Simultaneous quantification of tiotropium bromide impurities G + H in capsule formulation by LC-MS/MS

Tiotropium Bromide is a long-acting bronchodilator that is used in the treatment of chronic obstructive pulmonary disease (COPD) and asthma bronchodilator or bronchiolitis, which are substances that expand the bronchi and reduce resistance in the respiratory tract and increase airflow to the lungs. For Tiotropium Bromide found in inhaler capsules to treat COPD, determining the relevant impurities G and H, which are not UV active, is crucial. For this purpose, a new and sensitive liquid chromatography triple-quadrupole mass spectrometry (LC-MS/MS) detection with electrospray ionization by using multiple reaction monitoring in the positive mode method was developed and validated. The identity of the compounds was supported by using LC-Q/TOF. All chromatographic studies were performed with a Zorbax Eclipse XDB-C8 (150 mm x 4.6 mm, 5.0 µm) column with a total injection time of 13 min at a flow rate of 0.4 ml/min as a gradient. The limit of detection (LOD) and limit of quantitation (LOQ) in the current study range were determined as 1.0 ppb and 2.5 ppb, respectively. The results of the validation parameters following the ICH Q2(R1) guideline were determined within the acceptance criteria.

A semi-covalent molecularly imprinted electrochemical sensor for rapid and selective detection of tiotropium bromide

Tiotropium bromide (TIO) is a long-acting bronchodilator used in the treatment of chronic obstructive pulmonary disease (COPD) and asthma. Specifically, it is used to prevent patients from worsening breathing difficulties. In this study, a new TIO-imprinted electrochemical sensor was designed to detect TIO in serum and pharmaceutical samples. Methacryloyl-L-histidine-cobalt(II) [MAH-Co(II)] has been used as a metal-chelating monomer for synthesizing selective molecularly imprinted polymer (MIP). MIP film has been developed on glassy carbon electrodes using MAH-Co(II) as the functional monomer, 2-hydroxyethyl methacrylate (HEMA) as the basic monomer, and ethylene glycol dimethacrylate (EGDMA) as the cross-linker in the photopolymerization method. The surface characterization of the developed MAH-Co(II)@MIP/GCE electrochemical sensor was done using scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FTIR). Also, the electrochemical behavior of the sensor was provided by differential pulse voltammetry (DPV), cyclic voltammetry (CV), and electrochemical impedance spectroscopy (EIS) techniques. Under optimized experimental conditions, the linearity range was in the range of 10-100 fM, and the limit of detection (LOD) and limit of quantitation (LOQ) values were calculated as 2.73 fM and 9.75 fM, respectively. The MAH-Co(II)@MIP/GCE sensor was used to precisely determine TIO in capsule and commercial serum samples. The results demonstrated that the MIP could specifically recognize TIO compared to structurally related drugs and could be reliably applied to the direct determination of drugs from real samples.

Liquid chromatography-mass spectrometry method for the quantification of corticosteroids, β2-adrenoreceptor agonists and anticholinergics in human hair

Pharmacological treatments of asthma and chronic obstructive pulmonary disease include medications such as inhaled corticosteroids, long- or short-acting β₂-adrenoreceptor agonists and anticholinergics. There is an unmet need for the monitoring of adherence and drug exposure to those therapies since poor adherence and/or inhalation technique may impact the control of the disease and the pharmacological strategy. Since plasma therapeutic drug monitoring only reflects the body exposure in the last few hours, the measurement of hair drug concentrations may be of great interest to assess the chronic exposure. A liquid chromatography - tandem mass spectrometry method was therefore developed for the quantification of corticosteroids, β₂-adrenoreceptor agonists and anticholinergics in human hair. The method was validated according to the European Medicines Agency and Food and Drug Administration guidelines. Sensitivity, accuracy and precision were excellent, allowing the quantification of drugs in the pg/mg range. The method was shown suitable for the analysis of clinical hair samples, demonstrating that it could be used for hair therapeutic drug monitoring in asthma or chronic obstructive pulmonary disease patients.

