Correlation between Condylar Fracture Pattern after Parasymphyseal Impact and Condyle Morphological Features: A Retrospective Analysis of 107 Chinese Patients

Correlation of radiomorphometric indices of the mandible and mandibular angle fractures

This study assessed the correlation of radiomorphometric indices of the mandible and mandibular angle fractures (MAFs) in an Iranian population. This retrospective study was conducted on 3D computed tomography (CT) scans of 118 patients between 18 to 60 years. The images were divided into two groups with MAFs and other types of mandibular fractures (non-MAF). The gonial angle, ramus height, condylar neck width, minimum ramus width, and mandibular length were all measured using MARCO PACS software. Age, gender, and presence and eruption status of third molar at the fracture side were all recorded. The correlation between these parameters and MAF was analyzed using R software (alpha = 0.05). Of all patients, 41 samples had MAF. The two groups were not significantly different regarding the mean age and gender (P > 0.05). The mean size of gonial angle and ramus height in the MAF group were significantly larger, and smaller than the corresponding values in the non-MAF group, respectively (P < 0.001). The median minimum ramus width in the MAF group was significantly smaller than that in the non-MAF group (P = 0.001). Patients with a large gonial angle had 6.6 times higher odds of MAF compared with other fracture types (P = 0.046). Condylar neck width, mandibular length, and erupted third molars had no significant correlation with type of fracture. Presence of impacted third molar increased the odds of MAF by 5.55 times.

Patients with a large gonial angle, short ramus height, minimum ramus width, and impacted third molar are more susceptible to MAF. Surgeons can use these indices to predict the risk of MAF in trauma patients with such facial characteristics, and make a diagnosis by radiographic modalities.

The Influence of the Mandibular Chin Angle on the Occurrence of Mandibular Condylar Fracture: A Retrospective Study

Background

Condylar fractures are commonly associated with symphysis/parasymphysis fractures. Condylar fractures have been attributed to direct and indirect traumatic forces, the direction and magnitude of the forces, and the condylar anatomy. The chief aim of this study was to determine the association between the newly defined mandibular chin angle and the occurrence of condylar fractures.

Materials and Methods

A retrospective study was conducted to analyze two-dimensional computed tomography (2D CT) scans of patients with a history of chin trauma. The outcome was a symphysis/parasymphysis fracture with or without fracture of the mandibular condyle. The Mediff InstaRISPACS web-based platform was used to measure the chin angle. The cerebral aqueduct of Sylvius in the corresponding 2D CT midsagittal image was the standard reference plane to measure the chin angle. The SPSS Version 20 (IBM Corp, Armonk, NY) was used for data analysis.

Results

The sample size included 120 2D CT scans of patients with symphysis/parasymphysis fractures (60 associated with condylar fractures and 60 without condylar fractures). The mean chin angle in the group without condylar fracture was 133.35 ± 3.87°, which was approximately 15° lesser than in the condylar fracture group (mean, 148.56 ± 5.49°), and these findings were statistically significant (P < 0.05).

Conclusion

Individuals with a high chin angle are potentially at a higher risk of sustaining associated condylar fractures.

Combined Symphyseal and Condylar Fractures: Considerations for Treatment in Growing Pediatric Patients

BACKGROUND

Combined symphyseal-condylar mandible fractures are relatively common but difficult to manage in children. This study investigated the cause and management of symphyseal-condylar fractures in pediatric patients.

METHODS

This study presents a retrospective review and expert opinion of pediatric symphyseal-condylar mandibular fracture management at the authors' institution between 1990 and 2019. National data from the Healthcare Cost and Utilization Project Kids' Inpatient Database (2000 to 2016) were used to determine whether institutional data had national applicability.

RESULTS

Twenty-one patients at the authors' institution met inclusion criteria. Of these patients, 26.7 percent of deciduous dentition patients underwent open reduction and internal fixation, 40 percent underwent closed treatment (maxillomandibular fixation), and 33.3 percent received a soft diet. All mixed dentition patients underwent open reduction and internal fixation or closed treatment; all permanent dentition patients underwent open reduction and internal fixation. The national database (n = 1708) demonstrated similar treatment patterns: most permanent dentition patients (88.7 percent) underwent open reduction and internal fixation, most mixed dentition patients (79.2 percent) underwent closed treatment, and among deciduous dentition patients, 53.5 percent patients received a soft diet; 38 percent received closed treatment. In this study, the overall posttreatment complication rate was 62.5 percent among open reduction and internal fixation patients, 14.3 percent among closed treatment patients, and 16.7 percent among patients treated with a soft diet.

CONCLUSIONS

Symphyseal-condylar mandibular fractures were associated with substantial morbidity in children. The authors created a treatment algorithm to maximize outcomes in children who suffer from this challenging fracture pattern.

CLINICAL QUESTION/LEVEL OF EVIDENCE

Therapeutic, III.

Changes in mandibular and articular dynamics associated with surgical versus nonsurgical treatment of mandibular condylar fractures: a systematic review with meta-analysis

OBJECTIVE

The aim of this study was to evaluate the mandibular and articular dynamics and the presence of complications associated with surgical or nonsurgical treatments of condylar fractures.

STUDY DESIGN

Clinical trials that compared open reduction internal fixation and maxillomandibular fixation in patients with condylar fractures were included. We performed an electronic search of PubMed, Scopus, Cochrane Library, Web of Science, and LILACS (Latin American and Caribbean Health Sciences) databases starting from February 2017 and updated in January 2019 and found 467 articles. We evaluated methodologic quality by using the criteria from Cochrane's Collaboration Tool.

