Measurements of simulated periodontal bone defects in inverted digital image and film-based radiograph: an in vitro study

Detection of Simulated Periapical Lesion in Intraoral Digital Radiography with Different Brightness and Contrast

Objective:

To assess the detection of simulated periapical lesions in digital intraoral radiography with different levels of brightness and contrast combinations, and to investigate the observers’ preference of image quality for this diagnostic task.

Methods:

Digital radiographs were acquired prior to periapical lesion simulation and after each one of four defects enlargement. Original images were adjusted in 4 brightness and contrast combinations. Five observers evaluated the images according to the presence of periapical lesion on a 5-point scale. In a second moment, the observers ordinated the images subjectively, according to quality, from the best to the worst to detect the bone defect. The area under the receiver operating characteristic curve was calculated for the diagnostic values and compared by two-way ANOVA. The significance level was set at 5% (P<0.05).

Results:

No differences were found between the diagnostic values of the five combinations of brightness and contrast (P>0.05). The overall results showed low values of area under the Receiver Operating Characteristic (ROC) curve and sensitivity of the periapical radiography in the detection of periapical lesions of sizes from 1 to 3, which rose substantially in size 4. For image quality, combinations with the lowest brightness and highest contrast were preferred by the observers in 58% of the cases.

Conclusion:

Brightness and contrast adjustments do not influence the detection of simulated periapical lesions in digital intraoral radiography. Lower brightness and higher contrast images were preferred for this diagnostic task.

Treatment of periodontal intrabony defects using autologous periodontal ligament stem cells: a randomized clinical trial

Background

Periodontitis, which progressively destroys tooth-supporting structures, is one of the most widespread infectious diseases and the leading cause of tooth loss in adults. Evidence from preclinical trials and small-scale pilot clinical studies indicates that stem cells derived from periodontal ligament tissues are a promising therapy for the regeneration of lost/damaged periodontal tissue. This study assessed the safety and feasibility of using autologous periodontal ligament stem cells (PDLSCs) as an adjuvant to grafting materials in guided tissue regeneration (GTR) to treat periodontal intrabony defects. Our data provide primary clinical evidence for the efficacy of cell transplantation in regenerative dentistry.

Methods

We conducted a single-center, randomized trial that used autologous PDLSCs in combination with bovine-derived bone mineral materials to treat periodontal intrabony defects. Enrolled patients were randomly assigned to either the Cell group (treatment with GTR and PDLSC sheets in combination with Bio-oss^®) or the Control group (treatment with GTR and Bio-oss^® without stem cells). During a 12-month follow-up study, we evaluated the frequency and extent of adverse events. For the assessment of treatment efficacy, the primary outcome was based on the magnitude of alveolar bone regeneration following the surgical procedure.

Results

A total of 30 periodontitis patients aged 18 to 65 years (48 testing teeth with periodontal intrabony defects) who satisfied our inclusion and exclusion criteria were enrolled in the study and randomly assigned to the Cell group or the Control group. A total of 21 teeth were treated in the Control group and 20 teeth were treated in the Cell group. All patients received surgery and a clinical evaluation. No clinical safety problems that could be attributed to the investigational PDLSCs were identified. Each group showed a significant increase in the alveolar bone height (decrease in the bone-defect depth) over time (p < 0.001). However, no statistically significant differences were detected between the Cell group and the Control group (p > 0.05).

Conclusions

This study demonstrates that using autologous PDLSCs to treat periodontal intrabony defects is safe and does not produce significant adverse effects. The efficacy of cell-based periodontal therapy requires further validation by multicenter, randomized controlled studies with an increased sample size.

Trial Registration

NCT01357785 Date registered: 18 May 2011.

Electronic supplementary material

The online version of this article (doi:10.1186/s13287-016-0288-1) contains supplementary material, which is available to authorized users.

Diagnostic Accuracy of Inverted and Unprocessed Digitized Periapical Radiographs for Detection of Peri-Implant Defects

OBJECTIVES

This study aimed to compare the diagnostic accuracy of inverted and unprocessed digitized periapical radiographs for detection of peri-implant defects.