An evaluation of the pharmacokinetics of tiotropium following a single-dose inhalation in healthy subjects using an ultra-sensitive bioanalytical method

Objective and significance: The systemic bioavailability of tiotropium following administration via inhalation is known to be very low. A validated ultra-sensitive bioanalytical method with the lowest lower limit of quantitation (LLOQ) was developed and used to evaluate the complete pharmacokinetic profile of tiotropium.Methods: This was a pharmacokinetic study performed in 18 healthy subjects. Each subject was administered a dose of 18 mcg of tiotropium from a dry powder inhaler (DPI). The subjects' plasma tiotropium concentrations were assayed with LLOQ of 0.1 pg/mL.Results: The results showed a mean C_max of 4.98 ± 3.55 pg/mL, and a median (t_max) of 3.6 minutes (range: 1.8-12 minutes). The means for area under the concentration-time curve (AUC) from time zero hours to infinity (AUC_inf) and AUC from time zero hours to the time of the last measurable tiotropium concentration (AUC_t) were 51.11 ± 27.4 pg*h/mL and 37.37 ± 23.38 pg*h/mL, respectively. The mean apparent elimination half-life (t_1/2) was 68.02 ± 24.55 hours. This calculated half-life is longer than what others have reported where a less sensitive LLOQ was used.Conclusion: The lower LLOQ enabled further insight into the pharmacokinetics of tiotropium that was not possible with other analytical methods. With this method, we were able to quantify tiotropium concentrations as early as one minute following drug administration and up to 144 hours after dosing. The application of this method will allow for studies to be designed properly and enable further investigations into the pharmacokinetics of tiotropium.

Pharmacokinetic Bioequivalence of Two Inhaled Tiotropium Bromide Formulations in Healthy Volunteers

Background and Objective

A novel tiotropium bromide monodose capsule dry powder inhaler (DPI) formulation and device have been developed. The formulation was based on a spray-dried matrix that enhances the aerosolizaton properties, allowing a less active tiotropium metered dose (13 µg/capsule) while maintaining the same delivered dose (10 µg/actuation). This study describes the pharmacokinetic bioequivalence to the reference product.

Methods

This randomized, two-stage, crossover, semi-replicate (three-way) study was performed in healthy volunteers. In each study period, subjects received a single dose of two capsules (20 μg delivered dose) of the study medication, separated by a 14-day washout period: tiotropium 10 μg delivered dose (Laboratorios Liconsa, Spain) and Spiriva HandiHaler^® (Boehringer Ingelheim Pharma GmbH & Co KG, Germany). Blood samples were obtained up to 48 h post-dose to evaluate the comparative bioavailability. Tiotropium was measured in plasma by means of dual stage liquid–liquid extraction followed by the two-dimensional ultra-high performance liquid chromatography sensitive sub-pg/mL bioanalytical method. The main pharmacokinetic parameters were maximum plasma concentration (C_max), area under the concentration–time curve (AUC) from time zero hours to the last observed concentration at time t (AUC_t), and AUC from time zero hours to 30 min (AUC_0.5). Bioequivalence was accepted if the 90.20 % confidence interval (CI) for the ratio test/reference of the primary pharmacokinetic parameters lay within the acceptance range of 80–125 %. Safety assessment was a secondary endpoint.

Results

A total of 30 subjects were randomized and bioequivalence was demonstrated for all primary pharmacokinetic parameters: C_max (CI 87.26–106.60 %), AUC_t (CI 101.33–111.64 %), and AUC_0.5 (CI 97.95–113.49 %). Both study treatments were well tolerated (four non-serious adverse events [AEs] were reported in four subjects: one AE before any product administration, two AEs after test product administration; and one AE after reference product administration).

Conclusions

Both products containing tiotropium 10 µg delivered-dose DPI were bioequivalent and showed good tolerability and a similar safety profile.