RESULTS

After independent screening of abstracts, we assessed the full texts of 88 articles; 9 studies were included for qualitative synthesis; but only 8 were included for the meta-analysis. Four studies were considered to have high risk of bias, and 5 were considered to have low risk. The risk ratio (RR = 0.20; 95% confidence interval [CI] 0.13-0.32) was observed for complications. The quality of evidence, using GRADE software, was considered low for maximum mouth opening and protrusive movement and moderate for lateral excursion movement and complications.

CONCLUSIONS

This review suggested that open reduction internal fixation and maxillomandibular fixation are effective. However, surgical treatment presented higher objective parameters. Nonsurgical treatment presented a high index of complications, such as malocclusion, pain and deviation.

Craniofacial Morphometric Features Associated With Pericondylar Fractures of the Mandible

The research aimed at investigating potential correlations between craniofacial morphological measurements and mandibular pericondylar fractures, based on a retrospective study of 380 mandible fractures treated in our department, during 2010 to 2017. Predictors included morphological measurements and features. Primary outcome was presence of pericondylar fracture; 133 pericondylar fractures were found, including subcondylar, condylar neck, and condylar head fractures. Condylar neck fractures showed negative correlations with condylar neck width (5.7 mm versus 6.7 mm sagittaly, and 6.1 mm versus 6.8 mm coronally, respectively). Gonial angle (117.3 degrees versus 128.7), and mandibular length 106.2 mm versus 110.4 mm, respectively) showed negative correlation with all pericondylar fractures. Ramus height correlated positively with pericondylar fractures (53.6 mm versus 51.2 mm, respectively). Thus, our results showed condylar neck width was a predictor for condylar neck fractures. In addition, individuals suffering from pericondylar fractures had significantly smaller gonial angles, longer ramus height, and shorter mandibular length. These morphologic features are characteristic of individuals with decreased anterior facial height. Our results corroborated a previous study we had conducted, which suggested that increased anterior vertical growth correlates with angle fractures.

Morphology of the patellar tendon and its insertion sites using three-dimensional computed tomography: A cadaveric study

BACKGROUND

To clarify, with three-dimensional (3D) images, the morphological properties of the patellar tendon and both of its insertion sites.

METHODS

Thirty-two human cadaveric left knees were evaluated, and 3D computed tomography images were created. These images were used to analyse the morphology of both insertion sites of the patellar tendon, and the width, length and thickness of each region of the patellar tendon.

RESULTS

The insertion sites of the patellar tendon on the patellar and tibial sides were V-shaped and crescent-shaped, respectively, with the respective bony apexes located at 44.5 ± 2.2% (standard deviation) and 35.5 ± 2.8% of the tendon width from its medial edge. The proximal, central and distal widths of the patellar tendon were 29.9 ± 2.7 mm, 27.3 ± 2.5 mm and 25.0 ± 2.4 mm, respectively. The length of the patellar tendon was shortest at 40.6% ± 6.7% of the central width and gradually became longer toward both edges. The patellar tendon was thickest in the central portion of 40-75% and gradually became thinner toward both edges.

CONCLUSIONS

The morphological properties of the patellar tendon and its insertion sites on both the patellar and tibial sides were consistent. These findings indicate that the characteristics of the bone-patellar tendon-bone graft markedly depend on the location from which it is harvested, and that these characteristics contribute to predicting the length, width and shapes of the bone plugs of the graft when performing bone-patellar tendon-bone surgery.

Surgical Treatment for Extracapsular Condylar Fractures of the Mandible

BACKGROUND

Condylar fractures are considered the most controversial mandibular fractures, regarding both the diagnosis and the treatment. With the increase in surgical indications for handling this type of fracture, it is important to discuss about the advantages and disadvantages of the several surgical approaches available. This article describes the surgical details and postoperative results of the mini-retromandibular transparotid approach for treating extracapsular condylar fractures of the mandible.

METHODS

In a 1-year period, 16 patients affected by extracapsular condylar fractures with surgical indication were treated with the mini-retromandibular transparotid approach. All the surgeries were executed by the same surgeon. Preoperative and postoperative details of each patient were analyzed.

RESULTS

In the postoperatory, only 2 patients had purulent drainage in the associated fractures area and only 1 patient had paresis of the buccal branch of the facial nerve. No scar issues concerning the surgical wound were observed and reintervention was not necessary in any of the patients.

CONCLUSION

The mini-retromandibular transparotid approach offers advantages and should be included as an option for the open treatment of extracapsular condylar fractures of the mandible.

The Relation Between Morphometric Features and Susceptibility to Mandibular Angle Fractures

The study was aimed to determine possible relations between skeletal morphologic parameters to mandibular angle fractures. Retrospective study of 100 patients suffering from mandibular fractures and treated in the Rambam Health Care Campus between the years 2013 and 2017 was conducted. Predictor variable was facial skeletal morphologic features as derived from the measurements. Outcome variable was mandibular angle fractures. About 42 patients suffered from angle fractures. Gonial angle (131.3° versus 118.1°), condylar neck width (8.3 mm versus 6.8 mm sagittaly and 7.1 mm versus 5.8 mm horizontally), and wisdom tooth prevalence and impaction were positively correlated to the fracture. Ramus height (48.3 mm versus 53.4 mm) was negatively correlated to angle fractures. Many reports in the literature show positive relations between impacted 3rd molars and angle fractures, yet only sporadic reports describe relations between facial fractures and facial features. Our results showed the predictable positive relation between angle fractures and 3rd molar prevalence and impaction. Yet surprisingly, we found unequivocal significant positive correlation between angle fractures to gonial angle and condylar neck width and negative correlation to ramus height. Based on the correlation to the gonial angle and ramal height, it is concluded that enlarged anterior vertical growth is a predictor for angle fractures, as are condylar neck width, and wisdom teeth.