Development of a "turn off" fluorescent molecularly imprinted nanoparticle-based sensor for selective captopril quantification in synthetic urine and wastewater samples

The combination of silica nanoparticles with fluorescent molecularly imprinted polymers (Si-FMIPs) prepared by a one-pot sol-gel synthesis method to act as chemical sensors for the selective and sensitive determination of captopril is described. Several analytical parameters were optimized, including reagent ratio, solvent, concentration of Si-FMIP solutions, and contact time. Fourier-transform infrared spectroscopy (FT-IR), transmission electron microscopy (TEM), and the ninhydrin assay were used for characterization. The selectivity was evaluated against molecules belonging to other drug classes, such as fluoroquinolones, nonacid nonopioids, benzothiadiazine, alpha amino acids, and nitroimidazoles. Under optimized conditions, the Si-FMIP-based sensor exhibited a working range of 1-15 µM, with a limit of detection (LOD) of 0.7 µM, repeatability of 6.4% (n = 10), and suitable recovery values at three concentration levels (98.5% (1.5 µM), 99.9% (3.5 µM), and 99.2% (7.5 µM)) for wastewater samples. The sensor provided a working range of 0.5-15 µM for synthetic urine samples, with an LOD of 0.4 µM and a repeatability of 7.4% (n = 10) and recovery values of 93.7%, 92.9%, and 98.0% for 1.0 µM, 3.5 µM, and 10 µM, respectively. In conclusion, our single-vessel synthesis approach for Si-FMIPs proved to be highly effective for the selective determination of captopril in wastewater and synthetic urine samples.

Study of captopril pharmacokinetics in rabbit blood with microdialysis based on online generated Au nanoclusters and pepsin–captopril interaction in luminol chemiluminescence

A luminol–HAuCl₄–pepsin (Pep) flow injection-chemiluminescence system was explored to determine captopril (CAP) based on the CL intensity inhibition effect and applied to study CAP pharmacokinetics in rabbits with microdialysis.

Development and validation of a simple and sensitive HPLC-UV method for the determination of captopril in human plasma using a new derivatizing reagent 2-naphthyl propiolate

In this study, a simple, sensitive and reliable HPLC-UV method applying rapid sample preparation technique for the determination of captopril in human plasma was developed and validated. The method is based on pre-column derivatization of captopril and 2-propene-1-thiol (internal standard) with a new reagent 2-naphthyl propiolate. Sample clean-up, derivatization and extraction were carried out in two steps, totally less than 30min. The extracts were chromatographed on a C18 column (5μm, 150mm×4.6mmi.d.). The mobile phase consisted of methanol (75%, v/v) and phosphate buffer (25%, pH=8, 0.01M). UV detection was performed at 290nm. To obtain the best reaction yield, the factors that could influence the derivatization process, including the concentration of derivatization reagent, pH of sample solution and temperature were investigated in detail and optimized using Box-Behnken response surface methodology. Under optimized conditions the average extraction recovery of captopril and internal standard were >86%. The achieved lower limit of quantification (LLOQ) was 3ng/mL; the assay exhibited a linear dynamic range of 3-2000ng/mL with correlation coefficient (r(2)) of ≥0.99. The precision was satisfactory in the whole calibration range with RSD of 5.9-12.4% (accuracy: from 97.5% to 93.6%) and of 6.4-12.8% (accuracy: from 97.3% to 95.2%) for intra- and inter-assay, respectively. The method stability was confirmed in a series of experiments including: freeze-thaw, short- and long-term stability testing. Lastly, the developed method was successfully applied to the bioequivalence study of captopril administrated as a single oral dose (50mg) to 12 healthy male volunteers.