Determination of Picogram Levels of Levodopa in Pharmaceutical Preparations and Biofluids by Flow-Injection Chemiluminescence

Voltammetric Determination of Levodopa Using Mesoporous Carbon-Modified Screen-Printed Carbon Sensors

Levodopa is a precursor of dopamine, having important beneficial effects in the treatment of Parkinson’s disease. In this study, levodopa was accurately detected by means of cyclic voltammetry using carbon-based (C-SPCE), mesoporous carbon (MC-SPCE) and ordered mesoporous carbon (OMC-SPCE)-modified screen-printed sensors. Screen-printed carbon sensors were initially used for the electrochemical detection of levodopa in a 10⁻³ M solution at pH 7.0. The mesoporous carbon with an organized structure led to better electroanalysis results and to lower detection and quantification limits of the OMC-SPCE sensor as compared to the other two studied sensors. The range of linearity obtained and the low values of the detection (0.290 µM) and quantification (0.966 µM) limit demonstrate the high sensitivity and accuracy of the method for the determination of levodopa in real samples. Therefore, levodopa was detected by means of OMC-SPCE in three dietary supplements produced by different manufacturers and having various concentrations of the active compound, levodopa. The results obtained by cyclic voltammetry were compared with those obtained by using the FTIR method and no significant differences were observed. OMC-SPCE proved to be stable, and the electrochemical responses did not vary by more than 3% in repeated immersions in a solution with the same concentration of levodopa. In addition, the interfering compounds did not significantly influence the peaks related to the presence of levodopa in the solution to be analyzed.

Quantitative NMR analysis of L-Dopa in seeds from two varieties of Mucuna pruriens

INTRODUCTION

L-Dopa, a key neurotransmitter used to treat neural disorders such as Parkinson's disease, is found in the seeds of the genus Mucuna at a sufficient concentration for possible commercial use.

OBJECTIVE

To develop a simple and reliable method to extract L-Dopa from M. pruriens seeds in an aqueous medium and then quantitate this compound using a ¹ H qNMR method (internal standard); and also to evaluate the accuracy and reproducibility of this method with an NMR calibration curve.

METHODOLOGY

The extraction method of L-Dopa from M. pruriens was optimized. The quantitation with single point quantitative NMR (qNMR) and NMR calibration curve was based on the resonance properties of the main functional groups of the L-Dopa molecule, in particular the signals of the three aromatic protons, which were compared with the signal of an internal standard such as syringic acid. The accuracy (precision and trueness) and reproducibility of both NMR techniques were evaluated.

RESULTS

The methods of single point qNMR and NMR calibration curve, applied to the seeds of two M. pruriens varieties, gave very similar L-Dopa contents: 3.0-3.2% and 3.0-3.1%, respectively.

CONCLUSION

The statistical analysis confirmed the accuracy and reproducibility of this single point qNMR method (internal standard) for determining L-Dopa, as well as other commercial preparations of this species, without performing an NMR calibration curve.

3-Dimensional hollow graphene balls for voltammetric sensing of levodopa in the presence of uric acid

The development of novel nanomaterials brings new opportunity and challenge for high sensing detection of biomolecules. The authors describe the preparation of 3-dimentional hollow graphene balls (3D HGBs) using nickel nanoparticles (Ni-NPs) as the template. The Ni-NPs were synthesized by chemical reduction of nickel chloride and then graphene was coated onto their surface via carburization and carbonization. After etching Ni-NPs, 3D HGBs with few layers and a typical size of 100 nm were obtained. They were sprayed onto indium tin oxide glass to obtain a working electrode for electrochemical determination of levodopa in the presence of uric acid. Due to the unique hollow porous structure of the 3D HGBs, the electrode exhibits a sensitivity of 0.69 μA·μM^-1·cm^-2 and a 1 μM limit of detection. It is selective, reproducible and stable. It was applied to the determination of levodopa in spiked human plasma samples and it is of potential use in clinical research. Graphical abstract Schematic presentation of the preparation of 3-dimensional hollow graphene balls (HGBs) by using nickel nanoparticles as a template that can be removed by etching. The HGBs were sprayed onto indium tin oxide (ITO) glass to obtain a working electrode that has a sensitivity of 0.69 μA⋅μM^-1·cm^-2 and a 1 μM limit of detection for the determination of levodopa.