Clinical trial of an experimental cleaning solution: antibiofilm effect and integrity of a silicone-based denture liner

Strategies for Preventing and Treating Oral Mucosal Infections Associated with Removable Dentures: A Scoping Review

Oral infections occur due to contact between biofilm rich in Candida albicans formed on the inner surface of complete dentures and the mucosa. This study investigated historical advances in the prevention and treatment of oral mucosal infection and identified gaps in the literature. Bibliographic research was conducted, looking at PubMed, Embase, Web of Science, and Scopus, where 935 articles were found. After removing duplicates and excluding articles by reading the title and abstract, 131 articles were selected for full reading and 104 articles were included. Another 38 articles were added from the gray literature. This review followed the PRISMA-ScR guidelines. The historical period described ranges from 1969 to 2023, in which, during the 21st century, in vitro and in vivo studies became more common and, from 2010 to 2023, the number of randomized controlled trials increased. Among the various approaches tested are the incorporation of antimicrobial products into prosthetic materials, the improvement of oral and denture hygiene protocols, the development of synthetic and natural products for the chemical control of microorganisms, and intervention with local or systemic antimicrobial agents. Studies report good results with brushing combined with sodium hypochlorite, and new disinfectant solutions and products incorporated into prosthetic materials are promising.

The Current Antimicrobial and Antibiofilm Activities of Synthetic/Herbal/Biomaterials in Dental Application

Herbal and chemical products are used for oral care and biofilm treatment and also have been reported to be controversial in the massive trials conducted in this regard. The present review is aimed at evaluating the potential of relevant herbal and chemical products and comparing their outcomes to conventional oral care products and summarizing the current state of evidence of the antibiofilm properties of different products by evaluating studies from the past eleven years. Chlorhexidine gluconate (CHX), essential oils (EOs), and acetylpyridinium chloride were, respectively, the most commonly studied agents in the included studies. As confirmed by all systematic reviews, CHX and EO significantly control the plaque formation and gingival indices. Fluoride is another interesting reagent in oral care products that has shown promising results of oral health improvement, but the evidence quality needs to be refined. The synergy between natural plants and chemical products should be targeted in the future to accede to the formation of new, efficient, and healthy anticaries strategies. Moreover, to discover their biofilm-interfering or biofilm-inhibiting activities, effective clinical trials are needed. In this review article, therapeutic applications of herbal/chemical materials in oral biofilm infections are discussed in recent years (2010-2022).

Complete denture hygiene solutions: antibiofilm activity and effects on physical and mechanical properties of acrylic resin

BACKGROUND

Appropriated denture hygiene is a predictive factor for longevity of rehabilitation treatment and maintenance of the oral mucosal health. Although, disinfectant solutions are commonly used as denture cleansers, the impact of these solutions on acrylic resin-based dentures remain unclear.

OBJECTIVE

To evaluate, in vitro, the antibiofilm activity of complete denture hygiene solutions and their effects on physical and mechanical properties of acrylic resin.

METHODOLOGY

For antibiofilm activity measurement acrylic resin specimens were contaminated with Candida albicans, Candida glabrata and Streptococcus mutans. After biofilm growth, the specimens were assigned to the hygiene solutions: Distilled water (Control); 0.2% Sodium hypochlorite (SH); Efferdent Power Clean Crystals (EPC) and 6.25% Ricinus communis (RC). The viability of microorganisms was evaluated by agar plate counts. In parallel, physical, and mechanical properties of the acrylic resin were evaluated after simulating a 5-year period of daily immersion in the previously mentioned solutions. The changes in surface roughness, color, microhardness, flexural strength, impact strength, sorption and solubility were evaluated. Data were compared by ANOVA followed by the Tukey test or Kruskal-Wallis followed by the Dunn test depending on the distribution (α=0.05).

RESULTS

Regarding antibiofilm action, SH eliminated all microorganisms while EPC and RC exhibited moderate action against S. mutans (p=0.001) and C. glabrata (p<0.001), respectively. Relative to effects on the physical and mechanical properties of the acrylic resin, RC led to higher values of color change (p=0.030), hardness (p<0.001), surface roughness (p=0.006) and flexural strength (p<0.001). Moreover, RC induced the highest values of changes in solubility (p<0.001). EPC promoted greater changes in surface morphology, whereas immersion in SH retained the initial appearance of the acrylic resin surface. All hygiene solutions reduced the impact strength (p<0.05).

CONCLUSION

SH presented the most effective antibiofilm activity. In addition, changes on properties were observed after immersion in RC, which were considered within acceptable limits.

In Vitro Evaluation of Resilient Liner after Brushing with Conventional and Experimental Ricinus communis-Based Dentifrices

PURPOSE

To evaluate the effect of experimental (Ricinus communis) and commercial dentifrices used for denture cleaning on abrasiveness (gravimetric method; roughness), hardness, and color stability of a resilient relining material.

MATERIALS AND METHODS

Sixty circular (15 × 3 mm) specimens were distributed into four groups: C (control; brushing with water); CO (brushing with Colgate - for natural teeth); CB (brushing with Corega Brite - for complete dentures); RC (brushing with experimental dentifrice). Brushing was performed in a toothbrushing machine with a soft brush and a dentifrice suspension for 50 minutes, calculated to correspond to 1 year of regular brushing. Variables were measured initially and after the trial period. For the gravimetric method, the difference in mass was considered. The surface roughness was measured by a rugosimeter, and the hardness test was performed by a Shore A durometer. Color changes (ΔE; CIE L*a*b* and NBS systems) were measured by a portable spectrophotometer. Results were analyzed by ANOVA/Tukey's test (α = 0.05).

RESULTS

The largest mass variation (μg; p < 0.0001) occurred in C (-6.21 ± 3.18). Concerning roughness, CB (0.26 ± 0.04) showed the lowest value, followed by RC (0.29 ± 0.08) and CO (0.34 ± 0.24) (p < 0.0001). Group C produced the greatest surface roughness (0.72 ± 0.25). Hardness values decreased after brushing with water (p = 0.014). No significant differences were found among RC (50.31 ± 1.03), CO (49.11 ± 1.31), CB (49.17 ± 1.23), and C (48.02 ± 1.26). Color stability was similar in all groups (p = 0.135; C: 2.3 ± 0.77; CO: 2.6 ± 0.54; CB: 2.2 ± 0.44; RC: 2.9 ± 1.56).

CONCLUSIONS

The use of experimental dentifrice could be indicated, as it showed similar results to the specific dentifrice, keeping the resilient material properties within acceptable values.

Antimicrobial activity of complete denture cleanser solutions based on sodium hypochlorite and Ricinus communis - a randomized clinical study

To preserve oral health and to maintain the prosthetic devices, it is important not only to improve the properties of commonly known hygiene products, but also to investigate new materials with antimicrobial action.