molecular mechanisms and functional role of Wnt10b in OP-ASCs, as well as to investigate a potential application to reverse the OP-ASCs' impaired osteogenic differentiation potential. The OP-ASCs and ASCs were harvested from the inguinal fat of osteoporosis (OP) mice with bilateral ovariectomy (OVX) and normal mice. qPCR and WB were used to detect the different levels of the expression of the Wnt10b RNA in both OP-ASCs and ASCs. Lentiviral-mediated regulation of Wnt10b expression was employed for OP-ASCs, and the detection of the expression levels of key molecules in the Wnt signalling pathway and key osteogenic factors was performed through qPCR and WB in vitro experiments. The capacity of OP-ASCs to osteogenesis was determined using alizarin red staining. Lastly, the repair effect of the BCP scaffolds incorporating modified OP-ASCs on the critical-sized calvarial defects (CSCDs) in OP mice was scanned and detected by micro-computed tomography, haematoxylin and eosin staining, Masson's trichrome staining and immunohistochemistry. First, we discovered that both the RNA and protein expression levels of Wnt10b were significantly lower in OP-ASCs than that in ASCs. In vitro experiments, upregulation of Wnt10b could activate the Wnt signalling pathway, and increase expression of β-catenin, Lef1, Runx2 and osteopontin (Opn), thereby enhancing the osteogenic ability of OP-ASCs. In addition, the OP-ASCs with Wnt10b-overexpressing could promote the repair of CSCD in osteoporotic mice with increasing new bone volume, bone mineral density, and increased expression of Opn in new bone in vivo. Taken together, overexpression of Wnt10b could partially facilitate the differentiation of OP-ASCs towards osteogenesis and accelerated the healing of bone defects by activating the Wnt/β-catenin signalling pathway in vitro and in vivo experiments. This study confirmed the important role of Wnt10b in regulating the osteogenic differentiation capability of OP-ASCs and indicated Wnt10b could be a potential therapeutic target for reversing the impaired osteogenic capabilities of OP-ASCs to therapy bone defects of OP patients.

Proliferation and osteogenic differentiation of rat BMSCs on a novel Ti/SiC metal matrix nanocomposite modified by friction stir processing

The aims of this study were to fabricate a novel titanium/silicon carbide (Ti/SiC) metal matrix nanocomposite (MMNC) by friction stir processing (FSP) and to investigate its microstructure and mechanical properties. In addition, the adhesion, proliferation and osteogenic differentiation of rat bone marrow stromal cells (BMSCs) on the nanocomposite surface were investigated. The MMNC microstructure was observed by both scanning and transmission electron microscopy. Mechanical properties were characterized by nanoindentation and Vickers hardness testing. Integrin β1 immunofluorescence, cell adhesion, and MTT assays were used to evaluate the effects of the nanocomposite on cell adhesion and proliferation. Osteogenic and angiogenic differentiation were evaluated by alkaline phosphatase (ALP) staining, ALP activity, PCR and osteocalcin immunofluorescence. The observed microstructures and mechanical properties clearly indicated that FSP is a very effective technique for modifying Ti/SiC MMNC to contain uniformly distributed nanoparticles. In the interiors of recrystallized grains, characteristics including twins, fine recrystallized grains, and dislocations formed concurrently. Adhesion, proliferation, and osteogenic and angiogenic differentiation of rat BMSCs were all enhanced on the novel Ti/SiC MMNC surface. In conclusion, nanocomposites modified using FSP technology not only have superior mechanical properties under stress-bearing conditions but also provide improved surface and physicochemical properties for cell attachment and osseointegration.

Biphasic calcium phosphates bioceramics (HA/TCP): Concept, physicochemical properties and the impact of standardization of study protocols in biomaterials research

Biphasic calcium phosphates (BCP) bioceramics have become the materials of choice in various orthopedic and maxillofacial bone repair procedures. One of their main advantages is their biodegradation rate that can be modified by changing the proportional ratio of the composition phases. For enhanced bone tissue regeneration, the bioactivity of BCP should be increased by optimizing their physicochemical properties. To date, the ideal physicochemical properties of BCP for bone applications have not been defined. This is mostly related to lack of standard study protocols in biomaterial science especially with regards to their characterizations and clinical applications. In this paper we provided a review on BCP and their physicochemical properties relevant to clinical applications. In addition, we summarized the available literature on their use in animal models and evaluated the influences of different composition ratios on bone healing. Controversies in literature with regards to ideal composition ratio of BCP have also been discussed in detail. We illustrated the discrepancies in study protocols among researchers in animal studies and emphasized the need to develop and follow a set of generally accepted standardized guidelines. Finally; we provided general recommendations for future pre-clinical studies that allow better standardization of study protocols. This will allow better comparison and contrast of newly developed bone substitute biomaterials that help further progress in the field of biomaterial science.

