Trends in Biological Ammonia Production

Food production heavily depends on ammonia-containing fertilizers to improve crop yield and profitability. However, ammonia production is challenged by huge energy demands and the release of ~2% of global CO₂. To mitigate this challenge, many research efforts have been made to develop bioprocessing technologies to make biological ammonia. This review presents three different biological approaches that drive the biochemical mechanisms to convert nitrogen gas, bioresources, or waste to bio-ammonia. The use of advanced technologies-enzyme immobilization and microbial bioengineering-enhanced bio-ammonia production. This review also highlighted some challenges and research gaps that require researchers' attention for bio-ammonia to be industrially pragmatic.

Temperature Effects of MD on Municipal Wastewater Treatment in an Integrated Forward Osmosis and Membrane Distillation Process

An integrated forward osmosis (FO)-membrane distillation (MD) process is promising for the treatment and resource recovery from municipal wastewater. As higher temperature is applied in MD, it could affect the performance of both FO and MD units. This study aimed to investigate the effects of the type of draw solution (DS) and feed solution (FS) such as ammonium solution or municipal wastewater containing ammonium at higher temperatures on membrane treatment performance. It is found that higher FS and DS temperatures resulted in a higher water flux and a higher RSF with either NaCl or glucose as DS due to the increased diffusivity and reduced viscosity of DS. However, the water flux increased by 23–35% at elevated temperatures with glucose as DS, higher than that with NaCl as DS (8–19%), while the reverse solute flux (RSF) increase rate with NaCl as DS was two times higher than that with glucose as DS. In addition, the use of NaCl as DS at higher temperatures such as 50 and FS at 42 °C resulted in increased forward ammonium permeation from the FS to the DS, whereas ammonium was completely rejected with glucose as DS at all operating temperatures. Reducing pH or lowering the temperature of DS could improve ammonium rejection and minimize ammonia escape to the recovered water, but extra cost or reduced MD performance could be led to. Therefore, the results suggest that in an integrated FO-MD process with DS at higher temperatures such as 50 °C, glucose is better than NaCl as DS. Furthermore, a simplified heat balance estimation suggests that internal heat recovery in the FO-MD system is very necessary for treating municipal wastewater treatment. This study sheds light on the selection of DS in an integrated FO-MD process with elevated temperature of both FS and DS for the treatment of wastewater containing ammonium. In addition, this study highlights the necessity of internal heat recovery in the integrated FO-MD system.

Membrane Distillation for Wastewater Treatment: A Mini Review

Water serves as an indispensable part of human life and production. On account of the overexploitation of traditional water sources, the demand for wastewater recycling is expanding rapidly. As a promising water treatment process, membrane distillation (MD) has been utilized in various wastewater treatments, such as desalination brine, textile wastewater, radioactive wastewater, and oily wastewater. This review summarized the investigation work applying MD in wastewater treatment, and the performance was comprehensively introduced. Moreover, the obstructions of industrialization, such as membrane fouling, membrane wetting, and high energy consumption, were discussed with the practical investigation. To cope with these problems, various strategies have been adopted to enhance MD performance, including coupling membrane processes and developing membranes with specific surface characteristics. In addition, the significance of nutrient recovery and waste heat utilization was indicated.

Hybrid forward osmosis/membrane distillation integrated with anaerobic fluidized bed bioreactor for advanced wastewater treatment

Forward osmosis (FO)-membrane distillation (MD) process was integrated with anaerobic fluidized bed bioreactor (AFBR) to advance wastewater treatment. Low removal efficiency of nutrients such as ammonia nitrogen was improved significantly by combining FO-MD process with AFBR. The MD membrane was applied to concentrate the draw solution (DS) which can be diluted by FO filtration. By using 1 M of NaCl as DS, about 80% of ammonia nitrogen was further removed by the FO membrane while the phosphorous was removed almost completely (99%). However, the accumulation of ammonia nitrogen in DS and the reverse salt flux through the FO membrane was unavoidable. Nevertheless, combining MD membrane produced excellent removal efficiency yielding only 4 and 5.6 mg/L of ammonia nitrogen and chemical oxygen demand (COD) in MD permeate, respectively at 15 ℃ of transmembrane temperature. Alternatively, there is the possibility that the FO-MD process can be superior to concentrate resources such as nitrogen and phosphorous present in AFBR. The reverse salt flux from DS into AFBR bulk suspension did not show adverse effects on the performances of bioreactor with respect to COD removal efficiency, conductivity and methane production during operational period. Deposit of the fouling layer on FO membrane was also observed, but the fouling on MD membrane was not severe probably because crystallization rate could be retarded by diluting the DS during FO filtration.

