Simulation of the 6 MV Elekta Synergy Platform linac photon beam using Geant4 Application for Tomographic Emission

Effect of the Gaussian distribution parameters of the electron beam generated at the target on the simulated x-ray dose

The purpose of this work was to investigate by Monte Carlo method the adjustment of photon beams delivered by the medical LINear ACcelerator (LINAC) Elekta Synergy MLCi2. This study presents an optimization of the Gaussian distribution parameters of the accelerated electrons before the target simulated by two Monte Carlo codes and for three beams. The photon (x-ray) beam is produced by the interaction of accelerated electrons with the LINAC target. The electrons are accelerated by a potential difference created between the anode and the cathode of the gun and directed towards the target. In the Monte Carlo simulation, it is necessary to setup the spectrum parameters of the generated electrons to simulate the x-ray dose distribution. In this study, we modeled the LINAC geometry for photon beams 18MV and 6MV in cases Flattened (FF) and Flattening-Filter-Free (FFF). The Monte Carlo simulations are based on G4Linac_MT and GATE codes. The results of the optimized configurations determined after more than 20 tests for each beam energy show a very good agreement with the experimental measurements for different irradiation fields for the depth (PDD) and lateral (Profile) dose distribution. In all Monte Carlo calculations performed in this study, the statistical uncertainty is less than 2%. The results were also in very good agreement in terms ofγ-index analysis, for the 3%/3 mm and 2%/2 mm criteria.

Grid Block Design Based on Monte Carlo Simulated Dosimetry, the Linear Quadratic and Hug-Kellerer Radiobiological Models

Purpose

The clinical efficacy of Grid therapy has been examined by several investigators. In this project, the hole diameter and hole spacing in Grid blocks were examined to determine the optimum parameters that give a therapeutic advantage.

Methods

The evaluations were performed using Monte Carlo (MC) simulation and commonly used radiobiological models. The Geant4 MC code was used to simulate the dose distributions for 25 different Grid blocks with different hole diameters and center-to-center spacing. The therapeutic parameters of these blocks, namely, the therapeutic ratio (TR) and geometrical sparing factor (GSF) were calculated using two different radiobiological models, including the linear quadratic and Hug-Kellerer models. In addition, the ratio of the open to blocked area (ROTBA) is also used as a geometrical parameter for each block design. Comparisons of the TR, GSF, and ROTBA for all of the blocks were used to derive the parameters for an optimum Grid block with the maximum TR, minimum GSF, and optimal ROTBA. A sample of the optimum Grid block was fabricated at our institution. Dosimetric characteristics of this Grid block were measured using an ionization chamber in water phantom, Gafchromic film, and thermoluminescent dosimeters in Solid Water™ phantom materials.

Results

The results of these investigations indicated that Grid blocks with hole diameters between 1.00 and 1.25 cm and spacing of 1.7 or 1.8 cm have optimal therapeutic parameters (TR > 1.3 and GSF~0.90). The measured dosimetric characteristics of the optimum Grid blocks including dose profiles, percentage depth dose, dose output factor (cGy/MU), and valley-to-peak ratio were in good agreement (±5%) with the simulated data.

Conclusion

In summary, using MC-based dosimetry, two radiobiological models, and previously published clinical data, we have introduced a method to design a Grid block with optimum therapeutic response. The simulated data were reproduced by experimental data.