Pharmacokinetic analysis of antibiotic adsorption (vancomycin and teicoplanin) by the Lixelle extracorporeal unit

Vancomycin Adsorption During in vitro Model of Hemoperfusion with HA380 Cartridge

INTRODUCTION

A critical point for using blood purification during sepsis may be the potential interaction with antimicrobial therapy, the mainstay of sepsis treatment. The aim of our study was to investigate the vancomycin removal during hemoperfusion (HP) using HA380 cartridge.

METHODS

This is an experimental study, in which 500 mL of solution was circulated in a closed-circuit (blood flow of 250 mL/min) simulating HP ran using HA380. Vancomycin was added to reach a through concentration or a very high concentration to evaluate the removal ratio (RR) during 120 min of HP. Comparison between blood-crystalloid solution and balanced solution was performed by using Kruskal-Wallis test. The kinetics of vancomycin removal and the adsorption isotherm were evaluated.

RESULTS

We found a complete removal of vancomycin at baseline through concentration of 23.0 ± 7.4 mg/L. Using extremely high concentration (baseline 777.0 ± 62.2 mg/L), RR was 90.1 ± 0.6% at 5 min and 99.2 ± 0.6% at 120 min. No difference in terms of RR was found between blood-crystalloid mixture and balanced solution. The kinetics of the vancomycin reduction followed an exponential decay. Repeated boluses (total amount of 2,000 mg) resulted in cumulative adsorption of 1,919.4 mg with RR of 96.6 ± 1.4%, regardless of the amount injected (100 vs. 500 mg). Vancomycin adsorption onto HA380 followed the Langmuir isotherm model.

CONCLUSIONS

A considerable amount of vancomycin was rapidly removed during in vitro HP with HA380. Clinical studies are needed to determine whether this may lead to underdosing. Drug therapeutic monitoring is highly recommended when using HA380 for blood purification in patients receiving vancomycin.

Biocompatibility of a polymer-coated membrane possessing a hydrophilic blood-contacting layer: Adsorption-related assessment

OBJECTIVE

Currently, the foreign surfaces of extracorporeal circulation devices are coated with an acrylate-based copolymer that creates a hydrophilic blood-contacting layer to enhance biocompatibility. Several reports of acrylate-based copolymer with respect to biocompatibility have been published; however, the adsorption of peptide compounds on acrylate-based copolymer-coated membranes still requires clarity. In this study, we aimed to understand the adsorption of several peptide compounds of various molecular weights, including albumin, lysozyme, and vancomycin, on acrylate-based copolymer-coated membranes using in vitro studies.

METHODS

Six experimental circuits consisting of acrylate-based copolymer-coated tubes and membranes, and six comprising acrylate-based copolymer-coated tubes and non-coated membranes were prepared for comparison. An experimental solution, composed of albumin, lysozyme, vancomycin, and saline, was continuously stirred in a reservoir, recirculated in each experimental circuit, and then filtered. Concentrations of albumin, lysozyme, and vancomycin were measured after 0, 15, 30, 45, 60, 90, and 120 min of recirculation. Similar experiments were performed in all the prepared circuits.

RESULTS

The ratio of measured values at each time point to those at 0 min was not significantly different between acrylate-based copolymer-coated and non-coated membranes for albumin and lysozyme, but differed significantly for vancomycin; the ratios were higher in acrylate-based copolymer-coated than in non-coated membranes.

CONCLUSION

This study suggests that albumin is not adsorbed on either acrylate-based copolymer-coated or non-coated membranes, that lysozyme is not adsorbed on either membrane or is adsorbed at a similar rate on both membranes, and that vancomycin is less adsorbed on acrylate-based copolymer-coated membranes. Thus, acrylate-based copolymer coating could inhibit the adsorption of various peptide compounds.

Comparison of adsorption of selected antibiotics on the filters in continuous renal replacement therapy circuits: in vitro studies

The aim of this study was to assess the adsorption of selected antibiotics: vancomycin, gentamicin, ciprofloxacine and tigecycline in an experimental continuous veno-venous hemofiltration circuit with the use of both polyethyleneimine-treated polyacrylonitrile (PAN) and the polysulfone (PS) filter membranes. The crystalloid fluid dosed with one of antibiotic was pumped from a reservoir through a hemofiltration circuit (with PAN or PS membrane) and back to reservoir. All ultrafiltrate was also returned to the reservoir. During the procedures samples were collected from the post-hemofilter port at 5, 15, 30, 45, 60, 90, and 120 min. To determine spontaneous degradation of the antimicrobials, an additional bag with each study drug was prepared, which was not attached to the hemofiltration circuit. The samples from these bags were used as controls. In the case of vancomycin, gentamycin and tigecycline there was a statistically significant decrease in the drug concentration in the hemofiltration circuit in comparison to the control for PAN membrane (P < 0.05, P < 0.001, P < 0.001, respectively). In the case of ciprofloxacine adsorption was reversible and the drug concentrations increase to achieve the initial level for both membranes. Our studies indicated that a large portion of the administered dose of antibiotics may be adsorbed on a PAN membrane. In the case of gentamicin and tigecycline this amount is sufficiently big (over 90% of the administered dose) to be of clinical importance. In turn, adsorption on PS membranes is clearly lower (up to 10%) and may be clinically unimportant.

Hemodialysis membrane coated with a polymer having a hydrophilic blood-contacting layer can enhance diffusional performance

Purpose

Currently, the foreign surfaces of various extracorporeal circulation devices are coated with a biocompatible polymer coating agent (BPA), which creates a hydrophilic blood-contacting layer to reduce thrombogenicity, while the membranes in hemodialyzers are not. We aimed to clarify other side effects of BPA-coated membranes by examining the diffusion performance in in vitro experiments.

Methods

We used a polyethersulfone membrane (sieving coefficient of albumin is ≤0.01) coated with BPA product, SEC-1™ (Toyobo), in a hemodialyzer. To estimate the diffusion rates of a wide range of molecules, 2 L of saline containing vancomycin, lysozyme, and albumin were recirculated in the circuit configured with a hemodialyzer, and dialyzed continuously using water. The concentrations of sodium, vancomycin, lysozyme, and albumin were measured every 5 minutes for 30 minutes and compared in experiments with BPA-coated (n = 4) and BPA-noncoated (n = 4) membranes.

Results

The removal rates of sodium and vancomycin after 5 minutes of dialysis (n = 24) were significantly higher in BPA-coated than noncoated membranes, while those of lysozyme and albumin were not significantly different. The removal rates of sodium and vancomycin after 30 minutes of dialysis (n = 4) were significantly higher, and those of lysozyme were significantly lower in BPA-coated than noncoated membranes, while those of albumin were not significantly different.

Conclusions

The preliminary study suggests that BPA-coated membranes enhanced the diffusion rate of molecules with low and middle molecular weight without affecting the sieving coefficient of albumin. Thus, BPA coating can enhance the dialysis performance of membranes.