An overview of chitin or chitosan/nano ceramic composite scaffolds for bone tissue engineering

Chitin and chitosan based nanocomposite scaffolds have been widely used for bone tissue engineering. These chitin and chitosan based scaffolds were reinforced with nanocomponents viz Hydroxyapatite (HAp), Bioglass ceramic (BGC), Silicon dioxide (SiO₂), Titanium dioxide (TiO₂) and Zirconium oxide (ZrO₂) to develop nanocomposite scaffolds. Plenty of works have been reported on the applications and characteristics of the nanoceramic composites however, compiling the work done in this field and presenting it in a single article is a thrust area. This review is written with an aim to fill this gap and focus on the preparations and applications of chitin or chitosan/nHAp, chitin or chitosan/nBGC, chitin or chitosan/nSiO₂, chitin or chitosan/nTiO₂ and chitin or chitosan/nZrO₂ in the field of bone tissue engineering in detail. Many reports so far exemplify the importance of ceramics in bone regeneration. The effect of nanoceramics over native ceramics in developing composites, its role in osteogenesis etc. are the gist of this review.

Experimental study on the osseointegration of foam TiC/Ti composites

Macroporous ceramics have demonstrated osteoconductive properties because of their biocompatibility and 3D macroporous structure, and these materials have recently been widely studied as bone replacement materials. The foam TiC/Ti composites discussed in this study have good mechanical properties, balancing out metallic toughness and ceramic strength. Furthermore, because of the high porosity and pore connectivity of these TiC/Ti composites, they have the potential to be a new bone replacement material. The purpose of this study was to evaluate the osseointegration of foam TiC/Ti composites, preliminarily discuss the TiC/Ti ossification mechanism, and to obtain reliable data on the use of foam TiC/Ti composites as bone replacement materials. The foam TiC/Ti composites were sited in 40 Japanese white rabbits for 4, 8, 12 and 24 weeks. The foam TiC/Ti composites were compared to foam SiC. M-CT (micro-computed tomography) analysis, histological analysis, SEM (scanning electron microscopy) observation and EDS (energy-dispersive x-ray spectrometer) analysis were conducted to estimate the osseointegration of the materials. The histological observations and quantitative analysis exhibited significantly more ossification area (volume), trabeculae maturity, and calcium and phosphorus content in the foam TiC/Ti composites compared to the foam SiC (p < 0.05). The results from this study suggest that the foam TiC/Ti composites possess good osseointegration capacity and have the potential to be a new bone replacement material.

The association of human primary bone cells with biphasic calcium phosphate (βTCP/HA 70:30) granules increases bone repair

This work evaluates the suitability of biphasic calcium phosphate (BCP) granules (β-TCP/HA 70:30) as potential carriers for cell-guided bone therapy. The BCP granules were obtained by synthesis in the presence of wax, thermal treatment, crushing and sieving and characterized by scanning electron microscopy (SEM), X-ray diffraction and Fourier transform infrared spectroscopy. The cytocompatibility of the BCP granules was confirmed by a multiparametric cytotoxicity assay. SEM analysis showed human bone cell adhesion and migration after seeding onto the material. Rat subcutaneous xenogeneic grafting of granules associated to human bone cells revealed a more accentuated moderate chronic inflammatory infiltrate, without signs of a strong xenoreactivity. Histomorphometrical analysis of bone repair of defects in rat skulls (∅ = 5 mm) has shown that bone cell associated-BCP and autograft promoted a two- and threefold increase, respectively, on new bone formation after 45 days, as compared to BCP alone and blood clot. The increase in bone repair supports the suitability the biocompatible (70:30) BCP granules as injectable and mouldable scaffolds for human cells in bone bioengineering.

Biphasic, triphasic and multiphasic calcium orthophosphates

Biphasic, triphasic and multiphasic (polyphasic) calcium orthophosphates have been sought as biomaterials for reconstruction of bone defects in maxillofacial, dental and orthopedic applications. In general, this concept is determined by advantageous balances of more stable (frequently hydroxyapatite) and more resorbable (typically tricalcium orthophosphates) phases of calcium orthophosphates, while the optimum ratios depend on the particular applications. Therefore, all currently known biphasic, triphasic and multiphasic formulations of calcium orthophosphate bioceramics are sparingly soluble in water and, thus, after being implanted they are gradually resorbed inside the body, releasing calcium and orthophosphate ions into the biological medium and, hence, seeding new bone formation. The available formulations have already demonstrated proven biocompatibility, osteoconductivity, safety and predictability in vitro, in vivo, as well as in clinical models. More recently, in vitro and in vivo studies have shown that some of them might possess osteoinductive properties. Hence, in the field of tissue engineering biphasic, triphasic and multiphasic calcium orthophosphates represent promising biomaterials to construct various scaffolds capable of carrying and/or modulating the behavior of cells. Furthermore, such scaffolds are also suitable for drug delivery applications. This review summarizes the available information on biphasic, triphasic and multiphasic calcium orthophosphates, including their biomedical applications. New formulations are also proposed.