Forward osmosis membrane technology for nutrient removal/recovery from wastewater: Recent advances, proposed designs, and future directions

In recent years, the concept of nutrient removal/recovery has been applied as a sustainable solution to develop and design various modern wastewater treatment technologies for recovering nutrients from waste streams and is one of the high-priority research areas. Forward osmosis (FO) technology has received increasing interests as a potential low-fouling membrane process and a new approach to remove/recover nutrients from wastewater and sludge. The main objective of this review is to summarize the state of FO technology for nutrient removal/recovery from wastewater and sludge in order to identify areas of future improvements. In this study, nutrient removal processes, FO membrane technology, main factors affecting the FO process performance, the source water for nutrient recovery, the previous studies on the FO membrane process for nutrient removal/recovery from wastewater and sludge, membrane fouling, and recent advances in FO membranes for nutrient removal/recovery were briefly and critically reviewed. Then, the proposed possible designs to apply FO process in conventional wastewater treatment plants (WWTPs) were theoretically presented. Finally, based on the gaps identified in the area, challenges ahead, future perspectives, and conclusions were discussed. Further investigations on the properties of FO associated with real wastewater, wastewater pre-treatment, the long-term low fouling operation, membrane cleaning strategies, water flux and the economic feasibility of the FO process are still desirable to apply FO technology for nutrient removal/recovery at full-scale (decentralized or centralized) in the future.

Enhancing the removal efficiency of osmotic membrane bioreactors: A comprehensive review of influencing parameters and hybrid configurations

The amount of research conducted on osmotic membrane bioreactors (OMBRs) has increased over the past decade because of the advantages of these reactors over conventional membrane bioreactors (MBRs). OMBR process is a hybrid process involving a forward osmosis membrane and biologically activated sludge. It is a promising technology to reduce membrane fouling, enhance effluent water quality, and lower energy consumption compared to conventional MBR processes. Eleven years since the OMBR process was first proposed, about 60 papers regarding the OMBR process have been published. In this article, we address recent advances in OMBR technology based on a review of the literature. Typical factors that influence the performance of the OMBR process are discussed to provide a clear understanding of the current state of this technology. We also provide a critical review of OMBR applications in organic matter, nutrient, and micropollutant removal as well as direct recovery of nutrients from wastewater. We propose several hybrid configurations that can enhance the removal efficiency of OMBR systems. Finally, we present potential research directions for future OMBR research.

Approaches and processes for ammonia removal from side-streams of municipal effluent treatment plants

The main objective of this review article is to provide a comprehensive view on various conventional and emerging side-stream ammonia removal treatment options for municipal wastewater treatment plants (WWTPs). Optimization of wastewater treatment facilities from an energy and emissions stand-point necessitates consideration of the impact of the various internal side-streams. Side-streams from anaerobic sludge digesters in particular have the potential to be a significant ammonium load to the mainstream treatment process. However, the literature suggests that managing side-streams through their treatment in the mainstream process is not the most energy efficient approach, nor does it allow for practical recovery of nutrients. Furthermore, as effluent criteria become more stringent in some jurisdictions and sludge hydrolysis pre-treatment for digesters more common, an understanding of treatment options for ammonia in digester supernatant becomes more important. Given these considerations, a variety of side-stream treatment processes described in the literature are reviewed.

A critical review on ammonium recovery from wastewater for sustainable wastewater management

The growing global population's demand for ammonium has triggered an increase in its supply, given that ammonium plays a crucial role in fertilizer production for the purpose of food security. Currently, ammonia used in fertilizer production is put through what is known as the industrial Haber Bosch process, but this approach is substantially expensive and requires much energy. For this reason, looking for effective methods to recover ammonium is important for environmental sustainability. One of the greatest opportunities for ammonium recovery occurs in wastewater treatment plants due to wastewater containing a large quantity of ammonium ions. The comprehensively and critically review studies on ammonium recovery conducted, have the potential to be applied in current wastewater treatment operations. Technologies and their ammonium recovery mechanisms are included in this review. Furthermore the economic feasibility of such processes is analysed. Possible future directions for ammonium recovery from wastewater are suggested.

Hg removal and the effects of coexisting metals in forward osmosis and membrane distillation

In this study, we investigate the rejection of Hg, Cd, and Pb and the effect of coexisting metals on Hg removal through forward osmosis (FO) and membrane distillation (MD) in order to establish a more effective water treatment process. The results of our laboratory experiment indicate that more than 97% of the rejection for each metal is achieved through the FO system, and this rejection is the highest among previous studies using membrane filtrations. Moreover, we examine the matrix effect of the coexisting Cd and Pb on the rejection of Hg in the FO system. Hg²⁺ rejection increases with increase in the concentration of the coexisting metals. Furthermore, we study the effect of the Hg concentration and the water temperature on rejection of Hg²⁺. Indeed, the rejection of Hg²⁺ is achieved above 95% under any condition. However, approximately 1-10 ppb Hg from the feed solution remains in the draw solution due to permeation. Therefore, we use a FO-MD hybrid system. Approximately 100% rejection of Hg²⁺ and a stable water flux are achieved. Thus, the FO-MD hybrid system is considered an important alternative to previous studies using membrane filtration for heavy metals removal.