Adhesive behavior of the alloys "ALBABOND E" containing large percentage of Pd after various surface treatments

Evaluation of three silicoating methods for resin-bonded prostheses

Three different methods of increasing the bond strength of resin to metal were tested: the original Silicoater technique, the Silicoater MD technique, and the Rocatec system. Metals used for the resin-bonded prostheses were gold, a cobalt-chromium (Co-Cr) alloy, and titanium. Silicoating increased the bond strength to sandblasted specimens. The original Silicoater technique produced the highest bond strengths, especially when used with the Co-Cr alloy and titanium. The Silicoater MD technique showed the lowest bond strengths for all of the test metals. Storage for 7 days with protective film on the silicoated surface did not affect the bond strength, as compared with specimens bonded immediately. The retention of the resin to the gold specimens (Rocatec system) decreased after thermocycling, but retention to the Co-Cr alloy and titanium was not affected. Various resin cements were tested and showed the same retention with the exception of Microfill Pontic, which gave a weaker bond. Scanning electron microscope (SEM) and energy-dispersive X-ray analysis (EDAX) of the specimens before and after the measurements gave no clear explanation of the differences in bond strengths between the test metals. However, it was concluded that silicoating of the metal surfaces contributed to the retention of the resin by chemical action, as no differences in adaptation of the resin to the metal were seen between specimens pretreated by sandblasting and those which were also silicoated.

Dental cements

The manifold uses of dental cements-as (a) luting agents, (b) cavity linings and bases, and (c) restorations for teeth—make them perhaps the most important materials in clinical dentistry. The research of the last 10 years has resulted in four main types, classified by matrix-forming species: (1) phosphate, (2) phenolate, (3) polycarboxylate, and (4) polymethacrylate. The zinc phosphate cements continue to be widely used for luting in an essentially unchanged form. Acidity and oral dissolution remain as problems. The zinc-oxide eugenol cements and their modifications are useful as linings and temporary materials but are susceptible to hydrolytic breakdown. Vanillate cements may be an improvement. Calcium hydroxide-salicylate cements are widely used as cavity linings, especially on exposures, and show improved resistance to acid dissolution. Polycarboxylate cements as both zinc polycarboxylate and glass-ionomer cements show adhesion potential, good physical properties, fluoride release, and, generally, good biological properties. Glass-ionomer cements when correctly manipulated show minimal oral dissolution. Polymethacrylate cements have been used principally for bonding etched cast metal restorations to etched enamel. Recently, adhesive crown-and-bridge cements have been developed. There are no well-established correlations between laboratory measurements of apparently relevant properties and clinical performance. More clinically-based research is needed to facilitate the development of new cements.