Development and validation of spectrophotometric, atomic absorption and kinetic methods for determination of moxifloxacin hydrochloride

Development and validation of synchronous spectrofluorimetric method for the simultaneous determination of duvelisib and moxifloxacin: greenness metric assessment and application to a pharmacokinetic study in rats

Duvelisib (DUV) is a potent anticancer drug whereas Moxifloxacin (MOX) is an antimicrobial drug with anti-proliferative potency against cancerous cells, which is empirically administered in cancer treatment. DUV and MOX combination is commonly prescribed to combat infections in patients while they are under chemotherapy treatment. This study describes, for the first time, the development of a simple and green synchronous spectrofluorimetric (SSF) method for the simultaneous estimation of DUV and MOX in plasma. DUV and MOX were quantified at 273 and 362 nm, respectively without interference between each other at Δλof 120 nm. The experimental variables influencing fluorescence intensities were thoroughly investigated and the optimum conditions were established. At pH 3.5, the optimum synchronous fluorescence intensity (SFI) was achieved in water solvent by using sodium acetate buffer solution. Calibration curves for DUV and MOX, correlating the SFI with the corresponding drug concentration, were linear in the range of 50-1000 ng mL-1for both drugs, with good correlation coefficients. The method was extremely sensitive, with limits of detection of 24 and 22 ng mL-1, and limits of quantitation of 40 and 45 ngmL-1for DUV and MOX, respectively. The SSF method was validated according to the Food and Drug Administration (FDA) guidelines for validation of analytical procedures, and the validation parameters were acceptable. The proposed SSF method was applied to the pharmacokinetic and bioavailability studies in rats' plasma after single concurrent oral administration of both drugs. The results of the study revealed that caution should be taken with DUV dose when concurrently administered with MOX. The greenness of SSF method was assessed by three different metric tools namely Analytical Eco-scale, Green Analytical Procedure Index, and Analytical Greenness Calculator. The results confirmed that SSF method is an eco-friendly and green analytical approach. In conclusion, the proposed SSF method is a valuable tool for pharmacokinetic/bioavailability studies and therapeutic drug monitoring of simultaneously administered DUV and MOX.

Moxifloxacin: Physical-chemical and Microbiological Analytical Methods in the Context of Green Analytical Chemistry

Moxifloxacin (MOX) is a fourth-generation fluoroquinolone used in the form of tablets, infusion solutions and ophthalmic solutions. It does not have a physical-chemical or microbiological analytical method described in an official compendium. However, the literature shows some analysis methods for pharmaceuticals and biological matrices. In this context, the objective is to show the analytical methods present in the literature for the investigation of MOX by physical-chemical and microbiological techniques, as well as discussing them according to the requirements of current pharmaceutical analyses and green analytical chemistry. Among the physical-chemical methods present in the literature for MOX evaluation, 33% are HPLC, 21% are UV-Vis and 17% are capillary electrophoresis. On the other hand, among the microbiological methods, all of them are based on diffusion in agar. There is still scope in the literature to incorporate new and improved analytical methods for MOX evaluation, which adopt the concepts of green and sustainable analytical chemistry, either by using less (or not using) toxic organic solvents, reducing waste generation or even reducing the analysis time according to the intended objectives.

Development and validation of sensitive kinetic spectrophotometric method for the determination of moxifloxacin antibiotic in pure and commercial tablets

New, accurate, sensitive and reliable kinetic spectrophotometric method for the assay of moxifloxacin hydrochloride (MOXF) in pure form and pharmaceutical formulations has been developed. The method involves the oxidative coupling reaction of MOXF with 3-methyl-2-benzothiazolinone hydrazone hydrochloride monohydrate (MBTH) in the presence of Ce(IV) in an acidic medium to form colored product with lambda max at 623 and 660 nm. The reaction is followed spectrophotometrically by measuring the increase in absorbance at 623 nm as a function of time. The initial rate and fixed time methods were adopted for constructing the calibration curves. The linearity range was found to be 1.89-40.0 μg mL(-1) for initial rate and fixed time methods. The limit of detection for initial rate and fixed time methods is 0.644 and 0.043 μg mL(-1), respectively. Molar absorptivity for the method was found to be 0.89×10(4) L mol(-1) cm(-1). Statistical treatment of the experimental results indicates that the methods are precise and accurate. The proposed method has been applied successfully for the estimation of moxifloxacin hydrochloride in tablet dosage form with no interference from the excipients. The results are compared with the official method.