MATERIALS AND METHODS

A total of 30 osteotomy sites were prepared in three groups of control, study group 1 with 0.425 mm defects and study group 2 with 0.725 mm defects using the SIC and Astra Tech drill systems with 4.25mm and 4.85mm diameters. Small and large defects were randomly created in the coronal 8mm of 20 implant sites; implants (3.4mm diameter, 14.5mm length) were then placed. Thirty periapical (PA) radiographs were obtained using Digora imaging system (Soredex Corporation, Helsinki, Finland), size 2 photostimulable storage phosphor (PSP) plate sensors (40.0mm×30.0mm) and Scanora software. Unprocessed images were inverted using Scanora software by applying image inversion and a total of 60 images were obtained and randomly evaluated by four oral and maxillofacial radiologists. Data were analyzed using the t-test.

RESULTS

Significant differences were observed in absolute and complete sensitivity and specificity of the two imaging modalities for detection of small and large defects (P<0.05). Unprocessed digital images had a higher mean in terms of absolute sensitivity for detection of small defects, complete sensitivity for detection of large peri-implant defects and definite rule out of defects compared with inverted images.

CONCLUSION

Unprocessed digital images have a higher diagnostic value for detection of small and large peri-implant defects and also for definite rule out of defects compared with inverted images.

Effect of digital noise reduction on the accuracy of endodontic file length determination

PURPOSE

The aim of the present study was to evaluate the measurement accuracy of endodontic file length on periapical digital radiography after application of noise reduction digital enhancement.

MATERIALS AND METHODS

Thirty-five human single-rooted permanent teeth with canals measuring 20-24 mm in length were selected. ISO #08 endodontic files were placed in the root canals of the teeth. The file lengths were measured with a digital caliper as the standard value. Standard periapical digital images were obtained using the Digora digital radiographic system and a dental X-ray unit. In order to produce the enhanced images, the noise reduction option was applied. Two blinded radiologists measured the file lengths on the original and enhanced images. The measurements were compared by repeated measures ANOVA and the Bonferroni test (α=0.05).

RESULTS

Both the original and enhanced digital images provided significantly longer measurements compared with the standard value (P<0.05). There were no significant differences between the measurement accuracy of the original and enhanced images (P>0.05).

CONCLUSION

Noise reduction digital enhancement did not influence the measurement accuracy of the length of the thin endodontic files on the digital periapical radiographs despite the fact that noise reduction could result in the elimination of fine details of the images.

Comparison of changes in dental and bone radiographic densities in the presence of different soft-tissue simulators using pixel intensity and digital subtraction analyses

OBJECTIVES

To evaluate the influence of soft-tissue simulation materials on dental and bone tissue radiographic densities using pixel intensity (PI) and digital subtraction radiography (DSR) analyses.

METHODS

15 dry human mandibles were divided into halves. Each half was radiographed using a charge-coupled device sensor without a soft-tissue simulation material (Wm) and with 5 types of materials: acrylic (Ac), wax (Wx), water (Wt), wood (Wd) and frozen bovine tissue (Bt). Three thicknesses were tested for each material: 10 mm, 15 mm and 20 mm. The material was positioned in front of the mandible and the sensor parallel to the molar region. The radiation beam was perpendicular to the sensor at 30 cm focal spot-to-object distance. The digital images of the bone and dental tissue were captured for PI analyses. The subtracted images were marked with 14 landmark magnifications, and 2 areas of analyses were defined, forming the regions of interest. Shapiro-Wilk and Kruskal-Wallis tests followed by Dunn's post-test were used (p < 0.05).

RESULTS

DSR showed that both the material type and the thickness tested influenced the gain of density in bone tissue (p < 0.05). PI analyses of the bone region did not show these differences, except for the lower density observed in the image without soft-tissue simulation material. In the dental region, both DSR and PI showed that soft-tissue simulators did not influence the density in these regions.

CONCLUSIONS

This study showed that the materials evaluated and their thicknesses significantly influenced the density-level gain in alveolar bone. In dental tissues, there was no density-level gain with any soft-tissue material tested.