Moxifloxacin hydrochloride

A comprehensive profile of moxifloxacin HCl with 198 references is reported. A full description including nomenclature, formulae, elemental analysis, and appearance is included. Methods of preparation for moxifloxacin HCl, its intermediates, and derivatives are fully described. In addition, the physical properties, analytical methods, stability, uses and applications, and pharmacology of moxifloxacin HCl are also discussed.

Simple Atomic Absorption Spectroscopic and Spectrophotometric Methods for Determination of Pioglitazone Hydrochloride and Carvedilol in Pharmaceutical Dosage Forms

This study represents simple atomic absorption spectroscopic and spectrophotometric methods for determination of pioglitazone hydrochloride (PGZ-HCl) and carvedilol (CRV) based on formation of ion-pair associates between drugs and inorganic complex, bismuth(III) tetraiodide (Method A) and between drugs and organic acidic dyes, fast green and orange G (Method B). Method A is based on formation of ion-pair associate between drugs and bismuth(III) tetraiodide in acidic medium to form orange-red ion-pair associates, which can be quantitatively determined by two different procedures. The formed ion-pair associate is extracted by methylene chloride, dissolved in acetone, dried, and then decomposed by hydrochloric acid, and bismuth content is determined by direct atomic absorption spectrometric technique (Procedure 1) or extracted by methylene chloride, dissolved in acetone, and quantified spectrophotometrically at 490 nm (Procedure 2). Method B is based on formation of ion-pair associate between drugs and either fast green dye or orange G dye in acidic medium to form ion-pair associates. The formed ion-pair associate is extracted by methylene chloride and quantified spectrophotometrically at 630 nm (for fast green dye method) or 498 nm (for orange G dye method). Optimal experimental conditions have been studied. Both methods are applied for determination of the drugs in tablets without interference.

Spectrophotometric determination of gemifloxacin mesylate, moxifloxacin hydrochloride, and enrofloxacin in pharmaceutical formulations using Acid dyes

SIMPLE, RAPID, AND EXTRACTIVE SPECTROPHOTOMETRIC METHODS WERE DEVELOPED FOR THE DETERMINATION OF SOME FLUOROQUINOLONES ANTIBIOTICS: gemifloxacin mesylate (GMF), moxifloxacin hydrochloride (MXF), and enrofloxacin (ENF) in pure forms and pharmaceutical formulations. These methods are based on the formation of ion-pair complexes between the basic drugs and acid dyes, namely, bromocresol green (BCG), bromocresol purple (BCP), bromophenol blue (BPB), bromothymol blue (BTB), and methyl orange (MO) in acidic buffer solutions. The formed complexes were extracted with chloroform and measured at 420, 408, 416, 415, and 422 nm for BCG, BCP, BPB, BTB, and MO, respectively, for GMF; at 410, 415, 416, and 420 nm for BCP, BTB, BPB, and MO, respectively, for MXF; and at 419 and 414 nm for BCG and BTB, respectively, in case of ENF. The analytical parameters and their effects are investigated. Beer's law was obeyed in the ranges 1.0-30, 1.0-20, and 2.0-24  μ g mL(-1) for GMF, MXF, and ENF, respectively. The proposed methods have been applied successfully for the analysis of the studied drugs in pure forms and pharmaceutical formulations. Statistical comparison of the results with the reference methods showed excellent agreement and indicated no significant difference in accuracy and precision.